Search:

Type: Posts; User: klyons20

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Carrier / Bryant Draft Inducer Motor 318984753, 318984-753

    I have 10 year old furnace flame floats a litte going into heat exchanger. cycles out on flame senor..
    When i remove vent pipe flame flow normal.. Iam thinking new draft motor.
  2. Replies
    40
    Views
    7,934

    There are suggested books that you can read for...

    There are suggested books that you can read for the test... You need to know code to pass.
  3. Replies
    5
    Views
    2,164

    Super-Freeze 22a Refrigerant

    Super-Freeze 22a Refrigerant - R22 Freon Drop-in Replacement - 30 lb Equivalent

    Anyone using the Super-Freeze 22a Refrigerant ?

    What you take on it?

    Any cons?


    regards,
  4. Replies
    6
    Views
    766

    Pull fan motors and clean secondary heat coil...

    Pull fan motors and clean secondary heat coil just above the fan! Use a coil cleaner.
    This could be your problem
  5. Replies
    1
    Views
    524

    whirlpool gd5shaxlq02 ice maker

    whirlpool gd5shaxlq02 ice make stop working..

    the arms on the ice maker seem to be normally position.

    There is a wiring harness that connects the ice make black white green brown. How do i...
  6. fan limit switch vs a fan control board

    A fan is controlled by two ways a temperature switch or a fan board
    The fan board will run regardless of the temp.

    fan limit switch
    The temperature switch will open and close the switch based...
  7. I work on a loading dock we use around 150k btu...

    I work on a loading dock we use around 150k btu to 250k btu per door.

    They run 24 hours. There no match agaist and open door.
  8. This is normal behavior is you are using a...

    This is normal behavior is you are using a combination fan limit controll.

    If you want a unit to catch up fast then put a bigger unit in or more units.
  9. Replies
    15
    Views
    690

    u need some one in your area.. Call and get...

    u need some one in your area.. Call and get prices to replace..
  10. Replies
    40
    Views
    7,934

    Heating and Cooling Essentials

    Heating and Cooling Essentials (Hardcover)
    by Jerry Killinger
    Jerry Killinger (Author)
    › Visit Amazon's Jerry Killinger Page
    Find all the books, read about the author, and more.
    See search...
  11. Replies
    40
    Views
    7,934

    Buy book heating and cooling essectians by...

    Buy book heating and cooling essectians by ladoona read heating section
  12. Replies
    16
    Views
    18,920

    use less energy

    [QUOTE=rChris;1511988]Not looking like Rheem makes a VS furney, just a 2 stage that has a ECM motor.

    So if that's the case, could someone esplain what's so great about these motors. Looked at the...
  13. dirty coil

    A dirty filter can not cause a coil to leak. These new puron system are under a lot more preasure than r-22. So if everything is not done perfectly in the installation you will get leak down the...
  14. Replies
    21
    Views
    3,027

    make sure control voltage is constant

    Make sure control voltage is present to determine if contactor is not working.
    I feel like something in the circut is opening up.
  15. Replies
    4
    Views
    475

    Quiet Running Ac Unit

    Who makes the quiet running Ac Condener R-22.
    I had a magazine that show all the unit and the decimal rating.
    Iam replacing a condenser and the costumer insist on a quiet running system.
    I will...
  16. This calls are a pain in the behind. You have to...

    This calls are a pain in the behind. You have to pump down the system put an 160 psi of nitrogen and do a buble test. Close the valves and come back the next day to see what side is leaking the a...
  17. Replies
    16
    Views
    1,186

    mechanical code book

    Normally the BW vent change to B vent once it enters the attic. So you would use the same code that applies to b vent. Slop of the rood decides how tall the vent pipe should be. As long as this is...
  18. Replies
    14
    Views
    805

    ok

    set t stat to lowest setting . you only want to keep it above freezing.


    regards,
    Kelvin
  19. hello

    Piece where are you from?
  20. Replies
    2
    Views
    777

    Are they any beginners that need a little on the...

    Are they any beginners that need a little on the Job Training? You will provide the free help. I will provide you the experience.

    Regards,
    Kelvin Lyons
  21. Replies
    11
    Views
    904

    dont do it

    Dont waste you time .. These units will not fit most applications..

    regards,
    K
  22. Replies
    2
    Views
    519

    Why do the good man sound like a cannon ball when...

    Why do the good man sound like a cannon ball when starting.
    I need a quiet furnace for a job installation in the attic above the bed room. I am on a tight buget.

    Goodman product or comfort air...
  23. Replies
    16
    Views
    1,370

    Call a tech

    We give advice! I can not tell you how to fix that problem, plus it could be so many things until if you dont have a volt test you can not fix it.

    regards,
    K
  24. Replies
    3
    Views
    446

    ED25TEXHW01 REFRIGERATOR WHIRLPOOL Model of...

    ED25TEXHW01 REFRIGERATOR WHIRLPOOL

    Model of my whirlpool
    THERMOSTAT ASSEMBLY 2198202

    I have whirlpool that I am having problems with.
    The coil freezes up over time and cause the unit to run...
  25. Replies
    26
    Views
    2,500

    hi fire furnace

    It depends on how the dual stage is setup . Robo.
    The little jumper on the board and weather you have a two stage t-stat.

    Now explain to me how the furnace will know to go into hi fi mode after...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4