Search:

There are no stoppers. This particular damper has only two setscrews the lock the shaft in.
There are these 45deg and 60deg pins that can be installed into the damper motor, optional purchase,...

Anyone familiar with redlink mard8 vav.? I'm having problems with air leakage or bypassing damper blade in the 100% closed or "off zone" period. It's enough to overcool the space in a couple rooms...

Sounds like h10 is a winner! No complaints yet from anyone

Is the battery one just as good as the plug in version?


Looking into this h10 too, but need some pros and cons of which to get.

I setup a conference call with him to run through setup with my client
He was very helpful.

Thx anyway chuck, been there done that, called west region network tech today. He explained its too technical to explain over the phone and he agreed that their manuals are very thorough and...

anyone familiar with the setup of the gb50 centralized controller?
could anyone breakdown the setup and network initial settings for me? setting up email error and online maintenance ?

Thx nucl

No one work with techview?
Anyone?

Anyone with trane techview experience? I don't work for trane, but we use techview as a service tool to check control operations, logged chiller data.
I want to create log sheets directly from tv. ...

How about split case pump bearings?

At what temperature does bearing failure occur at?

Thx all, I used the manual, there is a set of Ohm readings that must be read to confirm proper operations

Anyone ever worked with tracer es? Have any comments?

is this similar to tracer es :sev. pk 1??

Someone had to of worked on this unit. Please help

Pefy p36 nmhu e
I found the Lev coil faulty and needs to be replaced.

Does anyone know if it can be replaced by accessing the side triangular panel? Or only through the bottom access panel?

Thx controldude!

Trane m#: Tch480a4oroa6kc5a
How should the dip switches be setup on the rtam board.
I would like to eliminate the ecomomizer from being used if possible.

Thanks davem

Here's the part
http://www.honeywellparts.com/4074eny-actuator-accessory-3-8.html

Now the actuator
http://www.amazon.com/gp/aw/d/B003CVV5SA/ref=redir_mdp_mobile

Any thoughts???

Digo its weird bc when you look online, the picture they show is a 90 degree angle piece of metal. Doesn't look anything like the slot on the actuator where your supposed to insert.

Thx all

anyone know how to go abot installing????

ML6161b2024 does anyone know how to keep.damper from opening up 100%, ?????I would like to make the max open at about 40-50% open instead of 100%.

Part #: 4074enj. Is that what it is used for???