Type: Posts; User: tomt
need e-mail address. will not let me attach file
Need info for Trane TruSense Monitor, calibration specs, filters.
Had power outage then unit was restarted. Oil differential reading -34psig ,oil sump pressure 25.0 psig, oil discharge pressure -32psig. Replaced oil discharge tranducer. Reading correctly started...
Can you send teardown manual, firstname.lastname@example.org
That is the bulletin i was looking for
Thank you guys for the help.
Anyone have this service bulletin. Unit will not start diagnostics code
Low suction pressure. Cannot clear alarm.
Try this site
Thanks for setting me straight on this one, do not want to have any problems.
I do not do residential work so could use some help here.Have a upflow oil fired furnace, ductwork comes out the top elbows down to floor runs under house.Want to replace with a oil fired...
Have not been to site yet, salesman told me what controls where there. I did get a copy of the bid they have the York ISN.
Any info about this control
I have another sight with ISN on a York Screw...
Our company just tookan account with the Pathfinder controls.
Any info you have would be appreciated.
Anyone have any info on this control system.
Tell them to upgrade ther meter to 2PSI . Then get Maxitrol 350 series regulators. 2psi to 7" w.c.
You definitely do not have enough gas to operate all four units.
Seen that you have info on York ConnX/ISn panel
I would appreciate any literature you have
Email is in my profile
Removed 14 inch oil sump to the new 16 inch, install all parts that where sent. Startup unit, pump ran for about 15 minutes and turned oil in sight glass black. Pulled oil pump[ and it is burnt out....
Send me your e-mail
Will take any wiring diagrams, my e-mail is on my profile
Need wiring diagram and parts list for this unit.
Trane Model# RAUCD104KB0320DF010
Should be able to pump all refrigerant into condenser barrel.Then valve it off from the system, thermister above discharge valve at the condenser.
LOOKING FOR FOR FORM 160.47-M2.
NEED TO MAKE ADJUSTMENT TO SLIDE VALVE.
I met another tech from my company at the site, it is his account. The AFD is a Rockwell we did find some literature for this drive. Company going to buy interface control to access drive. What...
Anyone have info on the AFD that comes with this unit.
I am going to this job, what I was told is the code they get is this. AFD SHORTED.
Thanks for the manual and the info, will be getting on the job next week. Will let you know what I find
Anyone have the install manual for the new YT shaft seal.
Did not receive any instruction with the retro kit.