Search:

Type: Posts; User: Core_d

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    142
    Views
    3,300

    Must be an inside joke, the hvac gobblin :)

    Must be an inside joke, the hvac gobblin :)
  2. Replies
    142
    Views
    3,300

    I would personally like to be better prepared for...

    I would personally like to be better prepared for pressure switch issues with Heating season coming up. As in pressure actuators anything and every thing I may need to know about them ...
  3. Replies
    15
    Views
    2,049

    You move it closer to the entrance? Forty foot...

    You move it closer to the entrance? Forty foot is sa good crawl.
  4. Replies
    13
    Views
    1,531

    Ever found a leak in the middle of the condensor...

    Ever found a leak in the middle of the condensor like that? If so ode wander about the rest of it.
  5. Yea no way to force defrost other than jump the...

    Yea no way to force defrost other than jump the heater to line and turn the stat down so the fan kicks off. If the board is a GE with the 5 prong plug you can replace it with a mechanical timer, ...
  6. Replies
    12
    Views
    458

    With the wrong piston I'm thinking the temp drop...

    With the wrong piston I'm thinking the temp drop would be a good bit lower. Couldn't hurt to check a few more things though, tesp would be first then check out the compressor. It's probably pulling...
  7. Replies
    12
    Views
    458

    Ide say airflow, and likely a bad compressor.

    Ide say airflow, and likely a bad compressor.
  8. Thread: More Braze Rod!

    by Core_d
    Replies
    17
    Views
    2,423

    nope

    nope
  9. Replies
    85
    Views
    3,752

    And cap tubes on comfort cooling.

    And cap tubes on comfort cooling.
  10. Replies
    24
    Views
    2,618

    First variable Compressor Trane

    We have like 30 them the xlv and xv that aluminum monstrosity is expensive

    Careful with the leads too make sure your meter is good for 400v DC. Ive never actually checked the volts though also...
  11. Replies
    27
    Views
    1,620

    Put an ecm on dat b*tch :p

    Put an ecm on dat b*tch :p
  12. Replies
    27
    Views
    1,620

    So then what? Fix them, step away. Back away,...

    So then what? Fix them, step away. Back away, run away,offer demo crew??
  13. Replies
    4
    Views
    443

    Manifold gauges

    Manifold gauges
  14. Your coil is 26* acording to my pt chart

    Your coil is 26* acording to my pt chart
  15. That was my thought[emoji3]

    That was my thought[emoji3]
  16. Adding mj-x oil your bleeding over high to...

    Adding mj-x oil your bleeding over high to suction for 3 minutes. I open almost fully. Compressor gets a little loud (not much). Its starved and hot anyways.
  17. Charging R22...bottle always upright vapor charging or upside down liquid cha...

    Thank you jp, when compressors runs low it runs very hot.

    With a small amount of common since it would be damn near impossible to slug an compressor.
  18. How bout the hot gas line?

    How bout the hot gas line?
  19. What you need all that for?

    What you need all that for?
  20. At what point does it start being cold and sweaty

    At what point does it start being cold and sweaty
  21. Always liquid its faster

    Always liquid its faster
  22. Replies
    6
    Views
    552

    Some systems will have a delay on outdoor unit...

    Some systems will have a delay on outdoor unit start up and shutoff. They will also overshoot the temp by a set degree amount in order to to keep humidity down as needed.
  23. Replies
    21
    Views
    1,831

    Ide get it if you like it. If you ever leave it...

    Ide get it if you like it. If you ever leave it somewhere after being a custom to the insulation be mindful what your hand is touching;) i play with live wires more than I should. Kinda keeps it...
  24. Replies
    27
    Views
    1,620

    Some of it will turn into delicious apples my...

    Some of it will turn into delicious apples my friend;) why not just heat our house with uv lights? Great air quality at no extra charge;)


    No you cant has free light.
  25. Replies
    27
    Views
    1,620

    To a different degree alot of wattage is used...

    To a different degree alot of wattage is used making light of different types. I believe your talking about resistance heaters?
  26. Replies
    27
    Views
    1,620

    Are the bulbs hps or cwf ? That makes a BIIIIIIG...

    Are the bulbs hps or cwf ? That makes a BIIIIIIG difference. If they are special type grow lights consult the maker.
  27. Replies
    60
    Views
    2,771

    Anyone know why my teet sometimes reads error...

    Anyone know why my teet sometimes reads error between that and my check and charge app saying i cant charge a system if its above 80 outside with a 60degree idwb im getting a little frustrated:)
  28. I dont care much for logans, dakotas or texas...

