Search:

Type: Posts; User: golan37

Page 1 of 7 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    12
    Views
    5,039

    That shorter limit could be the cause of your...

    That shorter limit could be the cause of your furnace catching fire at a later date!

    Golan
  2. Replies
    3
    Views
    413

    I have seen nothing that would indicate that...

    I have seen nothing that would indicate that either style of HX would outperforn the other for heat transfer. Tubular heat exchanger will often times allow for a smaller cabinet size though.
    ...
  3. Replies
    4
    Views
    752

    Any good HVAC technician should be able to seel...

    Any good HVAC technician should be able to seel those gaps up for you with sheetmetal in order for a standard size filter to fit

    Golan
  4. Replies
    40
    Views
    3,582

    If I try to use mine near anything shiny all I...

    If I try to use mine near anything shiny all I get in the center of the monitor is glare! There is light, just a wavelength that the human eye doesn't see and is subject to all the problems with...
  5. Replies
    40
    Views
    3,582

    You're having better luck with your "inspector"...

    You're having better luck with your "inspector" cameras than I am. Fixed focus unit can't see anything up close, manual focus unit, nothing but glare upclose. Have to check any questionable areas...
  6. Replies
    45
    Views
    3,737

    I'll add my penny's worth. Never trust to just...

    I'll add my penny's worth. Never trust to just one meter. Stuff happens in the field! A good quality clamp meter and a good quality multimeter are minimal. One of these has to be capable of...
  7. Replies
    23
    Views
    2,555

    In your system the infinity control determines...

    In your system the infinity control determines the required airflow and allows very little adjustment. The heatpump alone will be very slow to recover from setbacks. To alleviate this I would raise...
  8. Thread: New Coil Gun

    by golan37
    Replies
    9
    Views
    1,515

    Been using one for about a year, they will go...

    Been using one for about a year, they will go through some chemical though. Take the foamers off and toss them, the artifically generated foam doesn't penetrate well but the chemical/water steam goes...
  9. Thread: Wits end!

    by golan37
    Replies
    20
    Views
    1,825

    Zoning is better than nothing! 2 systems is the...

    Zoning is better than nothing! 2 systems is the better route!
  10. Replies
    12
    Views
    916

    As GAMA says on their website, if it's gotten...

    As GAMA says on their website, if it's gotten wet, replace it!
  11. Replies
    12
    Views
    916

    As GAMA says on their website, if it's gotten...

    As GAMA says on their website, if it's gotten wet, replace it!
  12. Replies
    10
    Views
    3,381

    I have a problem with using the ADP coil with a...

    I have a problem with using the ADP coil with a Trane or AS. As a rule ADP's coils don't have as much capacity as Trane/AS condensers and significantly shorten then lifespan of their compressors. I...
  13. My thoughts exactly Beenthere. Possible that...

    My thoughts exactly Beenthere.

    Possible that the termidistat is configured or wired incorrectly. Maybe a couple of wires that got shoted together somehow.

    Golan
  14. Replies
    6
    Views
    1,085

    Don't worry it'll quit again! Do yourself a favor...

    Don't worry it'll quit again! Do yourself a favor and call someone to come out and give it a proper cleaning and check the system over completely.

    golan
  15. Replies
    7
    Views
    1,144

    As long as it is just frost don't worry about it....

    As long as it is just frost don't worry about it. If your old Lennox HP didn't frost in the same manor it was probably overcharged. Since it was forming frost at 55 degrees it is probably slightly...
  16. Replies
    16
    Views
    1,703

    The physical size of 13 SEER equipment will be...

    The physical size of 13 SEER equipment will be decreasing very soon due to some new coil and motor technology. some manufacturers are preparing to rollout some 13 SEER equipment that is physically...
  17. Replies
    9
    Views
    1,327

    1.) something has happened that the heat pump is...

    1.) something has happened that the heat pump is no longer providing heat.

    2.) If the heat pump is not heating then set the stat to emergency until it can be looked at by a qualified service...
  18. Replies
    10
    Views
    2,319

    The U/V light will actually break down "most"...

    The U/V light will actually break down "most" organic substances if they are exposed long enough. It will also destroy some of the cheaper made evaporator drain pans in the same manor.

    Golan
  19. Replies
    10
    Views
    2,319

    If installed where they can shine on the...

    If installed where they can shine on the evaporator coil they are great at keeping it clean but do little else, unless the design incorporates some method of slowing the airflow, and concentrating...
  20. Replies
    14
    Views
    1,223

    Agree totally with Toolpusher but I would always...

    Agree totally with Toolpusher but I would always change out my own lineset as cheap insurance against contaminants getting in the new system from the old.

    golan
  21. Having played this game for a number of years....

    Having played this game for a number of years. You most likely will not notice the difference between the 2 in utility savings. There are many variables involved in the installation of a furnace that...
  22. Replies
    43
    Views
    3,397

    I think I've replaced 2 of them since Trane...

    I think I've replaced 2 of them since Trane started started using silicon nitride
  23. Replies
    54
    Views
    3,072

    Oh how wrong you are sir. Having participated in...

    Oh how wrong you are sir. Having participated in online forums since the days of the old BBS systems before there was widespread internet access, this is an extension of the sysops/moderators home....
  24. Replies
    4
    Views
    1,810

    The 80% furnaces are definitely noisier inside...

    The 80% furnaces are definitely noisier inside the home due to their open combution chambers and in most cases the cheaper bearings used in their draft inducer motors.
  25. Replies
    8
    Views
    1,632

    Placeing the coil on the return side is correct....

    Placeing the coil on the return side is correct. If on the supply side the heat pump might not like haveing 100 plus degree air blowing into its indoor coil. The furnace should be running while the...
Results 1 to 25 of 175
Page 1 of 7 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event