Search:

Type: Posts; User: mdmatt

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    648

    Yeah I certainly wish it had that option....

    Yeah I certainly wish it had that option. Thinking about getting an Ecobee SMARTSi at this point.
  2. Replies
    4
    Views
    648

    Hi BaldLoonie! Looking at my thermostat I only...

    Hi BaldLoonie! Looking at my thermostat I only have an option 250 to control my second stage heating cycle. There is no 240 option on my thermostat even though it is listed in the manual!
    I have...
  3. Replies
    4
    Views
    648

    Honeywell 8580 WIFI cycling often

    Hi all,

    I recently had to replace my Pro1 IAQ thermostat (failed touchscreen). I chose the Honeywell 8580 Wi-Fi. I notice when it is cold outside it cycles considerably more than when I had my old...
  4. Thread: Nut Drivers

    by mdmatt
    Replies
    47
    Views
    8,953

    For what it's worth, they also offer an...

    For what it's worth, they also offer an extended-reach version:

    http://www.service.kleintools.com/Tools/PRD/Category/Multi-Bit%20Screwdriver/Nut%20Driver%20SCREWDRIV-MULTIBIT/Product/32560


    ...
  5. Thread: Nut Drivers

    by mdmatt
    Replies
    47
    Views
    8,953

    Sounds good, I may have to get one. It looked...

    Sounds good, I may have to get one. It looked like they have a longer reach as well.
  6. Thread: Nut Drivers

    by mdmatt
    Replies
    47
    Views
    8,953

    Anyone ever try the Klein Heavy-Duty Multi-Bit...

    Anyone ever try the Klein Heavy-Duty Multi-Bit Screwdriver/Nut Driver 32557? I saw this in Home Depot, and it looks more "heavy-duty" compared to the 11-in-1.

    Klein link:
    ...
  7. Replies
    3
    Views
    564

    Would it be OK to use foam here?

    Hi all,

    I caught a mouse inside my home and was looking to seal openings outside.
    Looks like where my line set, power and control line is coming out has a big gap. It goes up about 4 inches ...
  8. Replies
    16
    Views
    1,619

    Yeah, I figure go left and maybe two elbows and I...

    Yeah, I figure go left and maybe two elbows and I could lower the run.
  9. Replies
    16
    Views
    1,619

    That's a Honeywell Truestream humidifier drain...

    That's a Honeywell Truestream humidifier drain line. Yes, I like the links Mark sent.
  10. Replies
    16
    Views
    1,619

    Any suggestions as to re-routing it?

    Any suggestions as to re-routing it?
  11. Replies
    16
    Views
    1,619

    It's all glued in that area except on the bottom...

    It's all glued in that area except on the bottom where it separates.
  12. Replies
    16
    Views
    1,619

    Thanks for the replies everyone! I had tried...

    Thanks for the replies everyone! I had tried rubber o-rings inside before which didn't really help. I was considering using silicone tape (neat stuff), but that would only be temporary as it would...
  13. Replies
    16
    Views
    1,619

    Condensate line issue

    Hi everyone. Before I call a pro in I figured I would ask advice here first. I have a slow drip condensate line drip from a non-glued junction. I can't glue it becuase I need to remove, or pivot,...
  14. Replies
    39
    Views
    2,759

    What kind of shelf life do modern run capacitors...

    What kind of shelf life do modern run capacitors have?
  15. Replies
    5
    Views
    1,067

    Well, times are tough I suppose. Could be someone...

    Well, times are tough I suppose. Could be someone looking for a cheap free high...:)
  16. Replies
    5
    Views
    1,067

    Thank you both, I appreciate the responses. I had...

    Thank you both, I appreciate the responses. I had initially considered calling the contractor, but I wasn't sure if the cap was missing from the get-go or someone had taken it. I would feel bad about...
  17. Replies
    5
    Views
    1,067

    Service valve cap question

    Hi everyone,

    I noticed on my condensing unit that the suction line service valve cap is missing. The system was installed in April, and I'm not sure how long the cap has been missing. I hope the...
  18. Replies
    9
    Views
    1,065

    I was calling for humidity. I don't think my home...

    I was calling for humidity. I don't think my home is very "tight" so to speak, but the large differences in the hygrometers and the humidstat has me puzzled.
  19. Replies
    9
    Views
    1,065

    Interesting. I wonder if that is the cause of my...

    Interesting. I wonder if that is the cause of my low-reading issue, or I just have an inaccurate humidstat? For testing for a while, I had the heating and cooling off and just let the humidifier run...
  20. Replies
    9
    Views
    1,065

    An addition to the above post, I left the setting...

    An addition to the above post, I left the setting at 35% and now it is humidifying with the other two hygrometers showing humidity in the upper 40's!
  21. Replies
    9
    Views
    1,065

    I took your suggestion. My portable was reading...

    I took your suggestion. My portable was reading 48%. The Honeywell humidstat, when manually changed, would engage at 40% and cut back off around 30%.
  22. Replies
    9
    Views
    1,065

    Honewell TrueSteam humidstat accuracy?

    Hi Everyone. I had a new system installed recently with a Honeywell TrueSteam (6 gallon capacity) with a H8908 humidstat installed in the return ductwork.

    I was wondering if anyone had issues...
  23. Replies
    18
    Views
    3,076

    Thank you. I will email them and see if it is the...

    Thank you. I will email them and see if it is the correct model.

    It was the availabilty that made me look for other options, I really couldn't find anything online for the "fil 18-32" so I...
  24. Replies
    18
    Views
    3,076

    Hi Blitzz86, I have a 15x20 in it now. It's a bit...

    Hi Blitzz86, I have a 15x20 in it now. It's a bit loose side to side and I can't get the front cover on because the filter sticks out the front slightly. Do you ever have this issue? (It initally had...
  25. Replies
    18
    Views
    3,076

    I thank you again. With the current tight 16x20...

    I thank you again. With the current tight 16x20 filter in there the front cover over the filter wont fit on correctly (from side to side). I will initially seek out the Goodman filter, and go from...
Results 1 to 25 of 40
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event