Search:

Type: Posts; User: tinknocker service tech

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. well explained thank you been

    well explained thank you been
  2. not up much on this set up but will assume there...

    not up much on this set up but will assume there is a solenoid valve that controls where the refrigerant goes heat ex changer or condenser and maybe be hanging up or fluttering on start up. It also...
  3. looks like the gas flex flare connection was...

    looks like the gas flex flare connection was doped also and is against code there should never be pipe dope on that connection.
    unless code change the flue should be b vent all the way and maybe a...
  4. I am not nor will become a fan of zoning but I...

    I am not nor will become a fan of zoning but I also understand you cost issues. Talk to your trane or lennox dealers about the trane zoneing or harmony zoning. It may cost a little bit more but they...
  5. get another opinion on the hx from a different...

    get another opinion on the hx from a different company and the decide
    I vote replace the furnace
  6. under your conditions and the fact you cant stop...

    under your conditions and the fact you cant stop your problem with out moving you neighbors you still have options
    a merv 16filteron you furnace and a Air Knight purifier installed on your system...
  7. the heat exchanger really needs to be pressure...

    the heat exchanger really needs to be pressure tested by a qualified tech the test that was done isn't conclusive. The limit may need to be replae or the secondary hx is dirty and not letting enough...
  8. Replies
    25
    Views
    1,618

    call the company you been using and ask them to...

    call the company you been using and ask them to check for dampers that may be close or hidden and ask for static test and to find the problem with the air flo to the second floo. It should not be...
  9. IMHO replace the ductwork with proper size and...

    IMHO replace the ductwork with proper size and your noise should be gone. The ducts in moble homes is very restrictive
  10. Replies
    16
    Views
    1,177

    very good units and dependable but the were ruff...

    very good units and dependable but the were ruff on the brain and you had to have the book and follow it to the letter. Was sorry to see it leave the market and was way ahead of its time
  11. Replies
    22
    Views
    718

    take your time and remember don't over think the...

    take your time and remember don't over think the questions most you will know the answers
  12. haven't installed one in a few years now but I...

    haven't installed one in a few years now but I believe the main trunk is 9in round breaking down to 7in depending on the duct design all the take offs are 2.5 in tubes and can fit through walls and...
  13. unico system is also an option three in runs and...

    unico system is also an option three in runs and main duct is smaller and works well in the older homes like yours
  14. sounds like your heating and colling bills will...

    sounds like your heating and colling bills will be through the roof and you still will be struggling to keep up. I would think a complete load calc be done and two systems be install with merv 14 to...
  15. oil seal blown out motor should be replaced....

    oil seal blown out motor should be replaced. Don't understand why they didn't replace it under warranty. Trane considers that as a failed part and have not seen then kick it back yet. Air quality in...
  16. Replies
    25
    Views
    1,618

    with 2000 cfm potential I see no reason you cant...

    with 2000 cfm potential I see no reason you cant heat or cool any part of the house. the duct going to the second floor may not have been connected at some point. From the duct sizes you gave your...
  17. the amana is a good unit and quite but I would...

    the amana is a good unit and quite but I would think it be in your best interest to get a load calc done and get the proper size for your needs. I also think a wifi stat since you are not there much...
  18. you will be far better off with the perfect fit...

    you will be far better off with the perfect fit better filtration and far less restriction on air flo
  19. IN most cases yes high limit will trip but I have...

    IN most cases yes high limit will trip but I have seen in many cases not enough heat is pulled from the HX and the heat would transfer through the shield and trip the roleout. If the limit is being...
  20. I am not a fan of reducing gas pressure to over...

    I am not a fan of reducing gas pressure to over come a problem in heat raise. It is designed with certain perremitors and they should be kept. Ajustment made with an analyzer to get the best eff is...
  21. uv lights are great for stopping organic growth...

    uv lights are great for stopping organic growth in the air handler only. They should be installed after the filter and not before. The uv will eat the filter making it uselessmost come with a shield...
  22. have the next guy check air flo and get a new...

    have the next guy check air flo and get a new filter also. You say it worked last year no issues and now problem and they all tunnel vision on the exhaust witch may be border line but most likely...
  23. Replies
    4
    Views
    898

    1 year expect some where between 10 n 15 per hour...

    1 year expect some where between 10 n 15 per hour if there is work
    things are slow here and may take time for it to pick up
  24. 20 gallons a day and it isnt water logged you...

    20 gallons a day and it isnt water logged you have a leak some where look for it before you damage the boiler
  25. just saw the vidio. Looks like the typical nc...

    just saw the vidio. Looks like the typical nc system. Looks like you may have a damper zone system from the control on the furnace.
    you would IMHO do better and save more by ripping it all out and...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event