Search:

Type: Posts; User: scooters45

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    16
    Views
    995

    Yes I would put a Hard Start on and for my 2...

    Yes I would put a Hard Start on and for my 2 cents a delay on break timer as well.
  2. Replies
    19
    Views
    1,466

    I have a cheap Master Cool single stage 6 CFM. ...

    I have a cheap Master Cool single stage 6 CFM. I could not believe how fast it pulls down. I've seen it pull down a 20 ton package unit to 600 microns in less than 2 hours with 1/4 inch hoses and...
  3. Replies
    39
    Views
    3,561

    If you have an Android phone you can down load...

    If you have an Android phone you can down load the Handyman Calculator for free. It does 50+ calcs wire sizing is one. It's available in the Play Store
  4. Replies
    39
    Views
    3,561

    The wire size is correct. I've run in too Trane...

    The wire size is correct. I've run in too Trane and Carrier condensers that have 2 different wiring diagrams on the condenser fan motor and would cause the condenser to have high head pressure and...
  5. Replies
    15
    Views
    2,284

    I use the Yellow Jacket set up with 3/8 hoses and...

    I use the Yellow Jacket set up with 3/8 hoses and core removers. I do put Teflon tape on the threads. It works just fine. I pulled a 60 ton tandem compressor circuit down to 450 microns in about 6...
  6. Replies
    41
    Views
    2,910

    Not to Hi-jack this thread but has anyone tried...

    Not to Hi-jack this thread but has anyone tried or used the NRP NTR21 (CPS TR21) machines? I have an old NRP recovery machine and it's held up well.

    The NRP says it's recovery rates are better...
  7. Replies
    14
    Views
    1,112

    I have a CPS and a JB. Both work really well...

    I have a CPS and a JB. Both work really well if you clean them each time you use them and keep good seals in them. Hope this helps.
  8. Thread: WV Codes

    by scooters45
    Replies
    1
    Views
    513

    WV Codes

    Hi Guy's I live and work in S. Florida. Residential is all fuzzboard and flex.

    What are you using for residential in WV?

    I'm asking because a family member is thinking about changing form a...
  9. Thread: truck mpg.

    by scooters45
    Replies
    130
    Views
    12,314

    I had an 07 2500 with the 4.8 and it did about...

    I had an 07 2500 with the 4.8 and it did about 11. Not much extra power when you get it loaded up
  10. Replies
    141
    Views
    17,912

    Plumbers and Pipefitters and Air Conditioning...

    Plumbers and Pipefitters and Air Conditioning Mechanics Local 630 West Palm Beach Fl.
  11. Replies
    22
    Views
    1,534

    When I was in my apprenticeship an instructor...

    When I was in my apprenticeship an instructor from the National Copper Institute advised us too use brazing flux on any reheated joint, any copper washed joint. He also said that you allways need to...
  12. Replies
    22
    Views
    1,534

    Are you brazing on new copper? The reason I ask...

    Are you brazing on new copper? The reason I ask is when copper is reheated it burns out the posphorus and thats when you need brazing paste to help any silver solder stick'
  13. Replies
    22
    Views
    1,534

    I use a Turbo Torch all the time and it seam to...

    I use a Turbo Torch all the time and it seam to me like the off brands of solder don't melt as wellas the name brands.
  14. Replies
    5
    Views
    2,209

    A # 14 tip will braze or soft solder those sizes...

    A # 14 tip will braze or soft solder those sizes fine. A #32 tp will do up to 4 inch if you have a big enough tank.
  15. Replies
    28
    Views
    2,930

    I have a older De Tek and I dont trust it. Ive...

    I have a older De Tek and I dont trust it. Ive got a Yellow Jacket and it works a lot better.
  16. Replies
    36
    Views
    5,424

    Where did you find them online? Thanks

    Where did you find them online?

    Thanks
  17. Replies
    23
    Views
    9,193

    I was thinking about a cap cleaner to. Can I ask...

    I was thinking about a cap cleaner to. Can I ask are you working on cap tube systems or are you talking about the distributor tube on a TXV system?
  18. Thread: Scotch

    by scooters45
    Replies
    16
    Views
    1,567

    I've never thought about that but I have had...

    I've never thought about that but I have had Miller lite and cottage cheese for breakfast.
  19. Replies
    14
    Views
    2,142

    Thats So. Florida for ya!! and It's really bad...

    Thats So. Florida for ya!! and It's really bad around there.
  20. Replies
    68
    Views
    10,136

    Sorry I missed your post. I bought my gauges...

    Sorry I missed your post.

    I bought my gauges at www.northwaysmachinery.com. Good price and service.
    I bought a R410 set with no hoses ans the standard gauges not oil filled.

    They also sell...
  21. Replies
    21
    Views
    1,250

    :worthless:

    :worthless:
  22. Replies
    12
    Views
    800

    :couchhide:We need Twilli's words of wisdom!!

    :couchhide:We need Twilli's words of wisdom!!
  23. Replies
    41
    Views
    2,619

    I read the new Testo 550 is .5 seconds so thats a...

    I read the new Testo 550 is .5 seconds so thats a lot better than mine. I realize I'm comparing apple to oranges but I've been happy with the Digimon's. They hang and fall off the bulk head like the...
  24. Thread: Scotch

    by scooters45
    Replies
    16
    Views
    1,567

    Scotch

    Hey Guys, Even though I'm Irish every now and then I like to have a Scotch or 2 or maybe even several.

    I'm a Dimple Pinch man. I take it Neat or chase it with distiled water.

