Type: Posts; User: amrik
can any one explain combination unit water heater and space heater
can anyone explain radiant sensor in cloth dryer
overfeeding refrigerant or overcharged.if overfeeding head pressure willbe slightly lower than normal.if overcharged head pressure can be sky high 5-10 superheat overfeeding or overcharged.
thanx for ur kind reply i realy appriciate.
some body installed a new ac at my friends home. he says not cooling and air flow is less. one of my friend is hvac tecnician he checked . he said furnace is lowboy and motor is with less...
i observed that condenser fan motor is heat up. comp is trying to start. is fan motor burnt ?
actually i got this question in cfq air/ref. four wire with 115v in three phase motor how to reverse i know that reverse phase wires. but exam answer is potential relay
thanx for advice
every body gives the advice not the solution
thank for ur kindness
sharing knowledge makes u more perfect
i need help from good experence people like u.
for walk in freezer if door gasket vacuum broken what will happen?
open the door difficult, thickness of eva frost , excess run which one is correct
what is the clearance for headroom.floor 9in x 50in and pipe diameter 4in
35in 44in 39in or 42in which one is correct
what comes first fan or pump in evaporator condeser?
pump comes first, than fan comes and condenser temp increase and pump stop.
pump comes first. than fan comes and condenser temp...
how to check the diagnose on microprocess board prograam
how to indicate the rotation of compressor?
1.non balaance TEV when incresing condenser outletpressure?
2. when the spring of a tev loose what happened?
thanx buddy for suggestion ur experience help me
is it phase meter?
i dont have answer to this because i dont have expierence on this somebody told me it is exam question
a three phase motor with four wire with 120v. how i can reverse its rotation ?
1.what procedure do you adopt when repair malfuntion one of the multiple evaporator fan ?
2.multi evaporator system how to repair one evaporator?
3. what do you want to do if you fail a fluctuation...
when a refrigeration system has flood, what has phenomenon?
high suction or low
for a multi-evaporator system, what'sthe procedure to repair one evaporator ?
while brazing to prevent oxide by sweeping inert gas , when the pressure is too high what happened ?
1.small hole on the connection.
2.the melted brazing alloy is blown out of the connection.