Search:

Type: Posts; User: stryder

Page 1 of 7 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    5
    Views
    672

    thanks dude...will check it out...

    thanks dude...will check it out...
  2. Replies
    5
    Views
    672

    Exhaust fans and speed controls

    Have a simular thread in another section concerning the age old situation of speed controls on psc motors. Have several roof exhaust fans causing negative pressure in kitchens. Need to lower cfm's....
  3. Replies
    3
    Views
    1,252

    Exhaust fans and speed controls

    This might have been asked in controls but, here goes...Have older roof exhaust fans that seem to be causing negative pressure in several kitchens. Might be asking the age old question...speed...
  4. Thread: Savannah, GA.

    by stryder
    Replies
    5
    Views
    640

    Yes....Mechanical contractor in the Savannah area...

    Yes....Mechanical contractor in the Savannah area and have several locations, also Bluffton, SC, hilton head etc.....If you will send some type of contact information I can contact you.
  5. Thread: RTU run 24/7?

    by stryder
    Replies
    7
    Views
    816

    Not sure about corp. decisions to run units that...

    Not sure about corp. decisions to run units that way but I've got several systems in locations that are open 24/7 and they take quite a beating....
  6. Thread: Dream Truck

    by stryder
    Replies
    28
    Views
    6,681

    ...what.....no brush guard......lol

    ...what.....no brush guard......lol
  7. Replies
    8
    Views
    2,218

    ...gonna agree with 99 there, usually chattering...

    ...gonna agree with 99 there, usually chattering relays/contactors are caused by lack of proper voltage to the coil. Possibly low voltage short/problem in the control circuit??
  8. Thread: CO2

    by stryder
    Replies
    11
    Views
    1,420

    Been discussing CO2 levels and monitoring lately,...

    Been discussing CO2 levels and monitoring lately, if I'm not mistaken the National average ambient C02 levels is 450 ppm, your eventual settings inside should take that into consideration. (when...
  9. Replies
    13
    Views
    1,320

    Take a little time and check out Semco Equipment,...

    Take a little time and check out Semco Equipment, good web-site. They are a little on the pricey side though...
  10. Thread: signal

    by stryder
    Replies
    4
    Views
    680

    Gonna take a stab at this one...any time I have...

    Gonna take a stab at this one...any time I have had to communicate with any EMS system, regardless of brand, I have had to obtain the software via the manufacturer...hope this helps
  11. Thread: HELP

    by stryder
    Replies
    11
    Views
    1,069

    Personally I think you have a good foundation...

    Personally I think you have a good foundation started in the industry. Probably safe to say that 20% of the service techs in the field today don't have a good Manual D/N/J background. Master the...
  12. Replies
    4
    Views
    1,632

    Thanks guys....yes persistant phone calls to the...

    Thanks guys....yes persistant phone calls to the distributor after the usual 30 days had passed. Like I said...just curious if I was the only one to wait an unusual amount of time to receive funds....
  13. Replies
    4
    Views
    1,632

    Totaline Compressor Core Charge

    South Carolina Mechanical Contractor here, purchased Totaline compressor instead of Carlyle, charged core charge at time of purchase. This was December 17, 2009. Returned core December 23rd. Current...
  14. Replies
    11
    Views
    1,127

    ...proceedures, proceedures, proceedures, special...

    ...proceedures, proceedures, proceedures, special attention to the "clean-up" on this one...yes, lot's of nitrogen...
  15. Replies
    6
    Views
    707

    ...yes, the plate on the condensing unit or the...

    ...yes, the plate on the condensing unit or the color on the txv...
  16. Replies
    5
    Views
    592

    I would vote for just replacing the duct...

    I would vote for just replacing the duct systems/plenums. Please ensure outside air though....agree on just a 2" filter also...
  17. Replies
    22
    Views
    1,264

    ...and facing reality, there are times that...

    ...and facing reality, there are times that troubleshooting in foul weather has to be done. Some accounts cannot be put off till the next nice day. Not trying to be silly but I keep a roll out...
  18. Replies
    10
    Views
    1,397

    Cool....let me know about a week in advance and...

    Cool....let me know about a week in advance and I'll put you in touch with the guy. In the Charleston/Columbia area here.....
  19. Replies
    10
    Views
    1,397

    ...when are you going that way? I have a real...

    ...when are you going that way? I have a real good contact in Alabama that can help you out......
  20. Replies
    8
    Views
    1,064

    ...you sure this guy isn't a relative? Or he...

    ...you sure this guy isn't a relative? Or he could be the Steven Hawking of the HVAC world........LOL
  21. Replies
    28
    Views
    2,887

    ...as a matter of fact I have, 2nd quarter profit...

    ...as a matter of fact I have, 2nd quarter profit rose 27% as a company, worldwide Key word there..."worldwide". Thanks to Clinton and the NAFTA thing. Building efficiency rose 11%, 3.3 billion in...
  22. Replies
    28
    Views
    2,887

    Might want to dig a little deeper on that and...

    Might want to dig a little deeper on that and investigate the automotive aspects of JCI, interiors, Interstate batteries, etc...and the profit margin of each. Not knocking JCI of course. Don't think...
  23. Replies
    18
    Views
    2,222

    I agree with cobra....sounds like cracker is...

    I agree with cobra....sounds like cracker is unhappy in his choice of locations. Properly trained and commited to proceedure techs should be able to find work just about anywhere....Not to mention,...
  24. Replies
    12
    Views
    1,435

    Yes...atmospherics, if the vent is...

    Yes...atmospherics, if the vent is "active"...Houston, we have a problem! Mostly semi-hermetics, though. As far as refrigeration...Gee, where do I start...guess I can just about run the entire...
  25. Replies
    43
    Views
    5,749

    Yes....you're the right Accu-temp. I think AAA...

    Yes....you're the right Accu-temp. I think AAA absorbed an outfit out of Plymouth, pretty good deal from what I can remember...as far as the "other" company, are they really competition?? Hope ya'll...
Results 1 to 25 of 172
Page 1 of 7 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event