Search:

Type: Posts; User: airconman

Page 1 of 6 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    621
    Views
    113,838

    Went out to a trailer house, just happened to...

    Went out to a trailer house, just happened to look up and no chimney cap... hmmm... went inside guy was a jerk, walks by and says just light it..... top door is on this trailer house furnace, 20 guys...
  2. Replies
    72
    Views
    5,120

    you can be missing one leg of your 220 and still...

    you can be missing one leg of your 220 and still get 110 on both sides...... or is it 120 and 240?
  3. Replies
    72
    Views
    5,120

    Do I have a pro membership?

    Do I have a pro membership?
  4. Thread: Beginner

    by airconman
    Replies
    10
    Views
    303

    What I've found is, you never quit learning. Or...

    What I've found is, you never quit learning. Or your in trouble.
  5. Replies
    23
    Views
    1,200

    I told this lady, what idiot told you that? She...

    I told this lady, what idiot told you that? She said I'm not gonna tell you. But it's Mr 80 year old man in town that used to think he was a furnace guy.
  6. Replies
    19
    Views
    1,814

    sounds like a crack in secondary..... and when...

    sounds like a crack in secondary..... and when you pull that cover off, you'll probably find little rings off the primary. Take a CO test in the flue pipe, it should be less than 100 ppm. or 400...
  7. Replies
    19
    Views
    1,814

    Put a CO tester in the exhaust vent. Maximum is...

    Put a CO tester in the exhaust vent. Maximum is 100 .......or 400 free air... you could be seeing 1200 and that my friend is a secondary problem. Carrier seems to have these problems big time...
  8. Replies
    9
    Views
    1,182

    Yep start with the trap.... I did have a heil one...

    Yep start with the trap.... I did have a heil one time have a bad gasket on the inducer motor.....It would run about 4 minutes and the pressure switch would go into convulsions...
  9. Replies
    8
    Views
    420

    Any downflow furnace should have the coil mounted...

    Any downflow furnace should have the coil mounted on the supply side of the furnace. On the Bottom. Mounted on top causes premature rust on the HE.
    Although about every downflow I've seen this...
  10. Replies
    23
    Views
    1,200

    Ok the rest of the story...... I told this lady...

    Ok the rest of the story...... I told this lady that her house had no CO in it, and that crack should be shut down..... I had her buy a CO detector and tried to get her a free furnace from two...
  11. Replies
    23
    Views
    1,200

    This is the problem, some say it's bad, some say...

    This is the problem, some say it's bad, some say it's good. I always figure ANY crack, Anywhere it can spread and let exhaust fumes into the conditioned area, is a shutdown. But seems like 1 in 10...
  12. Replies
    23
    Views
    1,200

    Well it isn't blowing the pilot out yet, so does...

    Well it isn't blowing the pilot out yet, so does the pilot and the end of the burners burning flame on a 1/8 inch crack safe? 1/8 wide and 1 1/2 inch across... burner to burner crack. More of a...
  13. Replies
    23
    Views
    1,200

    crack in HE? OR not crack in HE?

    hey fellers, got a quick question about a Rheem
    80 percent furnace, the famous crack above the
    pilot light. This crack goes from cell to cell across
    It is not blowing the pilot out yet.
    Ok to...
  14. Replies
    35
    Views
    6,263

    have your dealers show you their products in...

    have your dealers show you their products in action. You'll go Trane then.
    It's worth the extra. You cannot bid a Trane with a Goodman, it won't happen Trane is more expensive. Goodman has come...
  15. Replies
    10
    Views
    879

    I've found water in pressure switches for no...

    I've found water in pressure switches for no reason, usually at start of winter. Get that water out or replace it and it should fire.... It's a pressure problem anyway. Whip out the old magnahelic...
  16. Replies
    14
    Views
    2,796

    ya your right buy a trane and relax..... as I...

    ya your right buy a trane and relax.....
    as I duck for cover from the goodman guru's...... INCOMINGGGGGGGGGG!!! I think most the guys here must sell goodman or work for em.... but I like their...
  17. Replies
    46
    Views
    4,805

    I don't wanna argue as much as the goodman guru's...

    I don't wanna argue as much as the goodman guru's but here's an example...
    I put a Trane in for a guy, his neighbor puts in a Goodman in his new house down the road. They are friends.
    Good...
  18. Replies
    8
    Views
    774

    19 years. hmmmm Yea I'd consider changing it. ...

    19 years. hmmmm Yea I'd consider changing it. More efficient these days.
  19. Replies
    11
    Views
    1,119

    But then down the street there's the old lady...

    But then down the street there's the old lady glad to see ya....... don't forget them.......and I think I need a beer after hearin he had one of my weeks.
  20. Replies
    5
    Views
    1,324

    Thanks Looney.

    Thanks Looney.
  21. Replies
    13
    Views
    5,879

    contactor probly stuck...

    contactor probly stuck...
  22. Replies
    14
    Views
    2,796

    Goodman Guru's like to argue I know that.........

    Goodman Guru's like to argue I know that...... but I'd go with carrier and I sell Goodmans toooooooooo, but I don't sell carrier. That tell ya somethin?
  23. Replies
    46
    Views
    4,805

    I just hate the part,when you put a goodman in...

    I just hate the part,when you put a goodman in where you have to go apoligize to the neighbors for noise of the condensor.
    Oh by the way Goodman quit putting out the lifetime warranty deal on the 14...
  24. Replies
    5
    Views
    1,324

    Anyone know what size this condensor is? Model...