    I dont care much for logans, dakotas or texas road house. All are good but we have alot of rusty buckets in col, ohio and thats the best steak ive had in a while. Steaks are just so easy to make at...
  29. Replies
    16
    Views
    971

    Well the jury is out.... I still wander if that...

    Well the jury is out.... I still wander if that slime started crawling:p it must have been a similar environment to a condensate tube where life all began.
  30. Thread: Stumped

    by Core_d
    Replies
    22
    Views
    1,197

    Stumped

    Yes if its above 80 in the house the txv will be wide open and bring the subcooling down. If you charge by the nameplate subcooling with that much load on the indoor coil you will over charge it. ...
  31. Thread: Stumped

    by Core_d
    Replies
    22
    Views
    1,197

    Could you hear it bypassing?

    Could you hear it bypassing?
  32. Replies
    16
    Views
    971

    That was my first thought all though ive never...

    That was my first thought all though ive never seen slime scrunch up like that. Guess the pump could make it do that? The tube and system is only 2years old.
  33. Replies
    16
    Views
    971

    Im no expert but, what else could it be?

    Im no expert but, what else could it be?
  34. Replies
    4
    Views
    265

    Wired the pump on the comm wire again:p

    Wired the pump on the comm wire again:p
  35. Replies
    16
    Views
    971

    Tape worm in condensate tube

    Not when i got to it. Had to get up there though.
  36. Replies
    16
    Views
    971

    Trust me ruined my appetite

    Trust me ruined my appetite
  37. Thread: Stumped

    by Core_d
    Replies
    22
    Views
    1,197

    Did it pump down ok?

    Did it pump down ok?
  38. Thread: Stumped

    by Core_d
    Replies
    22
    Views
    1,197

    Ok, whats your return temp in return wet bulb? A...

    Ok, whats your return temp in return wet bulb? A twelve degree split may be appropriate. I cant see a 178 suction pressure being ok though. If your charging by nameplate sub cooling and the house...
  39. Replies
    16
    Views
    971

    Tape worm in condensate tube

    Get a load of this. From wat i understand this tube along with the washer was stubbed into the main drain line for the house feeding a septic tank. The pic is just a piece this thing. It was a...
  40. Thread: Stumped

    by Core_d
    Replies
    22
    Views
    1,197

    Stumped

    Sounds like reversing valve is letting a little over...
  41. Replies
    27
    Views
    1,620

    Did it always freeze up? Piston or txv? Mild...

    Did it always freeze up?
    Piston or txv?
    Mild outdoor temps?
    Static pressures?
  42. Staving evap:undercharged,restricted liquid line....

    Staving evap:undercharged,restricted liquid line.

    Over fed cond. restricted liquid line, dirty outdoor coil, bad airflow at cond., overcharged....with a fixed bore unit low airflow indoors will...
  43. Replies
    45
    Views
    2,296

    Ive seen both sides of the grass in my short...

    Ive seen both sides of the grass in my short career in HVAC and can say with confidence hacks exist in resi, commercial and refrigeration. Folks have done it for years and have bad practices. It...
  44. Replies
    12
    Views
    570

    How many times have they replaced them for you?

    How many times have they replaced them for you?
  45. Replies
    45
    Views
    2,296

    I had a customer ask if my name was nate:p

    I had a customer ask if my name was nate:p
  46. Replies
    12
    Views
    570

    I had that issue with some smans a borrowed...

    I had that issue with some smans a borrowed [emoji33]
  47. Replies
    60
    Views
    2,771

    Well i just gave er a quick check and its not...

    Well i just gave er a quick check and its not that far off now[emoji16]600611
  48. Replies
    60
    Views
    2,771

    I would be my thought that the more load you have...

    I would be my thought that the more load you have on the coil the easier it would be to get a high delta h? Specially with a fixed orifice. Low outdoor temps would probably be the biggest killer on...
  49. Replies
    60
    Views
    2,771

    Here is brents post "Generally a properly...

    Here is brents post "Generally a properly operating system will have a ΔH of 5.7-7.7. Airflow is mainly what will cause a deviation outside these parameters. A refrigerant related issue will cause...
  50. Replies
    60
    Views
    2,771

    From my experience it always is very cose to...

    From my experience it always is very cose to seven, as well as jim bergmans video on the tool and i believe brent ridley stated the exact number should be 6.7. I perfectly ignorant of this before...
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Quality Home Comfort Awards