Search:

Type: Posts; User: larnot

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    41
    Views
    2,924

    Get trained, get confident, get lucky, get with a...

    Get trained, get confident, get lucky, get with a good company, get rich, get over it.
    :munching:
  2. Replies
    4
    Views
    397

    OK, thanks for that. Next question is both lines...

    OK, thanks for that. Next question is both lines or just suction? Then regular 'P' type trap or inverted?
  3. Replies
    4
    Views
    397

    Carrier 38AUQ 25 question.

    Having to relocate this heat pump onto a roof 25 feet above the airhandler. Do I need any traps in the lineset? Using the required size line (1-3/8", 5/8"), but not too clear in the installation...
  4. Replies
    7
    Views
    647

    I think we'll go with the Diversitech CS-3...

    I think we'll go with the Diversitech CS-3 Condensate Switch.
    Thanks everyone.
  5. Replies
    7
    Views
    647

    The compressor sits in a tray on top of the drain...

    The compressor sits in a tray on top of the drain pan. There is about half an inch gap all around. As the intake grill is open to the elements, if rain water was to get in, it would set the off a wet...
  6. Replies
    7
    Views
    647

    Small/tiny condesate switch.

    Just been told by an inspector that we need a condensate switch on upright PTAC's we installed. First Company sell the units, but don't offer a switch. Drain pan is tight. Anyone have suggestions?
  7. I worked at one place (for about a month) and...

    I worked at one place (for about a month) and sold one of their UV light/filter packages to a homeowner who had mold and allergies...when I got back to the shop they gave me a round of applause like...
  8. Replies
    15
    Views
    1,319

    Maybe running backwards?

    Maybe running backwards?
  9. Replies
    62
    Views
    4,441

    My Mother retold a similar story...the poor will...

    My Mother retold a similar story...the poor will always be poor...they make the poor choice.

    I make no quotes, and I call no one friend...I live happier with my self by 'doing the right thing' and...
  10. OK, didn't read everything and I'm in Heatpump...

    OK, didn't read everything and I'm in Heatpump territory.

    If the (residential) compressor can't stand ONE out of the ordinary start, in this case to pump it down, and survive, then it has no...
  11. Replies
    62
    Views
    4,441

    Well, IMO, that is a bit over the top. So, if...

    Well, IMO, that is a bit over the top.
    So, if they are dumb enough they deserve everything they get?
    However, if we tell them what they need we are Nazi's?

    Yeh, I probably read that wrong, but...
  12. Disconnect the outdoor fan motor, that will warm...

    Disconnect the outdoor fan motor, that will warm everything up real quick. Then pump it down like you would in the summer.
  13. Replies
    62
    Views
    4,441

    I got my stepson a job as a laborer where I work,...

    I got my stepson a job as a laborer where I work, because his 5 year Criminal Justice degree didn't seem to be panning out.
    He hates it, but he's still there.
    I can imagine him (and an awful lot of...
  14. Replies
    10
    Views
    974

    Just having fun with you my friend...keep up the...

    Just having fun with you my friend...keep up the good work.
  15. Replies
    10
    Views
    974

    How much did you get at the scrapper for it??

    How much did you get at the scrapper for it??
  16. Replies
    7
    Views
    1,065

    We had 4 or 5 of them from the same parts house...

    We had 4 or 5 of them from the same parts house go bad. Also seems like the end bulges a little and makes them a pain to remove.
  17. Replies
    23
    Views
    2,542

    Will it bring on stage 1 and stage 2 seperately...

    Will it bring on stage 1 and stage 2 seperately in the test mode?
  18. Replies
    62
    Views
    4,441

    The last one is a genius...pulling LRA but has no...

    The last one is a genius...pulling LRA but has no power going to it!

    I was told that if you do a good honest job for people they may tell another person. If you try to screw somebody over, they'll...
  19. Replies
    7
    Views
    770

    Did you take the jumper off of the test pins as...

    Did you take the jumper off of the test pins as soon as it started defrost?
  20. Thread: NATE Exam

    by larnot
    Replies
    30
    Views
    2,661

    Congrats. Don't forget you'll need 60 CEH to...

    Congrats. Don't forget you'll need 60 CEH to recertify. Start collecting!
  21. Replies
    44
    Views
    5,824

    The only time I'm asked if i have NATE...

    The only time I'm asked if i have NATE certification is when I go to classes.
    State requires 8 CEH's here. I've yet to be in a class where more than 5% have NATE.
    If the public doesn't know about...
  22. Replies
    47
    Views
    4,178

    As far as the original post is concerned...check...

    As far as the original post is concerned...check the blower (speed and wheel) for cleanliness.Get a superheat and subcooling reading at least. The more you tell, the more we can sell!
  23. Replies
    47
    Views
    4,178

    While I agree with that, I have to say that my...

    While I agree with that, I have to say that my thinking is along the lines of Dogboy. I change a lot of outdoor TXV's that have dryers attached. Always cut them out and sweat in a new one outside of...
  24. Thread: Trane Wreck.

    by larnot
    Replies
    31
    Views
    6,849

    It's new housing. They sell the lot and people...

    It's new housing. They sell the lot and people pick their floorplan. It's like a production line with different sub contractors for every job. Needless to say, Quality of work is not first class.
  25. Thread: Trane Wreck.

    by larnot
    Replies
    31
    Views
    6,849

    Oh yeh, they back-charge the deck guys for 2 new...

    Oh yeh, they back-charge the deck guys for 2 new ones, and then put the 'hangers' in rental property somewhere.
  26. Thread: Trane Wreck.

    by larnot
    Replies
    31
    Views
    6,849

    I guess we can't say 'It's hard to drop a trane'...