    Anyone know what size this condensor is?
    Model # HS94113P
  25. Replies
    3
    Views
    1,225

    first of all.....after Jan 2006 noone is allowed...

    first of all.....after Jan 2006 noone is allowed to manufacture 12 SEER any more... 13 minimum.
    heat pumps are better choice. cheaper to run than gas down to about 25 30 degrees then gas takes...
  26. Replies
    7
    Views
    834

    Buy the Trane and quit worryin, they are goin to...

    Buy the Trane and quit worryin, they are goin to all aluminum too handle the higher pressures of R 410. in southern climates other brands have experienced champaine leaks. Trane is goin this way...
  27. Replies
    84
    Views
    7,409

    seen one that a guy did and it wasn't put...

    seen one that a guy did and it wasn't put together right... might not be all the way slid inside itself.
  28. Replies
    15
    Views
    1,676

    hold the phone... don't remember the month but...

    hold the phone... don't remember the month but trane had a code six or 3 problem on the board and did recommend changing out the board. This should have been all fixed by now though. Yours might...
  29. Replies
    3
    Views
    609

    actually it wasn't the homeowner it was his bank....

    actually it wasn't the homeowner it was his bank. a WELLLLs known bank.
  30. Replies
    7
    Views
    910

    coolwhip had one in a lennox one side of the W...

    coolwhip had one in a lennox one side of the W terminal I got no heat other side where ya put wire it worked fine. I thought okkkkkkk we'll leave it like that let me know...... 2 years later its...
  31. Replies
    3
    Views
    609

    As of reading another post on a general...

    As of reading another post on a general contractor this came to mind.
    Put a furnace and A/C in a house and came time to get paid the homeowner was going thru a bank on a home loan deal. About a...
  32. Replies
    10
    Views
    2,134

    run cap is all ya need. i think I'd change that...

    run cap is all ya need. i think I'd change that motor if its changing directions somethin aint wired right inside I'd say.
  33. Replies
    7
    Views
    910

    coolwhip..... ya know this guy said it did this...

    coolwhip..... ya know this guy said it did this when it was new... I kinda forgot about that because it is about 4 or 5 years old now..... but I think this will look good bein replaced but nope...
  34. Replies
    22
    Views
    2,494

    looks to me like the only difference between the...

    looks to me like the only difference between the GMS90 and the 95 is the number. Inducer fan faster or what? I think its like this.... as long as your close is all that counts kinda like horseshoes.
  35. Replies
    22
    Views
    2,494

    on the GMS furnace if you run the drain from left...

    on the GMS furnace if you run the drain from left side to dump on right make sure it doesn't trap in the hose.. my suggestion is do it like the installer guide says so ya don't have a problem with...
  36. Replies
    10
    Views
    2,134

    no brown wires? hmmm well if ya aint got no...

    no brown wires? hmmm well if ya aint got no cap.... change out that motor again. Whats all the colors of wires do you have on it? Should have probably Black Blue red green white and two browns? ...
  37. Replies
    7
    Views
    910

    yap looked at the back and didn't see anything...

    yap looked at the back and didn't see anything wrong which has me to thinkin a diode went out on the board...... BUTT this is where I don't know a thing about. and yep disconnected everything except...
  38. ever notice after distributors do their...

    ever notice after distributors do their inventory, they are always short on some things. Or this year the gas prices increase demand on equipment changing, well I was doin a church the other day and...
  39. Replies
    5
    Views
    1,882

    I wondered where he was gettin that info......

    I wondered where he was gettin that info... thought maybe he had two furnaces or somethin.
  40. Replies
    7
    Views
    910

    ok fellers, got this nordyne furnace 80% and the...

    ok fellers, got this nordyne furnace 80% and the fuse in the circuit board blows immediately following a buzzing coming from the board. checked everything for a grounding and nothing found.......
  41. Replies
    5
    Views
    1,882

    the 3 and the 4 in the model number is supposed...

    the 3 and the 4 in the model number is supposed to be the blower size.... the same model number on motor and squirrel cage ... ya got me there. Maybe someone at the factory put the wrong one in?
  42. Replies
    42
    Views
    3,757

    you forgot the limit dugfish

    you forgot the limit dugfish
  43. Replies
    17
    Views
    2,039

    either way should work. pump goes out and you...

    either way should work. pump goes out and you only have one, the whole house gets cold, pump goes out and ya have more only one room gets cold
    depends on who's puttin em in I'd say.
  44. Replies
    6
    Views
    820

    I'd say there would be a difference if you put...

    I'd say there would be a difference if you put identical equipment side by side.
  45. Replies
    13
    Views
    1,565

    filter? what filter? does my unit have a filter...

    filter? what filter? does my unit have a filter too?
  46. Replies
    13
    Views
    1,565

    I grew up thinking that the only stupid question...

    I grew up thinking that the only stupid question was one that wasn't asked. Gets aweful boring someone asks something in here and all some of you have is an I'm smarter than you so I aint tellin...
  47. Replies
    5
    Views
    999

    do you have 220 though? does the compressor run?

    do you have 220 though? does the compressor run?
  48. I believe that all trane coils being made today...

    I believe that all trane coils being made today have TXV's.
  49. Replies
    20
    Views
    3,014

    I think they are an excellent 2nd line. ...

    I think they are an excellent 2nd line. dependable. And I agree with compressors being noisy, but never seem to have problems other than that. Cabinets could be heavier but never had an issue with...
  50. Replies
    42
    Views
    3,757

    funny when they don't know somethin they just...

    funny when they don't know somethin they just toss out insults aint it. I wish I had time to sit on this thing and look up every furnace to see what it is. instead of just trying to help.
Results 1 to 50 of 267
Page 1 of 6 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event