Search:

The problem could be electrical, I would check for proper voltage and also check the neutral conductor. If it works on the bench it has to be the location.

Wish I could just keep mine as neat.:o

Nice... Weathered pretty good

Thats pretty much what I've been doing when time allows,
Kinda sad that a CrackHead will destroy a condenser for 30 or 40 dollars, Even less than that if they get a spiral tube.

How do you dispose of old units, Do you remove coils, copper ect, or just scrap them in one piece? how much difference does it actually make?

:)

Big Fingers, I kinda think the Gorilla's not the only one with that problem.:rolleyes:

Kinda like an OOgiee gone bad..... like without any women.:eek:

I never saw anything quite like that...

Is it Standard Practice to upsize the Indoor coil & Air Handler by 1 ton??
3 ton outside, 4 inside heatpump

People make fun off what they don't understands...:rolleyes:

:eek:

How much to you actually save.... you can by more efficent equipment but how far down the road is the break even point when compaired to simpler systems.... For my money simpler is always more...

I'm sure most of you are talking about Mastic Tape,...Very easy to work with and extreamly difficult to remove, an excellent product.

Valves not seating properly, Vibration

You ever heard of enhansed copper?

Some manufactures make tons of money with people assuming that you get what you pay for, Just because it cost more doesn't make it any better. In fact you be surprised how cheeply some " Top Shelf "...

You mean the ones that are never around to do any service work???:(

I changed the Return @ 1st Failure, I'm not going to knowing leave a problem with any unit unless the HO just refuses my advice. I just want to be as certain as I can that its not something I may...

I didn't install this unit , just ended up with it . The unit is a 12 seer Gibson Heat pump. I'm not certain why the unit was replaced, HO said they replaced line sets , really didn't look that way...

I have never seen a filter in suction line, The unit seems to have a bad bearing in the compressor, would any debree that happens to make it throught the accum. cause bearing failure?

Replaced compressor and Reversing valve on 3 ton Gibson. Pilot line broke off on valve and compressor shorted starting with no R-22. Now 2 mos later the compressor sounds like it has a mouth full of...

That coil is kinda dirty, not that it needs and extra pressure to lose the Freon.

That one dude kinda looks like Steve O

You can buy them on the Net.