Zonex controls they are a division of California economizer I've done some work on them need a computer program to get into changing the set points and various other setting most I've seen is only a...
Type: Posts; User: tkhvacguy
Zonex controls they are a division of California economizer I've done some work on them need a computer program to get into changing the set points and various other setting most I've seen is only a...
Company I work for used to use it really couldn't complain much but company recently bought all of the techs the testo 310 with printer nice analyzer a little more pricey but worth it IMO
Sent...
Frigidaire FG6RA072C-12A
Sent from my iPhone using Tapatalk
Jesjen I have always looked at it like this, and also been told when I first started in the field and have always felt it is right but how it has been explained to me is you don't want to use any...
Glenn thanks for the reply I have spoke with tech support they pretty much said I'm on my own I do believe that it is something in the air just not sure what it is or how do cure it but I wanted to...
Gas pressure is 3.48 " wc
That's a good point I do believe its a fiberglass tile not only that bit it's got the pink rolls of insulation right above it I could very well be getting insulation on it ill have to check it out...
Looks spotless
Cleaned it with a steel brush
Thanks everyone for the replies this is a residential furnace 80 percent however it is installed in a dry clean drop off building meaning clothes are dropped off at this building the clothes are then...
Had a no heat call today on a system I was at a month ago for regular maintenance and found today that the flame sensor was dirty I was reading .2 ua so I cleaned the flame sensor check my ua and it...
Yes used my manometer to get the pressure draw on the pressure switch
I had a older Lennox unit doing the same thing a couple weeks ago what I found was a weak inducer motor that when the burners light up would cause the pressure switch to open briefly but never did...
This is the Ask Our Pro's forum. In order to post a response here, you must have verified qualifications and have been approved by the AOP Committee. You may ask a question by starting a new thread....