Search:

Type: Posts; User: emtim

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Thread: Ddc retofit

    by emtim
    Replies
    1
    Views
    285

    Do companies typically leave a schematic . I have...

    Do companies typically leave a schematic . I have seen rooftops converted with schematics , p
  2. Thread: Ddc retofit

    by emtim
    Replies
    1
    Views
    285

    Ddc retofit

    Hello I have some building with what I call a hybrid system for controlled carrier service tool 5 with a combination of pneumatics . We have a installer in our area who installed this ....
  3. Thread: Fan blade stuck

    by emtim
    Replies
    32
    Views
    2,057

    I will usually order new blade, cap .i will check...

    I will usually order new blade, cap .i will check availability ,have had some odd motor blade combinations ,especially with York and trane .i had a old trane from 1960 .the blade was a airplane...
  4. Replies
    13
    Views
    1,211

    Voyager

    Did you get it running. Been a while in think the draft inducer motor starts first and then the igniter lights .Proves flame and gas valve opens . Keep us posted .
  5. Replies
    13
    Views
    1,211

    Voyager

    Have you put in test mode and if so what happens .
  6. Thread: System pilot

    by emtim
    Replies
    5
    Views
    576

    The rtu was at idle .

    The rtu was at idle .
  7. Thread: System pilot

    by emtim
    Replies
    5
    Views
    576

    System pilot

    Went on a call today with a system pilot and had no heat .checked zones and when I attached the zone to the system pilot on the bottom of screen it said disabled for every zone. I would normally see...
  8. Replies
    8
    Views
    1,014

    Did you try grainger, not a big fan of dayton . I...

    Did you try grainger, not a big fan of dayton . I usually go to a few motor shops ,what is wrong with the original motor maybe you can get it rebuilt.
  9. Thread: Lennox NAS

    by emtim
    Replies
    143
    Views
    38,016

    Glad you made it out .I was out of springfield...

    Glad you made it out .I was out of springfield ,ma .When we were aquired from tradewinds there were 4 techs and a manager. Two were laid off ,two left and manager left in one year. I remember ...
  10. Thread: national grid

    by emtim
    Replies
    0
    Views
    301

    national grid

    Has anybody worked for them or no anybody who has . I appiled and taken test ,interview .possible career change . Service rep B ,Thanks Rick i
  11. Replies
    59
    Views
    6,439

    serta i comfort prodigy ,three models to choose...

    serta i comfort prodigy ,three models to choose from ,last bed I purchased had a matress with with foam ,felt nice at store hated it,my wife would say meet you in the middle .The serta i confort has...
  12. Thread: bristol dx

    by emtim
    Replies
    4
    Views
    840

    thanks this does have a direct vent kit .Working...

    thanks this does have a direct vent kit .Working good .
  13. Thread: bristol dx

    by emtim
    Replies
    4
    Views
    840

    All fixed ,Found b vent on termination fitting...

    All fixed ,Found b vent on termination fitting not sealed properly ,allowing exhaust and fresh air to mix ,starving out fire ,it is running and the sit control is beeping ,warranty covering this...
  14. Replies
    31
    Views
    2,641

    I think these are the old york sunshine series...

    I think these are the old york sunshine series ,the panels all interlock on each other ,is the condenser fan grill on top and its along rectangular grill. Is this electric heat ,had some of these at...
  15. Replies
    4
    Views
    853

    I too was having issues ,does this have a...

    I too was having issues ,does this have a ignition control ,I have a fireplace control made by sit ,the tech I was talking to states it has a timing mechanism (runs 6 hours ) .This is a built in...
  16. Replies
    22
    Views
    2,224

    what kind of issue you having with unit , I had...

    what kind of issue you having with unit , I had one giving me problems it was heat exchanger ,new exchanger replaces the one inshot burner design.
  17. Thread: bristol dx

    by emtim
    Replies
    4
    Views
    840

    venting

    I am using simpson direct vent , I have checked literature on this and do you seal the fittings ,these are a twist lock fitting . I have read that these stoves are sealed units and if the pipes leak...
  18. Thread: bristol dx

    by emtim
    Replies
    4
    Views
    840

    bristol dx

    Hello just bought a bristol dx by hearthstone , install went good ,upon lighting did not work ,The stove now does run longer after i checked log placement ,checked pressure before valve . The stove...
  19. Replies
    6
    Views
    1,072

    fan limit control

    Just installed a thermo pride oil furnace ,what settings do you set up for the on and off on the fan control ,installed late last night ,going back to finish later in week ,heavy furnace, Thanks
  20. Thread: Winter Gear

    by emtim
    Replies
    24
    Views
    2,188

    winter gear

    Depends on what i am doing ,layers ,if outside all day and its colder 20 degrees and colder with wind i will switch to insulated coveralls . I have a insulted hat with full face mask ,insulated snow...
  21. Replies
    2
    Views
    659

    Has anyone ever worked on one of these . There is...

    Has anyone ever worked on one of these . There is a switch on controller auto and manuall. I have never seen one .Thanks
  22. Thread: posts

    by emtim
    Replies
    2
    Views
    575

    posts

    I posted some posts how do i move them into the tech to tech commercial.Thanks Rick
  23. Replies
    8
    Views
    1,208

    I have seen theses installs , you could have...

    I have seen theses installs , you could have electrical come out of roof .I had one we rerouted and had a pitch pocket for electrical and unit still leaked covered up rtu and shut off it was the roof...
  24. Thread: pump

    by emtim
    Replies
    6
    Views
    850

    pump

    I have to replace bearing assemblies on gthis pump ,two on site , have not done any in a while .1 do you guys reuse impeller or should I order new ones . 2 These pumps do have isolation valves ,is...
  25. Replies
    2
    Views
    659

    diaphragm controller

    Hello ran across this yesterday ,no heat call after researching found out on a call for heat this energizes coil in this controller and releases gas into pilot ,then the main gas valve opens .Does...
  26. Replies
    15
    Views
    1,463

    Is a old york sunline series ,had them at a mall.

