Search:

LMAO Too Right, Unless he lucks out and unit is still under warranty....other then that you are so right..

Very easy job, Hardest part is removing the auger, may need to use a puller tho.....

Hope this helps

Spoken like a true ass !!! Not to mention very unoriginal

You don't know me as well as I don't know you, so you can keep your little comments to yourself.

You haven't a clue except to argue...

I'm the one who said that data tags are usually incorrect and I'm the one who said SH and SC and a good thermometer with a PT chart is all ya need to charge a cap system, My company spends more time...

Hydra - what are you talking about not to have sweat back to the compressor....I think ya need to rethink things abit...on that statement

There are ways around that if you know what you are doing and as I stated before that should only be talked about in the pro section, and also keep in mind we are also talking about the OPs cap...

Not against checking amps on a compressor, you just dont charge to them. I check amps if I have an electrical problem with the compressor or seting up a CPR valve other then that its not necessary...

Neil- The only way I'm checking amp draw on a compressor is if there are no taps and shell is blazing hot, so that I can see if the compressor is doing any work ( under a load ) or not other than...

All things considered it gets pretty aggravating some of replies the OP has been given, cap tube system is charged by SH , I do use SC as a diagnostic tool on charging cap systems and using...

[QUOTE=K_Neil;15459571]The old ones sometimes need some magic. Get it cleaned up and watch pressures, amps, temps. Amps are a good indication if everything is clean charge to 1 amp lower than RLA and...

Coldtech is still around. The company that built that box was most likely Gemtech they wet out of business a few years ago.

Personally I never go by data tags as most are incorrect, SH and SC....

They already make UVs for ice machines
You're a I'll late on that one

Think nobody answered you cause you didn't give enough info....
I'd check the auger and check production and after that check charge,

That's the kind of info we need..

Hope this helps...

http://www.brooks.com/support/technical-support/documentation/cryochillers-cryocoolers/~/media/Files/Support/Documentation/Vacuum/WaterpumpChillers/Manual%20Cryocoolers/82512300.pdf


I believe...

404 does have a phase out date can't remember when it is , but when I get to my office I will post it....

You haven't worked on your fair share yet or you'd think differently, can't stand True boxes , but they keep me in business

Ya just can't beat the H-10 PM :.02: too...

As everyone else has told ya call another company....

That unit shipped 10/11/2002 all parts still available...

It's truly sad how many shady contractors there are out there. :.02:

run a magnet along it afew times

If this is a heat pump I'd check to see if the check valve is stuck.... and have him clean the coils evap and condenser.... that low of superheat with those pressures problem most likely at the air...

what are the SH and the SC numbers

Need more info.... model numbers

Very simple Store is under negative pressure... to confirm with all doors closed open one door a couple of inches while you are inside the building at the door that is being opened and if you feel...

To answer your question...

Pump system down and allow condenser fan to run until exhausted air is the same as ambient, then break out your PT chart and check your high side pressure with unit...

We need more information... ie what are your pressures and control settings and subcooling providing there is no receiver..... if compressor is close to evap I'd be more concerned with SH at the...