Search Results - HVAC-Talk: Heating, Air & Refrigeration Discussion

Search:

Type: Posts; User: JES

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Thread: XL20i noise

    by JES
    Replies
    14
    Views
    329

    The fan looks like it's not spinning fast enough.

    The fan looks like it's not spinning fast enough.
  2. I would give it some time to dry. Maybe you'll...

    I would give it some time to dry. Maybe you'll get lucky.
  3. Best way to test it would be to turn it on in the...

    Best way to test it would be to turn it on in the morning. Don't wait till it's 81* inside.
  4. If your return is making noise, it's to small....

    If your return is making noise, it's to small. Have a pro take a look at it.
  5. Replies
    5
    Views
    313

    Did he make sure the air handler was level?

    Did he make sure the air handler was level?
  6. Thread: Heat Pump in CT

    by JES
    Replies
    5
    Views
    215

    32k btu in CT? What is the sq ft?

    32k btu in CT? What is the sq ft?
  7. Replies
    9
    Views
    341

    I would not open a system to replace the...

    I would not open a system to replace the insulation.
  8. Replies
    7
    Views
    242

    As long as the RA is the right size you should...

    As long as the RA is the right size you should not have a noise problem. Doesn't matter if you use 1 large or 2 smaller ones.
  9. Replies
    4
    Views
    336

    In heat mode you need to take temp inside close...

    In heat mode you need to take temp inside close to the coil for subcooling.
  10. Replies
    50
    Views
    3,446

    Hour and halft to find the tranformer........

    Hour and halft to find the tranformer........
  11. Have a pro come out and find the leak or you will...

    Have a pro come out and find the leak or you will be topping it off every summer. Sounds like it's going into defrost mode.
  12. Replies
    21
    Views
    1,221

    Don't discount the insulation idea. You have...

    Don't discount the insulation idea. You have 4500 less btu's now. The added insulation might be what you need.
  13. If the system has been working good for a 1.5...

    If the system has been working good for a 1.5 years with no one opening the the system....no contaminants. Call some one else.
  14. Call a differant company.

    Call a differant company.
  15. It could be the indoor txv is not bypassing...

    It could be the indoor txv is not bypassing corectly ...blockage?
  16. If the outdoor txv is not opening you should see...

    If the outdoor txv is not opening you should see low suction. What is the suction pressure? make sure you are on true suction.
  17. Thread: blower question

    by JES
    Replies
    7
    Views
    427

    Sounds like the stat is bad .

    Sounds like the stat is bad .
  18. Replies
    20
    Views
    714

    It is possible the return is sucking the basement...

    It is possible the return is sucking the basement smell in. Have someone come out and seal the return duct and find out where the smell is coming from. Don't worry about the pan-joisted return.
  19. Replies
    3
    Views
    408

    Have the tech check the defrost thermostat.

    Have the tech check the defrost thermostat.
  20. Replies
    3
    Views
    425

    Make sure you have a clean filter and then call a...

    Make sure you have a clean filter and then call a Pro.
  21. Replies
    14
    Views
    793

    I agree with kls-ccc. Good idea!

    I agree with kls-ccc. Good idea!
  22. Replies
    14
    Views
    2,269

    Hey Ralph, think we should go outside and check...

    Hey Ralph, think we should go outside and check before we drill these holes? .......Naw, it's hot out there.
  23. Thread: Hey Rundawg

    by JES
    Replies
    4
    Views
    409

    Hi Joe, I did find some info on the CB19 but the...

    Hi Joe, I did find some info on the CB19 but the only diagram I found was the stat wiring.

    Rundawg, I'm only getting a 100F supply when it's in emer mode.
  24. Thread: Hey Rundawg

    by JES
    Replies
    4
    Views
    409

    Hey Rundawg

    I am working on Lennox CB 19-41. The wiring diagram is on the blower housing and driving me crazy trying to read it. It's a real pain in the neck. I can't find a diagram anywhere online. Any help?
  25. Replies
    16
    Views
    2,795

    Was this "offset coupling" leaking?

    Was this "offset coupling" leaking?
Results 1 to 25 of 53
Page 1 of 3 1 2 3
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event