    Is a old york sunline series ,had them at a mall.
  27. lennox

    If you do go back ,it is pain check the ductwork. I have had duct work with all ductwork connected and lots of slopppy mistakes from disgrunted employees (the takeoffs were installed without the...
  28. lennox

    Had a brand new york rtu wired wrong from factory give me that code ,are these a retrofit ,had one unit company installed units , 3 out of four the phases were incorrect ,fans and compressors running...
  29. Replies
    34
    Views
    3,649

    alpine mechanical

    Is this alpine mechanical from pennsylvania. When the company I worked for got bought out by lennox nas .I heard they were looking at aquiring this company. That was a couple of years ago .If you...
  30. Replies
    2
    Views
    1,055

    bryant

    Which wiring harness is burning ,and are you refering to the hi limit swiches that are failing. What did bryant rep tell you ,have you checked temperature rise acoss unit ,found one job filters...
  31. Replies
    5
    Views
    616

    This is a prefabbed panel .Each compressor has a...

    This is a prefabbed panel .Each compressor has a shut off switch and a test button and reset for the overloads ,schematic is hard to read . That makes sense to cycle compressors .Next visit I am...
  32. Replies
    5
    Views
    616

    pneumatic compressor

    Have air station one tank ,two compressors ,I was told the compressors should be staged whenthey come on. On startup both compressors come on . I did not see any controls to lead and lag compressors....
  33. Replies
    43
    Views
    8,531

    That does not surprise me with lennox nas ,any...

    That does not surprise me with lennox nas ,any benner techs left. Buying good companies and running them into the ground .
  34. Thread: Christmas bonus

    by emtim
    Replies
    20
    Views
    4,980

    supposed to be employer

    supposed to be employer
  35. Thread: Christmas bonus

    by emtim
    Replies
    20
    Views
    4,980

    Christmas bonus

    Does your employee give you a bonus, used to get a ham ,turkey or cash . I did recieve a bonus last couple of years ,yes it was taxed . This year started with new company ,I do not expect anything...
  36. Thread: Trane voyager

    by emtim
    Replies
    27
    Views
    2,686

    I agree with time builder ,had one unit with heat...

    I agree with time builder ,had one unit with heat exchanger was good all over ,except bottom left front ,pull the top off and back panel , is this rtu natural gas or propane .
  37. Thread: trane voyager

    by emtim
    Replies
    2
    Views
    526

    trane voyager

    have bad economizer motor ,last time on smaller unit took hood off to replace motor, .On this unit looks like I have to remove the outer shell of the hood to get to the motor .Is there a easier way...
  38. Replies
    29
    Views
    1,988

    Just replaced one today ,there also is a...

    Just replaced one today ,there also is a addditional relay and wiring that the trane dealer will charge to prevent motor from shorting again.
  39. Thread: glycol

    by emtim
    Replies
    6
    Views
    1,080

    I have peerless horizontal discharge pump , have...

    I have peerless horizontal discharge pump , have to go through rep to get parts .
  40. Replies
    6
    Views
    1,531

    A friend of mine works for them he likes it ,lots...

    A friend of mine works for them he likes it ,lots of driving ,let us know ,
  41. Thread: glycol

    by emtim
    Replies
    6
    Views
    1,080

    glycol

    Hey guys thanks for info ,going to work on this this week , I will let you guys know how I made out . Started on rebuild on old pump ,is there a trick to get old seal apart , brass sleeve would not...
  42. Thread: glycol

    by emtim
    Replies
    6
    Views
    1,080

    glycol

    Have building with glycol loop ,just inherited ,not sure how much glycol loop hold (ethylene glycol ) .I live in upstate new york ,not sure what I should mix glycol to ,I have it at -6 degrees now...
  43. Replies
    7
    Views
    1,152

    heat exchanger

    Never heard of repairing heat exchanger,replace also how old is unit ,
  44. Thread: r7795

    by emtim
    Replies
    2
    Views
    1,807

    thanks .I also had one w136a I think .

    thanks .I also had one w136a I think .
  45. Replies
    28
    Views
    1,847

    cell service

    sprint has airwave ,have to have a dsl ,complain of the bad service they may ship you one,worked at my house.The beeper worked the best .
  46. Thread: r7795

    by emtim
    Replies
    2
    Views
    1,807

    r7795

    on this control has plug to check the flame signal .Is there a way of checking with standard electric meter .Honeywell has a meter with adapter ,looked at wiring looks like i can put meter in series...
  47. Replies
    15
    Views
    1,639

    Yes

    My son says mw3 will sell more but bf3 will have better gamplay, graphics and bigger maps. The Cod series has had the smae graphics for 5 years now yes it is a good choice.
  48. Replies
    11
    Views
    766

    job

    I would also find out what the max pay you can earn at this new company and also ask people if they like working there. Benefits if your single ,ask about family plan . It could drive insane debating...
  49. Replies
    11
    Views
    2,672

    york

    Installed replacement 30 ton ,I think it was predator ,as soon as checked phases and rotation the board was flashing ,hi limit 2nd stage . I was told bad board ,finally got factory on phone ,they...
  50. Replies
    56
    Views
    4,289

    leak

    Are the lines run overhead or in trenches in floor ,if there is access point see if detector picks up refrigerant ,what kind of detector , .Do not enter where lines are in floor if there is access...
Results 1 to 50 of 115
Page 1 of 3 1 2 3
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event