    I guess we can't say 'It's hard to drop a trane' anymore.
    btw that's a dryer vent next to where the right-hand unit used to be.
  27. Thread: Trane Wreck.

    by larnot
    Replies
    31
    Views
    6,849

    Deck posts not in concrete, not bolted to house,...

    Deck posts not in concrete, not bolted to house, couple inches of rain and whoosh. Good strong solder joints though.
  28. Thread: Trane Wreck.

    by larnot
    Replies
    31
    Views
    6,849

    Trane Wreck.

    :oops:398181
  29. Replies
    12
    Views
    1,151

    Thanks. So will it also take up evaporator space?

    Thanks. So will it also take up evaporator space?
  30. Replies
    12
    Views
    1,151

    OK, so 407C, which is a r-22 replacement, is...

    OK, so 407C, which is a r-22 replacement, is approximately a 50/50 blend of 134a and 410a. One of those runs higher pressures at a given temp and one runs lower pressures at the same temp. Together,...
  31. Replies
    12
    Views
    1,151

    Thanks. My issue is 'charging chart' head and...

    Thanks. My issue is 'charging chart' head and subcooling, 20 degree superheat and delta, low suction through the TXV.
    It's an older 410 heatpump (9 years), indoor TXV and strainer just changed.
  32. Replies
    69
    Views
    9,739

    Worked for one company...took van home on call or...

    Worked for one company...took van home on call or not. They added $16 to your check every week, taxed you, then took $16 out of your check. Supposedly IRS thought it was an $800 a year benefit....
  33. Replies
    4
    Views
    729

    I have hoses with the ball valve and fitting in...

    I have hoses with the ball valve and fitting in one and have never had a problem. Have also owned the kind with a fitting, then 4-6 inch hose, then ball valve. Those I would agree need to be purged.
  34. Replies
    12
    Views
    1,151

    Thanks for your replies. I could understand the...

    Thanks for your replies. I could understand the high head if you put 410 in a 22 system, or say, 22 in a 134a system. But, I can't see it happening the other way around.
  35. Replies
    12
    Views
    1,151

    410 mix question.

    Can anyone tell me how a small (say less than 5%) amount of R-22 would react in a 410 system? Would I be able to pick it up by P/T alone? Would it affect operating pressures in a TXV unit noticeably?...
  36. Thread: service call

    by larnot
    Replies
    41
    Views
    4,350

    I did go muttering all the way to one 'smoke...

    I did go muttering all the way to one 'smoke coming out and fan not running'. Found the motor wire burnt at the capacitor!
  37. Replies
    16
    Views
    1,743

    Do they have an electric water heater? If they...

    Do they have an electric water heater?
    If they have an old fashioned rotary type electric meter outside, you can stand and watch the wheel speed up and slow down when the Aux. heat kicks in and...
  38. Replies
    52
    Views
    12,740

    Or, maybe more important, inform the customer!

    Or, maybe more important, inform the customer!
  39. Thread: service call

    by larnot
    Replies
    41
    Views
    4,350

    3am Sunday morning...College kids in a...

    3am Sunday morning...College kids in a rental..."Dude, it's 83 in my drum!" - 'I'll be there at 8!' - "grumble, grumble" ...15 minutes of pounding the door and ringing doorbell later, hangover...
  40. Replies
    52
    Views
    12,740

    That only works in Florida because of the...

    That only works in Florida because of the humdititty...thought everyone knew that! :)
  41. Replies
    52
    Views
    12,740

    Bottom line is you can't mix them. What...

    Bottom line is you can't mix them.
    What refrigerant would you have after you'd Recovered?
  42. Thread: service call

    by larnot
    Replies
    41
    Views
    4,350

    We have outfits here that advertise 'no overtime...

    We have outfits here that advertise 'no overtime charges ever'. Thing is, if you call them at 2am they have their answer service read a script that says 'we are experiencing a high level of calls...
  43. Replies
    22
    Views
    2,433

    You telling me there could be issues if I...

    You telling me there could be issues if I overcharge the system?? :)
  44. Replies
    22
    Views
    2,433

    They told me at sckool that Propane was...

    They told me at sckool that Propane was flammable...but you know what skhools are like!! R-290 is used in Europe a lot, and not just for Grilling!!!
  45. Replies
    16
    Views
    8,721

    Basically, you pressure test to check for leaks...

    Basically, you pressure test to check for leaks from inside out. Think of a nail in your copper line, as you pull a vacuum the nail sucks in and makes a good seal. As soon as you put pressure on it,...
  46. Replies
    67
    Views
    9,127

    [QUOTE=ga-hvac-tech;15366931]IMO it is too late...

    [QUOTE=ga-hvac-tech;15366931]IMO it is too late to pay to stockpile R-22... might end up with an up-side-down investment./QUOTE]

    My understanding is that if there is a system that 'leaks' a pound...
  47. Replies
    67
    Views
    9,127

    I think you'll find that 407 is a blend of 410a...

    I think you'll find that 407 is a blend of 410a and 134a...not sure the proportions, but think it's around 50/50 (of course, they are both blends to begin with). I was also told that POE and mineral...
  48. Replies
    19
    Views
    2,078

    Or, it could be 5 aux, 10 defrost and 15...

    Or, it could be 5 aux, 10 defrost and 15 emergency. More info required.
  49. Thread: polaris

    by larnot
    Replies
    9
    Views
    890

    Yeh, to be honest, the last time i looked at a...

    Yeh, to be honest, the last time i looked at a Polaris it was a submarine.
  50. Thread: polaris

    by larnot
    Replies
    9
    Views
    890

    Was there a call 'to' the board?

    Was there a call 'to' the board?
Results 1 to 50 of 242
Page 1 of 5 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Quality Home Comfort Awards