    If there are...
  25. Replies
    41
    Views
    2,619

    I have a set of Digimon's and for what I paid for...

    I have a set of Digimon's and for what I paid for them I'm happy. I Think a Tech should wait until he/she has all thier other hand tools and some field experence before buying any set of digitails.
    ...
  26. Replies
    15
    Views
    1,136

    After looking at a lot a manufactures sites and...

    After looking at a lot a manufactures sites and looking at the supply house I think I would avoid any manifold that has a diaphram seal. From what I've read (here and other sights) they tend to leak....
  27. Replies
    74
    Views
    3,175

    :couchhide:Term limits on elected officals or...

    :couchhide:Term limits on elected officals or only a start. There has to be a limit on Civil Service also. Remember J. Edgar Hoover?
    The lobbyist has to go also.

    Then the average person might...
  28. Replies
    20
    Views
    2,150

    Could you explain?

    Could you explain?
  29. Replies
    1
    Views
    451

    Obama prayer

    A friend of mine sent this to me and I thought I would pass it along.
  30. Replies
    20
    Views
    2,150

    When I was in school I was allways taught that an...

    When I was in school I was allways taught that an orfice or cap tube would leave trace amounts of bubbles in the liquid due to thier design and that these would show in the sight glass as a bubble...
  31. Replies
    19
    Views
    1,042

    While I don't like the tone of these letters they...

    While I don't like the tone of these letters they really don't bother me much as long as there is no threat implied or otherwise of violence.

    What really bothers me is when the President (any)...
  32. Replies
    20
    Views
    2,150

    A sight glass is used for much more than just to...

    A sight glass is used for much more than just to verify a soilid stream of liquid at the expansion device. While they are much more common place in commericial HVAC and refridgeration does not mean...
  33. Replies
    5
    Views
    1,013

    Save these pics and use them with new customers...

    Save these pics and use them with new customers to sell the benifits of a properly installed UV light system
  34. Replies
    20
    Views
    2,150

    When he changes the Evap he'll know. So if you...

    When he changes the Evap he'll know. So if you want a sight glass ask your service tech.
  35. Thread: I Pad

    by scooters45
    Replies
    51
    Views
    4,122

    Raped Ape might be a northern lingo. Down South...

    Raped Ape might be a northern lingo. Down South we say "runs like a scalded dog"
  36. Replies
    20
    Views
    2,150

    I allways install a sight glass in any system i...

    I allways install a sight glass in any system i install/changeout. You must have a TXV in the system for the sight glass to not show bubbles in the glass.
  37. Replies
    109
    Views
    3,564

    AMEN!!

    AMEN!!
  38. Replies
    109
    Views
    3,564

    Boy thats the truth. Our only real friend in the...

    Boy thats the truth. Our only real friend in the Middle East.
  39. Replies
    109
    Views
    3,564

    We defended western Europe twice in hot wars and...

    We defended western Europe twice in hot wars and a cold war and we even helped rebuild most of western Europe.

    Not since France helped us in our Revolution has anyone had to help us stave off...
  40. Replies
    109
    Views
    3,564

    Yes. The United States is a center-right country....

    Yes. The United States is a center-right country. We have to be. How else could we have enough people of work and pay the bills to not only support all those who are subsidized by our government. Not...
  41. Replies
    109
    Views
    3,564

    We are in Africa. Remember W's AID's program. If...

    We are in Africa. Remember W's AID's program. If thats not humility I don't know what is.
  42. Replies
    109
    Views
    3,564

    :ditto:

    :ditto:
  43. Replies
    109
    Views
    3,564

    We waited untill we where attacked. Then Germany...

    We waited untill we where attacked. Then Germany declared war on us. Britian and France had a treaty with Poland and had to declare war on Germany because of it but, they waited untill they had...
  44. Replies
    109
    Views
    3,564

    What about the Spainish American War, WW1,...

    What about the Spainish American War, WW1, Vietnam, Korea, Panama Kuwait ,Iraq, and Afganistan.
    The US has stuck her nose in many places many times but never for land or loot, but to promote...
  45. Replies
    109
    Views
    3,564

    Your right we may be ignorant of how the rest of...

    Your right we may be ignorant of how the rest of the wolrd lives but

    Ask England, France,Holland ,Belgum,Denmark,Norway.Italy,Monaco,Luxumberg,Austria,Germany.Japan,Australia,The Pacific Islands...
  46. Replies
    109
    Views
    3,564

    Canada was given indendence from England. We...

    Canada was given indendence from England. We fought for ours not once but twice. We either won it bought it or stole it fare and square.
    America has many faults and we are by no means perfect but:...
  47. Replies
    44
    Views
    4,525

    Not trying to change the subject but; I was in...

    Not trying to change the subject but;

    I was in my local Johnstone's and say a new Testo Digitail Manifold that retailed for about $280.00.

    Does anyone know anything about them?

    Thanks Scooter
  48. Replies
    47
    Views
    5,985

    Technically a compressor does reject heat. ...

    Technically a compressor does reject heat.
    Follow me and I'll try to make sense.
    The motor windings are cooled by the returning suction vapor. Since the windings are hotter than the suction vapor...
  49. Replies
    4
    Views
    536

    Our compamy has Windows mobile. It runs thier...

    Our compamy has Windows mobile. It runs thier dispatching software. While windows has improved I still like Palm better.
  50. Replies
    35
    Views
    3,557

    For everyone who is into smoking and Q check out...

    For everyone who is into smoking and Q check out this link there is a wealth of info.

    wwwthesmokering.com
Results 1 to 50 of 249
Page 1 of 5 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event