Search:

Type: Posts; User: joebrisbin

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    998

    Dilbert, Your current unit is 100kBTU and 60%...

    Dilbert,

    Your current unit is 100kBTU and 60% so you are getting approximately 60kBTU out of the existing unit.

    If you upgrade to a 90% then you will be increasing your current efficiency by...
  2. Replies
    13
    Views
    2,088

    For me and the other non HVAC folk, What is DSS...

    For me and the other non HVAC folk,
    What is DSS ?

    Thank you.
  3. Replies
    200
    Views
    13,434

    NormChris, Here is the instructions to post...

    NormChris,

    Here is the instructions to post pictures on this web site
    just follow this link:
    http://www.hvac-talk.com/vbb/showthread.php?threadid=22507

    We are all looking forward to see them!...
  4. Replies
    200
    Views
    13,434

    Man, the smoke is now clearing. It is obvious...

    Man, the smoke is now clearing. It is obvious that nitro purge is required by many manufacturers including Trane.

    Yes I want my new AC and heater to last a long time!!

    My wife asked one of the...
  5. Replies
    200
    Views
    13,434

    They added one collar joint in the lines where...

    They added one collar joint in the lines where they come up through the floor. So there are 4 joints on each line, one at each end and 2 for the collar.
    I think a liquid line dryer comes already...
  6. Replies
    200
    Views
    13,434

    Thanks Coolwhip, I know I will be fine. But how...

    Thanks Coolwhip,
    I know I will be fine. But how about the equipment?
    Just kidding... Thanks for the reply.
  7. Replies
    200
    Views
    13,434

    Thanks Irascible, The rods they used came out...

    Thanks Irascible,

    The rods they used came out of a plastic tube.
    The rods looked like stiff solder. So maybe they actually soldered and did not braze after all.

    Now that you mention it, they...
  8. Replies
    200
    Views
    13,434

    I saw in several posts about flowing nitrogen...

    I saw in several posts about flowing nitrogen while brazing.
    My Trane 19i was installed last week and I did not see either of the installers using nitrogen when they were brazing.
    I think that this...
  9. Replies
    11
    Views
    1,044

    You are right. I don't need to know how to...

    You are right. I don't need to know how to measure the ESP but I want to make sure the installer measures it. My wife is at the install site and not me.
    This is at her folks house and the three of...
  10. Replies
    11
    Views
    1,044

    These ducts are in the attic. The roof slopes...

    These ducts are in the attic. The roof slopes down and there is not much working space where the top of the AC coil at 93 1/2 inches off the floor.

    My wife is at the house with the installer right...
  11. Replies
    11
    Views
    1,044

    The secretary of the installers did not know what...

    The secretary of the installers did not know what I meant by a fan chart.

    Is this fan chart the one that is in the installation manual or is this some diagnostic chart that the installers have...
  12. Replies
    11
    Views
    1,044

    Thanks Dash, I really appreciate your reply....

    Thanks Dash,

    I really appreciate your reply.
    I will ask them for what you suggest.

    It sounds like you completely understood my convoluted question!!!

    THANK YOU!!
  13. Replies
    11
    Views
    1,044

    My parents furnace and AC install was started...

    My parents furnace and AC install was started last week and will be finished tomorrow (connect the freon lines and install the roof vent pipes). It took longer than the installers planned because the...
  14. Replies
    22
    Views
    2,304

    Amickracing... To make the venting simple, how...

    Amickracing...

    To make the venting simple, how about using a concentric vent. This is only one vent hole in the roof with 2 PVCs one inside the other. This is what I am having installed in a...
  15. Replies
    4
    Views
    613

    Yes. That's it. My wife and I both spoke to Trane...

    Yes. That's it. My wife and I both spoke to Trane reps and we were told: Putting a 19i 8 inches from the wall is not a problem and there will be no noticable change in SEER. But one of them also...
  16. Replies
    4
    Views
    613

    I am having a Trane 19i 4 ton AC installed at the...

    I am having a Trane 19i 4 ton AC installed at the south side of my in-laws house. The system will also have a Trane 100kBTU XV90 and a 5inch media filter. The model of the coil is hard to read on...
  17. Replies
    11
    Views
    1,509

    Thanks Jeep, I will make sure he puts the pipe...

    Thanks Jeep,
    I will make sure he puts the pipe in the existing roof vent hole instead of through the wall where the dryer vents.

    Thanks for the inputs.
    JB
  18. Replies
    11
    Views
    1,509

    I searched the web for "concentric vent" and...

    I searched the web for "concentric vent" and found a couple of different styles. One was a box that COMBINED both pipes into one common pipe (not a wise choice). The other looked good, one pipe...
  19. Replies
    11
    Views
    1,509

    Thanks guys. I will ask my installer for a...

    Thanks guys. I will ask my installer for a concentric kit.
    The comments about do not use laundry room air make a lot of sense! We want this unit to last a long time.
    THANKS FOR ALL THE ADVISE!!! We...
  20. Replies
    11
    Views
    1,509

    I am not familiar with a concentric kit. Does...

    I am not familiar with a concentric kit. Does that mean having two PVC pipes going through one flue hole in the roof?
  21. Replies
    11
    Views
    1,509

    The house is in Lafayette, CA. It is single story...

    The house is in Lafayette, CA. It is single story about 2200 sq ft, 50 years old with alot of windows (thin single pane) and no wall insullation.
    The existing furnace is 135 intake / 108 output....
  22. Replies
    11
    Views
    1,509

    I am having a Trane XV90 TUY100R9V4W installed to...

    I am having a Trane XV90 TUY100R9V4W installed to replace an old gas furnace at my mother-in-laws house. The new furnace will be installed in an un-airconditioned laundry room at one end of the...
Results 1 to 22 of 22
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event