Search:

Unless size limitations require it, ie short basement with a short plenum may need a newer shorter furnace to allow for proper airflow through the newer more efficient TALLER coils.

i heard they were Mercedes, could be wrong

Sounds to me like you may need to get used to the new system, but.... I had a unit I replaced the autumn, and the new unit did make more noise than the old, both induced, different manufacturers,...

Boiler was designed so as not require pri/sec piping, from manuf meeting, never used the Quantum. Not sure what you're trying to accomplish, maintain boiler temp?

WNY 1.78/therm on last bill

When he sees the $ he may want to reconsider

Actually, looking at fabric ducts.

Yea actually looking at the Modine DFS unit. Looks like what should be used.

Ok got Dectron on the case designing dehumidifacation system, I will need extra spac heating, looking at Reznor EEDU. This will be in mechanical room, will there problems with chlorine gasses within...

just ask for them. Actually about a month ago I did an installation for a deaf/mute. Did alot of writing, and her vocabulary was very limited, didn't understand what efficiency meant. Overall a great...

Nother nod for HW, used Aprilair but like HW

Those numbers look a bit better. My 28 year old, 1400 sq' home in Buffalo, NY heats with a 50,000 btu 90% er and cools nicely with 1 1/2 tons cooling.

Not sure where you're located but in Buffalo NY I measured my incoming water last Jan and had 38*. I'm about 30 miles from intakes on Lake Erie but I would have guessed it would have warmed a bit...

Got a couple buddies who are pro firemen. They too have some of the best stories. Usually ends with my gut hurting

FICTION

-1 F winter, 87 F summer

[Edited by jonm on 12-10-2005 at 03:40 PM]

Ask the builder the differences in an Energy star home and a normal code built home. Here in WNY the building codes are very close to the Energy Star codes. Duct work needs to be sealed by code here...

Same equipment except for Tempstar TCA slope top AC as Loonie states. Airquest is probably the Heil line. At least at one of my distributers that is the way it is. Though Tempstar and heil are the...

Both seem a bit big. Won't know till a load calculation is done. As everyone stated, insulation and envelope tightness need to be addressed. I'm in the area and if I can be of assistance I'd be glad...

I'm a Tempstar dealer, same as Heil and am partial to them. Sizing is one the more important issues, Have a load calc done. I'm not sure where you're located. I live in the Buffalo NY area so we do...

I believe the Dunkirk Q95 is going to be discontinued. The new Quantum 90 will be modulating and be direct competetion for the Weil-Mclain Ultra. And if I remember correct the Dunkirk will be the...

Dunkirk will be coming out with their fully modulating condensating boiler the 1st of the year.

Check your air filter.

Not sure where you're located and at what your design high temps are but it sounds like you might have an oversized system. short cycles and high indoor humidity are classic symptoms of an oversized...

January 23, 2006.