does any one know how toget rid of the wistling sound that comes from cast iron burners
Type: Posts; User: cape fear
does any one know how toget rid of the wistling sound that comes from cast iron burners
does any one know if any manufactures in the nc area offer
classes on mini split sytems?
Why dont you try a hayes book theres other publishers they have step by step instructions for ac electrical etc. i learned how to change my breaks with one they tell you tools you will need and every...
has any one tried using the new supstitute for r22 made by hot shot yet? i saw it in the supply house the other day.
does anyone know where i might be able to sell a used leak detector? it works the way it is supposed to but i have run out of patience with it. it is a amprobe ultra sonic detector every thing is...
Thats what i thought we replaced the 1/4 in with 3/8in had to change the piston about 5 times before we found a good balance thanks for confirming.
can someone help me with this Lennox no# data plate unreadable
AHH254 ip/ru 8
gf06 69 110385ah28113v this is off the compressor
Hs61-211-1ff this was on inside panel
talked to lennox...
your family will be in our toughts and prayers, My cousin did the same thing a few years ago only he succeeded emidiaty. May God bless you and give you strength. My wife works in the brain ingury...
i did away with any kind of flare fittings, i hooked up to system like normally would. Pull a vacuum for about 20 minutes then close off valves disconnect high side attach it to micron gauge then...
believe its 12000 the screen says atm
i have a Titting the female end hooked up to the pump then top capped off the left one is male so i flared two female flare nuts one to that end the other to the gauge.
will flare fittings hold a vacuum, hoses are brand new got everything capped off except pump and micron gauge.
i just bought a supco vg64 miron gauge. i hooked it up to my vacuum pump as i ran it the bars where showing it was pulling down , after about a half hour still showing above 12000 microns i changed...
i will
thankyou to everyone who responded i bought the amprobe acd 14 that freezone recomended. It has quickly become my favorite meter thanks again.
i would like to thank william antley for your help with the leak detector. i tried bringing home a old coil from the junk pile with little success,I don't think it had a leak.
i gave up tried to...
can any one tell me the advantages of being a site supporter?
I know this was discussed a little while back ,but i have an amprobe uld-300 from johnstone for a little over 200. i talked to a friend of mine there i might try to give back at a loss and get a d...
may want to look into a dipped coil trane usually offers them but you have had someone try to clean it three times
i graduated from ccac now am living in nc i started out at 8hr within two years ent to 10hr now with six years experience im making 15hr best advice stay away from comanies that do plumbing also you...
im looking for the most compact clamp on amp meter that does everything micofareds peak hold the works any ideas or brand names would be appreciated
i bought a amprobe one it is one of the worst investments of my carear would strongly vote against getting one