Search:

Now that my friend is quite an impressive document.
Thanks you.

L99H0313M
Is that serial # correct. I could not find that #.

Lift is the difference between the evap. ref. pres. and the cond. ref. pres.

I would have to guess by the size that the machine is fairly old (don't see to many small machines being commisioned now days) Need the first three digits of the serial #.

But if it is a current...

Good point.
I hope that it was a misprint, because the one that I did with those instructions I called it done at 9.

check this out.

Check your email.

60872

Or try this you said that you are in the 8th grade??????????/
Maybe the first was a little to simple for you.

60862

Check this out.
If you put your email in your profile bigger things can be sent.

Carrier Mech,
I got my motor out yerterday and I took some good pics. of the discharge volute flange surface that where the oring seats.
Purposely I took the pics. very big aprox. 2 meg. so that...

Glad to hear that the job went well. It is bad that the kit was misleading with the extra parts.

I will have my next motor out by Wed. or Thurs. of this week and it is an 97 and I am sure that it...

You should be able to push the motor up to the flange by hand if it is floating on the guide bolts. The fit is not that tight it should push up right against the flange. Expecially with that small of...

There is not a grove on the motor you just slide the oring over the end of the motor and there is a lip on the discharge volute that the oring goes up into.

That is to say that there is a lip that...

From what I see this machine does in fact have an oring for the motor to discharge volute.
It is # 29 in the lit. that came in the motor change out kit. There should be 2 different orings in the kit...

I am not sure what you are asking.
My example was with the pump off.
Still the pump only has to have the head to overcome the resistance in the loop like piping losses, coil drops, chiller drop....

For every 2.307 ft of head in the water pipe equals 1 psi.
The pump is mearly overcoming the resistance in the loop.
If you turn off the pump you will get your standing static pressure.
It could...

There are companies that you can get to rent their equiptment and operator.
The one we use is from up north somewhere, we have used a couple of times on absorbers.

I have also seen it used on...

It does not come standard with either Comm4 or Comm5.

It is and option and you have to select if you want the Comm module to be 4 or 5 when you order.

You can bind and program either one in.
...

That's right..... of course you can pay an arm and leg from Trane and it will have a cool little logo on it. :)

I would suggest that you get the Literature on Techview and CH530.

They will tell you step by step how to do what you want to do.

It is pretty involved if you are starting from scratch.(way to...

I hope that what I replied was not confusing.

The KIT07957 is the splice kit that contains two connectors, tube of glue, several end caps and about 12 inches of cable.

That is what I buy in...

kit07957
that is the # for the kit you need to splice in a llid.

Wtih the $ amounts that you described.

My suggestion would be to take it to the motor shop and let them remove the impeller.

My guess is that you need to update the software.

There was a version of software that would loose configuration and both machine start and hours along with purge pumpout time on power failure

I assume you are talking about this in relation to Commissioning of a controls job.

If so maybe you would get more response out of the Controls Forum.