Search:

Type: Posts; User: paulyd18

Search: Search took 0.01 seconds.

  1. Replies
    14
    Views
    1,276

    I have seen at least 15 of this valves in s...

    I have seen at least 15 of this valves in s series stop filling to the probe. Checked water pressure, inlet screen, and diaphragm. Never find a problem. You replace the valve and it starts filling...
  2. Replies
    14
    Views
    1,163

    I forgot to mention these were all remote...

    I forgot to mention these were all remote machines. No recovery, no brazing, no vacuum. Saves your costumer a lot of labor.
  3. Replies
    14
    Views
    1,163

    I have done this many times. The easiest way to...

    I have done this many times. The easiest way to do it is to use unistrut across rafters above the unit. Slip unistrut under the machine and use threaded rod to suspend the machine until the new...
  4. Replies
    7
    Views
    801

    Follet told me that a digital meter may not react...

    Follet told me that a digital meter may not react fast enough to catch the over amp issue. Inspect the barrel for scratches, run a clean cycle, and check bearings.
  5. Replies
    5
    Views
    1,766

    With no mechanical make up you can't balance the...

    With no mechanical make up you can't balance the store and you will end up exhausting air from your 10 ton. So you are fighting a loosing battle. Usually the make up will be ducted as part of the...
  6. Replies
    7
    Views
    1,458

    Thanks for the help guys. Hopefully one of you...

    Thanks for the help guys. Hopefully one of you suggestions leads to the problem.
  7. Replies
    7
    Views
    1,458

    Lynn, there are no pressure gauges installed on...

    Lynn, there are no pressure gauges installed on this system. How do you go about measuring the pump pressure.
  8. Replies
    7
    Views
    1,458

    Cooling Tower Water Flow

    I have an Amcot ST-15 that does not have enough water pressure to spin the sprinkler assy. The system has a small w/i cooler, w/i freezer, a/c, and a 600# Mani. I have checked the screen in the...
  9. How do techs like that keep a job!

    How do techs like that keep a job!
  10. Replies
    10
    Views
    2,430

    I don't know what area you're in pdrake. Ken's...

    I don't know what area you're in pdrake. Ken's just started a contract in St. Louis and are subcontracting the account. I know a tech that applied and they only offered 20/hr. This guy has 18 yrs...
  11. Replies
    21
    Views
    3,267

    I actually wrote that wrong. While I was...

    I actually wrote that wrong. While I was weighing a charge in, liquid was dripping from the evac port. The manual said to close the valve hand tight, so maybe I should start working out because my...
  12. Replies
    21
    Views
    3,267

    Testo 557 Review

    This is my first set of digitals so I can't compare to other brands. I've only used them three times so far. When comparing pressures and temps to my manifold and cooper, the sensors where...
  13. Replies
    5
    Views
    3,620

    Just ordered from TrueTech. Should be here by...

    Just ordered from TrueTech. Should be here by Thur. I can post initial impressions of performance and quality next week.
  14. Replies
    21
    Views
    1,207

    Commercial service in the Midwest is steady. ...

    Commercial service in the Midwest is steady. Boss tried to hire another tech in August. We all had a meeting and agreed to work more on straight time to get the calls covered. An extra tech in the...
  15. Replies
    71
    Views
    15,615

    Installed my first Honeywell steam humidifier...

    Installed my first Honeywell steam humidifier today. It has a 1:1 ratio and fan runs through control. Any time humidity is needed control will start the fan. Came with water line, drain line and...
  16. Replies
    71
    Views
    15,615

    I agree with hvacmd the aprilaire is a better...

    I agree with hvacmd the aprilaire is a better unit. I also use the hot water line, but install an inline scale inhibitor.
Results 1 to 16 of 17
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event