Type: Posts; User: targetman
Just Goggle Yaskawa z1000 quick setup.
Don't assume that your driving record will be an issue.
I think there was another recent thread about this subject. Our company had two motors fail during construction of a building. Our Aaon rep sent there Tech out and changed the motors under warranty.
What is the model number?
I have used it on 410 installs and TXV replacements. It will be fine.
New Tech maybe? I can remember making that same call for the same problem.
You have a wire rubbing somewhere. Check all low voltage wiring in the outdoor unit. No need to call Carrier.
You could email me your contact info. I may be able to help.
The church I was at today has four G12's. As long as they make heat, they won't replace them. Pilot is orifice is plugged and flame sensor and ignitor are falling apart.
Anyone got a source for a pilot burner.
You have to set regulators with flow. That's what the do is regulate flow. When the flow stops , they lock up and cease to flow.
Thanks. Lots of good info.
What is up with Square D? I cannot get any info from the Schneider electric website. I have 5 combination motor starters that are screwed up. They were supplied wired as common control but have a...
There is always a replacement compressor. It might be a different brand compressor. Some piping changes may be required. But it can be done.
Your customer should hire someone else.
Leaking in the back.
I have one that's leaking.
Anyone here familiar with them?
Steam mains carry steam not water. No need to pump glycol into them. Just drain the boiler and wet returns or condensate pumps.
Take the soldering class.
I'm going to the Copeland COSS class next week. Would like to know how much hands on training and do they have more than one instructor?
Check your installed vent compared to the installation manual.
Anyone familiar with these? I'm not. I have eight units with these gas burners all different sizes. Started the first one on Friday. Apparently these burners are very sensitive to the supplied...