Search:

Type: Posts; User: busterweaver

Search: Search took 0.00 seconds.

  1. Replies
    21
    Views
    2,583

    That makes sense.

    That makes sense.
  2. Replies
    32
    Views
    1,720

    Has anyone noticed yellow jackets seem to aim for...

    Has anyone noticed yellow jackets seem to aim for you face and ears? The worst is roof top units that have been vacant or broke for a while. I started up 14 package units in a strip mall we had...
  3. Replies
    5
    Views
    792

    I have seen this happen because of the magnetic...

    I have seen this happen because of the magnetic strips in the door seals. If opened back up soon, the seals are still at room temp making them more pliable and creating a better seal making it...
  4. Replies
    6
    Views
    453

    What do you mean by "auxillary" is on, this is...

    What do you mean by "auxillary" is on, this is usually some type of electric heat back-up for a heat pump. Is it a heat pump or just a/c. If there is electric back up heat, it could be on,...
  5. Replies
    6
    Views
    609

    I looked into a new timer for a washer about five...

    I looked into a new timer for a washer about five years ago, found a better, slighty scratched washer at the discount appliance store for less money. Granted this was nothing fancy, may make sense...
  6. Replies
    21
    Views
    2,583

    I saw at the Dome Hepot and wowes stores they now...

    I saw at the Dome Hepot and wowes stores they now have tiny oxy-mapp gas torch sets, just wondering if anybody else has seen this and comments. Didn't really notice what they were marketed towards.
  7. Replies
    21
    Views
    2,608

    me too!! i am paying $$ to return r22, i have...

    me too!! i am paying $$ to return r22, i have been seeing the ads in the tech magazines about $$ for your reclaimed r22, but nowhere that i know of in central ohio is even close to breaking even.
  8. ok. thanks.

    ok. thanks.
  9. Replies
    21
    Views
    2,583

    brazing with mapp gas is good for about 3\8, 1\2...

    brazing with mapp gas is good for about 3\8, 1\2 inch max copper, if its close to any larger masses of metal, you gotta get out the oxy acetyl. it is convienent for repairing hairline condensor...
  10. Thread: Filter

    by busterweaver
    Replies
    7
    Views
    422

    just remember the more expensive the filter, in...

    just remember the more expensive the filter, in general, will need to be replaced more often. i've came across many folks who assume a better filter should last longer. those "allergy" filters sold...
  11. Replies
    4
    Views
    345

    i agree, complete carb cleaning is good, also...

    i agree, complete carb cleaning is good, also make sure the float in the bottom of the carb is operating properly, if its not keeping the correct fuel height in the carb bowl it will flood the motor...
  12. Replies
    20
    Views
    1,546

    brown cap wire with white stripe is usually the...

    brown cap wire with white stripe is usually the same as nuetral in 115 or line one in any higher voltages. but its a simple check with a meter. i imagine they started making four wire motors so it...
  13. we use nu calgon rx-11 flush when using an...

    we use nu calgon rx-11 flush when using an existing line set from r22 to 410 upgrade. doing alot of that lately, but always try to replace everthing within reason on upgrade. i think the pro-flush...
  14. new member - hope i'm doing this right.

    replaced contactor points on four 200 amp 3p on and old dunham-bush chiller, size of dimes, about 3/16 thick brazed to the brass leg. they cost around $ for just the points. are they some kind of...
Results 1 to 14 of 15
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event