Search:

Type: Posts; User: Core_d

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    44
    Views
    1,315

    No but static pressure should be done and...

    No but static pressure should be done and recorded on a start up as well as circling all settings on stat and control board. That would be nice:-)
  2. Thread: Goodman

    by Core_d
    Replies
    29
    Views
    1,434

    Sexy ducting....

    Sexy ducting....
  3. Replies
    14
    Views
    1,253

    Wat is cop @ 15 degrees? Looks good btw

    Wat is cop @ 15 degrees? Looks good btw
  4. Replies
    13
    Views
    732

    Could be, put your meter across a limit switch...

    Could be, put your meter across a limit switch and see what it does.
  5. Replies
    13
    Views
    732

    Ways a negative ohm?

    Ways a negative ohm?
  6. Thread: impact driver?

    by Core_d
    Replies
    37
    Views
    1,640

    I'm do m12 too. I like it

    I'm do m12 too. I like it
  7. Thread: D-tek vs H-10.

    by Core_d
    Replies
    73
    Views
    8,954

    I got an h10 and always find my leeks except on...

    I got an h10 and always find my leeks except on fridges with insulation that throws you off
  8. You beat me to it:)

    You beat me to it:)
  9. A breaker too. Its a fail safe they are special...

    A breaker too. Its a fail safe they are special but thank you for the reminder. Soooo many systems cycle on high limit. I will start quoting replacment . any literature would be helpful:)
  10. Replies
    23
    Views
    1,003

    Unless you take every thing apart and do a CA

    Unless you take every thing apart and do a CA
  11. Replies
    23
    Views
    1,003

    Yes it does your sucking way too much:) most...

    Yes it does your sucking way too much:) most sealed combustion chambers require you adjust gas pressure with a seals chamber as the valve is relative to those conditions. Most folks don't tee their...
  12. Replies
    23
    Views
    1,003

    Does the manufacturer mention co? 100 ppm is rule...

    Does the manufacturer mention co? 100 ppm is rule of thumb. I've seen some literature call no more then 30 after 10 min runtime. I'm hardly an expert.... And just happy when the damn thing heats.....
  13. Replies
    23
    Views
    1,003

    Wat is the effenciecy compared to rating? Your...

    Wat is the effenciecy compared to rating? Your sucking too much idea guess... Stick a pipe out and put a couple 90s on it if your drawing from the room. That should help.....
  14. Replies
    29
    Views
    1,402

    I could figure it out at their expense lol. Wat...

    I could figure it out at their expense lol. Wat a mess
  15. Replies
    841
    Views
    191,086

    I had lol warranty company that installed a...

    I had lol warranty company that installed a sequencer to the heat-speed to bypass a board.
  16. Replies
    12
    Views
    602

    haven't got it to work yet though.... lol. I have...

    haven't got it to work yet though.... lol. I have the fp wireless amp clamp. I don't always use it but it seems to work good. Great for actual amp drawls with blower door in place.... (Note) I've...
  17. Replies
    841
    Views
    191,086

    Had an apartment today new stat required a w1-e...

    Had an apartment today new stat required a w1-e jumper in this hook up. Got it squared away after they replaced the heat kit.... Oopsy had some folks forget the r\c jumper as well. They get mad when...
  18. Replies
    31
    Views
    3,493

    Cool pic

    Cool pic
  19. Replies
    25
    Views
    690

    Manufacturers want you to recover and weigh per...

    Manufacturers want you to recover and weigh per specs, if I have info....trane is good about it and have seen it for Lennox, they will give you low/high pressures based on outdoor indoor temp.
    ...
  20. Replies
    6
    Views
    370

    Sounds good take a switch with you if you can....

    Sounds good take a switch with you if you can. Ide prolly unhook the outdoor unit and put it in cooling and look at static\blower performance. Is it variable speed? Has it been a problem child? ...
  21. Replies
    15
    Views
    962

    That's live action boys lol idea have subbed that...

    That's live action boys lol idea have subbed that one out to turtle man...
  22. Replies
    6
    Views
    370

    What is static equate to on the blower...

    What is static equate to on the blower performance chart and what is your temperature rise? Removing the limit and checking actual temp compared to the other side could be helpful as well...
  23. Replies
    7
    Views
    493

    You got a steal alright,, leave the bastard a...

    You got a steal alright,, leave the bastard a message and leave him alone lol
  24. Thread: Bad Gas Valve?

    by Core_d
    Replies
    8
    Views
    626

    That's the thing of the job I hate, not your...

