Search:

Type: Posts; User: kimosobee

Page 1 of 6 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: Need Advise

    by kimosobee
    Replies
    22
    Views
    847

    Is this your own job or do you work for a...

    Is this your own job or do you work for a company, I can't imagine a company would send you out on RTU with no experience,just curious!
  2. Thread: Need Advise

    by kimosobee
    Replies
    22
    Views
    847

    how old is unit, Do you own a sniffer, if not i...

    how old is unit, Do you own a sniffer, if not i would put at least 200 # OF NITROGEN Coil is probably rated for 300#Use some Big Mike it's blue in color It's used for micro leaks spray all the end...
  3. Thread: Need Advise

    by kimosobee
    Replies
    22
    Views
    847

    Look for oil deposits most rooftops t he older...

    Look for oil deposits most rooftops t he older ones run on R-22.It won't be a puddle. With zero readings the unit sounds totally empty ! How long has it not been running? Even not running it should...
  4. Replies
    21
    Views
    1,160

    Very good point joemach

    Very good point joemach
  5. Replies
    28
    Views
    976

    You need to call a reputable service company and...

    You need to call a reputable service company and quit guessing about whats wrong! Who put r-22 in the unit how did you determine it needed gas. How old is unit? The guy who put r-22 in should have a...
  6. Replies
    21
    Views
    1,160

    The majority of guys I see on the street use...

    The majority of guys I see on the street use Oxy/Acetylene,It seemed like the guy I seen using it spent a very long time brazing a lineset ,if he used Oxy/acetylene that long he would have destroyed...
  7. Replies
    21
    Views
    1,160

    Acetalyne or Oxy/Acetelyne

    I'm curious of the upsides and the downsides of brazing with just acetylene, compared to brazing with oxygen and acetylene. Any and all input greatly appreciated! Thanks in advance for whatever input...
  8. Replies
    44
    Views
    2,483

    I purchased an H-10g 2 years ago because on the...

    I purchased an H-10g 2 years ago because on the leak I had that was inside a cinder block wall, property owner was adamant that that I was wrong! After showing up with the h10 which I didn't want to...
  9. I only asked because on occasion I've seen it...

    I only asked because on occasion I've seen it here on service calls! I'm i n Michigan. I have never used CPVC for a drain The I D is way to small for todays equipment. This unit was 27 year old coil...
  10. Replies
    12
    Views
    963

    Is this a condensing furnace or 80% or less

    Is this a condensing furnace or 80% or less
  11. Replies
    16
    Views
    992

    If I was doing my own house I would use metal ,...

    If I was doing my own house I would use metal , labor intensive but if sized correctly and insulated with R8 or better. There is going to be less restriction with metal.
  12. Replies
    10
    Views
    758

    I agree with Gravity, if I had to pick I say...

    I agree with Gravity, if I had to pick I say pressure switch,did you make sure hoses are clear of obstructions?
  13. Replies
    12
    Views
    1,417

    Is this a honeywell smart valve with the 3 wire...

    Is this a honeywell smart valve with the 3 wire pilot assembly?
  14. Sounds like silicone is the product to use if...

    Sounds like silicone is the product to use if your putting in new, I never use tape unless trying to seal existing air leak
  15. Are you using 3/4" pvc condensate line for drain...

    Are you using 3/4" pvc condensate line for drain and not CPVC ?
  16. I also tell customers to use soapy bleach water...

    I also tell customers to use soapy bleach water into the condensate every season especially in A/C traps when furnace i isn't 90+ efficiency. If it was 80% furnace the condensate trap sets 8 or 9...
  17. Replies
    11
    Views
    1,086

    I would like to thank you guys for all of your...

    I would like to thank you guys for all of your input> Customer is going with Sensit P100 CO
  18. Replies
    11
    Views
    1,086

    I thank you for your advice but do you or...

    I thank you for your advice but do you or somebody you know own this unit? I'll check it out Thanks for the lead!
  19. Replies
    11
    Views
    1,086

    Personal C O Detector

    I am looking for a low level C O detector for a customer of mine for her to attach to her physical self. She travels alot and likes the idea being able to check the C O levels of her environment...
  20. Replies
    7
    Views
    444

    I stand corrected, Thanks for your input also! We...

    I stand corrected, Thanks for your input also! We can put my curiosity to rest now.
  21. Replies
    7
    Views
    444

    Thanks for your input Ryan it's exactly what I...

    Thanks for your input Ryan it's exactly what I was trying to find out. It seems to me that the older equipment was built to last .Not like today!
  22. Replies
    7
    Views
    444

    Hermetic or schroll

    Are there any single phase hermetic compressors still being used in residential,light commercial condensers in the market today? If so what brands are they? All input appreciated , Thanks in advance...
  23. I couldn't see the calcs, what I do know is if...

    I couldn't see the calcs, what I do know is if you have a second floor on this house and a basement where the furnace will be tell your contractor to use 7" wall stack for the supply runs upstairs....
  24. Anything made in the early 60's , 70' was...

    Anything made in the early 60's , 70' was probably made in america. there use to be quality in manufacturing and workmanship. I don't know when we switched to a disposable nation! for instance...
  25. Replies
    69
    Views
    27,063

    Sticky: Welcome Aboard , A lot of information available...

    Welcome Aboard , A lot of information available once you make pro status!
Results 1 to 25 of 144
Page 1 of 6 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event