Search:

Type: Posts; User: JNorton

Search: Search took 0.01 seconds.

  1. Thread: NAE BAcnetIP

    by JNorton
    Replies
    4
    Views
    605

    No, you just have to setup the bacnet IP in the...

    No, you just have to setup the bacnet IP in the jace and make sure it is enabled off of the correct Ethernet adapter. Should work once everything is enabled in the jace.
  2. Replies
    3
    Views
    1,196

    Cooling Compressor Pressure Sensors

    I have an odd problem any thoughts would be appreciated.

    I have a set of screw compressors that have suction and discharge ports on the lines with a PV09AV Veris (0-10V) pressure sensor.

    The...
  3. Thread: NAE BAcnetIP

    by JNorton
    Replies
    4
    Views
    605

    NAE is backnet IP compliant. Just do a discovery...

    NAE is backnet IP compliant. Just do a discovery with backnet IP on the Jace.
  4. Replies
    7
    Views
    2,322

    I did set the binary output 1 to BAS control. ...

    I did set the binary output 1 to BAS control. Also set the out of service points for the unoccupied setpoints to false. I don't have any trouble writing to the temperature setpoint and the occupied...
  5. Replies
    7
    Views
    2,322

    No the unit maintains the arbitrary unoccupied...

    No the unit maintains the arbitrary unoccupied setpoints, which don't reflect any available setting.
  6. Replies
    7
    Views
    2,322

    Trane ReliaTel BACnet Controller

    I'm setting up a few RTU's with the ReliaTel controllers on board. I was testing the Unoccupied mode and can't seem to get the controller to reflect the unoccupied setpoints when the unit is in...
  7. Replies
    6
    Views
    965

    What are the identifying features of the BTL...

    What are the identifying features of the BTL listed protocessor board? If it is dip switches then we don't have that. We are currently using the legacy board.
  8. Replies
    6
    Views
    965

    Thanks for the thoughts, I will be using the...

    Thanks for the thoughts, I will be using the contact info on Monday.

    I don't necessarily think it is the Jace but I don't have much control over the protocessor board. I know how to pull the...
  9. Replies
    6
    Views
    965

    Protocessor BacNet Comm With Jace

    I'm having an issue with a AAM branded Jace communicating with a protocessor board in a boiler.

    The boiler that contains the protocessor board has a switch on the front that shuts down all...
Results 1 to 9 of 9
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event