    That's the thing of the job I hate, not your fault and the customer will always doubt you. I changed an obviously failed inducer on an 8 year old system just to find an obvious failed heat exchanger....
  25. Replies
    36
    Views
    3,179

    Did you mean to post in wop, has this thing been...

    Did you mean to post in wop, has this thing been jimmyed;D jk
  26. Replies
    36
    Views
    3,179

    What is that bahaaa?

    What is that bahaaa?
  27. Rip all that stuff out and put a wall switch and...

    Rip all that stuff out and put a wall switch and a fan limit on it:P
  28. Replies
    3
    Views
    233

    You must mean stack limit?

    You must mean stack limit?
  29. I'm guessing the thermometer just displays...

    I'm guessing the thermometer just displays temperature and no image.
  30. Just got back from a new xv unit tripping...

    Just got back from a new xv unit tripping breaker. 3zones and somethings very wrong lol. Narrowed it down to only tripping with aux heat so locked aux out "till tommow"

    I noticed till tommow is...
  31. I did work for a place the would not swap a coil...

    I did work for a place the would not swap a coil out of warranty, a select few customers had an exception. If your flat rate changing a coil is seldom a good choice. A few you young Bryant's are the...
  32. I quote a repair and tell em to replace, how does...

    I quote a repair and tell em to replace, how does one have another choice? And I agree 100% caps and leaks. Not sure about heating season see all kinds of stuff- glow flys and inducers probably
  33. Replies
    35
    Views
    3,102

    Same here

    Same here
  34. Thread: FP hg3

    by Core_d
    Replies
    1
    Views
    194

    No one I guess? If you guys don't need it I sure...

    No one I guess? If you guys don't need it I sure dont
  35. Thread: FP hg3

    by Core_d
    Replies
    1
    Views
    194

    FP hg3

    I've collected a few of the wireless devices over the last year. I'm pretty much all basments and backyards around here, a few craws and attics. Thus far I have the spd2 and 1 transmitter with the...
  36. Sounds broke:couchhide:

    Sounds broke:couchhide:
  37. Replies
    18
    Views
    955

    :oThat wasnt on the nate test

    :oThat wasnt on the nate test
  38. Replies
    72
    Views
    3,712

    Yes it does cause phantom shorts. The breaker...

    Yes it does cause phantom shorts. The breaker will open due to heat caused by a poor connection.
  39. Replies
    72
    Views
    3,712

    T Dont do that.

    T
    Dont do that.
  40. Replies
    182
    Views
    10,008

    That the route i took after the low side started...

    That the route i took after the low side started leaking over to the charging port. With as many turns as it takes with the titans i doubt ill be leaking again :)
  41. Replies
    182
    Views
    10,008

    Enough chit chat already hit the record button...

    Enough chit chat already hit the record button and show me what you do when a pressure switch(heating)opens every 15 or 20 minutes. :)
  42. Replies
    24
    Views
    3,370

    This used to be a wholsome place ��

    This used to be a wholsome place ��
  43. Thread: Charging

    by Core_d
    Replies
    89
    Views
    4,067

    Thats a good sumup

    Thats a good sumup
  44. Thread: Charging

    by Core_d
    Replies
    89
    Views
    4,067

    Charging to 20* temp drop is bad mm k

    Charging to 20* temp drop is bad mm k
  45. Replies
    99
    Views
    10,062

    If you valve that off and get it in a vacuum the...

    If you valve that off and get it in a vacuum the night before you dont even need a pump:)
  46. Replies
    16
    Views
    1,059

    Maybe so, good call

    Maybe so, good call
  47. Replies
    99
    Views
    10,062

    Why did yellow jacket give me a big yellow hose...

    Why did yellow jacket give me a big yellow hose with my new 4 valve manifold? Just too cheap to give me a black hose?
  48. Replies
    47
    Views
    2,068

    But if blue is rv then what is common white? If...

    But if blue is rv then what is common white? If white ir common red sould be Y and if Y is red what is hot yellow?
  49. Replies
    22
    Views
    1,278

    Good thread thanks for starting. You are a good...

    Good thread thanks for starting. You are a good employee that cares about his job. From across the interweb I can tell that you are doing fine. Your to new to be fast and to young to be slow... So...
  50. Replies
    8
    Views
    484

    Seems general enough to me

    Seems general enough to me
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365