Search:

Type: Posts; User: rimide

Page 1 of 6 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    1,089

    would like to thank those that helped here---have...

    would like to thank those that helped here---have 4 interviews next week---see what comes about
  2. Anyone one here looking for a comm. tech in Charleston SC area

    Moving to Charleston SC area --Looking for Commercial Job---chillers, control,towers etc. etc
  3. Replies
    3
    Views
    1,089

    commercial in South carolina

    Anybody have openings in Charleston, S.C. area--or know of a good company to go to???
  4. Thread: plumbing

    by rimide
    Replies
    2
    Views
    365

    thanks--I knew it was the wrong place--just shot...

    thanks--I knew it was the wrong place--just shot it out there---will go
  5. Thread: plumbing

    by rimide
    Replies
    2
    Views
    365

    plumbing

    Hate to ask this here--but any plumber in here that know of a shower handle escutcheon that has a locking ring with it--I.E. shower handles float in wall---and its an out side wall--so ripping it is...
  6. Replies
    10
    Views
    833

    Had a chiller under ground---had to warranty...

    Had a chiller under ground---had to warranty change out a condenser motor---had to shimmy with tools above my head--it sucked--but was funny at same time---I'll see if I can find the pic
  7. Replies
    6
    Views
    536

    I can give all the info you...

    I can give all the info you want--wb-db-sh-sc-amps--but the question is shut down no probs with unit running or cutting out-
  8. Replies
    6
    Views
    536

    yep---call for heat and fan satisfied--at the...

    yep---call for heat and fan satisfied--at the leds in air handler---yes new install--variable speed fan goes from normal operation to slow and out door unit continues to run for about 10 minutes and...
  9. Replies
    6
    Views
    536

    no actually was sequence of operation---after...

    no actually was sequence of operation---after call for heat (hp) and fan go away--the fan(variable) runs low speed and hp continues to run--it does eventually shut down---so the question is---is that...
  10. Replies
    6
    Views
    536

    Armstrong 4SHP18LT

    any armstrong guru's on here? have a question about unit cycling--I.E. shuting down after call for heat
  11. Replies
    23
    Views
    1,710

    had a boiler kick my butt for a week--replaced a...

    had a boiler kick my butt for a week--replaced a lot of parts and cleaned everything-twice and it still failed to lit off--turns out the ignitor had been there for so long it actually blasted away...
  12. Replies
    9
    Views
    889

    currently they have 53 refrigeration jobs open...

    currently they have 53 refrigeration jobs open and 0 hvac jobs--I'll bookmark them though--Thanks
  13. Replies
    9
    Views
    889

    Thank you and sent a pm to you as well

    Thank you and sent a pm to you as well
  14. Replies
    9
    Views
    889

    primarily in hotels (400 rms or greater)--have...

    primarily in hotels (400 rms or greater)--have been traveling from northern VT to Fla
  15. Replies
    9
    Views
    889

    for the last few years I have been working with...

    for the last few years I have been working with line carrier systems
  16. Replies
    9
    Views
    889

    what is the majority of systems you have?? Have...

    what is the majority of systems you have?? Have done my fare share of controls--just wasn't my primary
  17. Replies
    9
    Views
    889

    Commercial in S.C.

    Any commercial jobs in South Carolina - preferably near Ladson/Charleston area
  18. Thread: manuals

    by rimide
    Replies
    5
    Views
    717

    manuals

    I have a shelf ful lof manuals Ranging from lieberts to chillers--23xl service/repair/rebuild, toshiba e3 drives, I thing I even have vvt system 1,2, and 3. Since I am not in that field anymore and...
  19. Replies
    5
    Views
    1,299

    still have the freezer???

    still have the freezer???
  20. Thread: Mcquay Chiller

    by rimide
    Replies
    22
    Views
    4,826

    yep---if you got material in the tubes------HAVE...

    yep---if you got material in the tubes------HAVE fun, new headers and the joy of cutting all the u-bends off-cleanignt he tube and re-installing the new u-tubes and and headers

    been there--done...
  21. Replies
    2
    Views
    512

    I'm in central east----where is beaver county

    I'm in central east----where is beaver county
  22. Replies
    4
    Views
    981

    a little help here

    I'm a high tonnage chiller tech--if you have an idea please post
    TKS
  23. Replies
    4
    Views
    981

    lennox H/P defrost board???

    anyone help me with a Lennox heat pump condenser, Tripped the breaker on the transformer, poked around anf found Y1 on the condender grounded, checked contactor(ok), disconnected Y1 in the A/H and...
  24. Replies
    48
    Views
    4,015

    Know all about the turbocor--I worked for McQuay...

    Know all about the turbocor--I worked for McQuay for a couple of years

    [Edited by rimide on 07-10-2006 at 09:44 PM]
  25. Replies
    48
    Views
    4,015

    on that multistack is that a Hitachi screw

    on that multistack is that a Hitachi screw
Results 1 to 25 of 126
Page 1 of 6 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event