Search:

Hi,

In over 15yrs in this field, this is only the 2nd home I've seen like this: an old 50yr old furnace, 2000sq ft. home, 100,000BTU's, belt drive blower, and every room has 4" ducts going to it...

Bet you cant find a boot like this

"when you said it's crooked,did you mean my ductwork? or your teeth?"

" I heard the last time you had a piece off ass was when your finger went through the toilet paper"

check this out220712

I'd fire his ass, cuz if he's doing sloppy, lazy work habits, just think what else he may be doing to cut corners

I don't care for no pro status, I just want an opinion. The furnace is working fine now. FYI, this isn't a DIY install.

I installed a high effic Carrier furnace, did all my flue, condensate drain, and re-tubing/configuration for horizontal right.

When starting it up, I get an error code, 3 flashes which says -...

when shoving it up a chimney. I think building codes require that if its a new install it must be a sealed/new flue?

I have this project: a 3 story building w/ 3 console heaters, currently vented through chimney. Owner is concerned about the way it's currently vented, a 3 inch pipe just shoved a few inches through...

No I am not a hack. I sold the homeowner 2 furnaces at 2 other properties already, but w/ this particular unit he just wants the ductwork replaced. So again the question is can I use wireflex duct...

Hi,

I have one of those old old green monster gravity furnaces w/ asbestos ductwork. The homeowner is going to remove all the asbestos and leave the boots intact and a 12" section at the furnace...

This is a second story building w/ thick ass brick walls. Because the client is on a budget, they decided to go w/ about 6 regular ceiling fans (the propellor type). Not the best solution, but easy...

OK, I have this client w/ a commericial building 150 ft x 35 ft x 15 ft ceilings. There is a small window on each end of building, but not enough for any ventilation. It gets quite stuffy in there...