Search:

Schneider Electric. (APC)
The best in my opinion, but I may be a bit biased.

http://www.apc.com/products/category.cfm?id=9

I guess my first question is why 100% OSA? What benefit are they trying to achieve with that many changes?

Temperature is not going to be too hard to maintain, especially with the higher ASHRAE...

888-685-6500

Thats will get you the tech support folks from who support the airflow and APC cooling product line.

They will help you

888-695-6500 will get you to APC tech support and they can walk you through the set up.

There is a terminal block in a 4x6 junction box next to the controller. Terminals 1,2 and 3 are your dry...

That board is no longer available but you can buy an upgrade kit.

888-695-6500 is the number you need to call

My advise is go get the water tested. Our tech support will be more than happy to provide the heat ex water requirements. Stay within what they are designed for and everything is going to be fine.
...

THX thats kind of what I thought just wanted to make sure my bases were covered.

Guys,
I am getting quotes for a new heat pump installation and I have some questions on carrier's warranty. I am looking at the Infinity dual stage system and I am getting different opinions of what...

APC, Liebert, Stultz, DataAir, Canatel.... all designed for a specific need. What you suggest is great for people cooling. Not for process cooling

What do you want to know? I guess you can figure out my opinion on the APC units

Are you talking reducing at the header or for the vertical?

APC purchased Airflow back in 2000

you have a 10 ton DX there

I would double check the pipe supports as well as the run. The more 90's that you have on a discharge line the possibility for noise increases. rubber mounts and a discharge muffler will help. Also...

Jeff,

Let me throw my 2 cents in here.. Look no further than RI and APC. There are many options to choose from out there but the only 2 names you need are APC / MGE and Liebert. If you are going...

Typical Datacenters humidity levels should be at 40-50% RH. Perimeter cooling units are designed to work within that environment. If you look at any manufactures spec sheets you will see that the...

What does the space look like and how did you come up with 2 tons of cooling? What kind of servers are you running and are they housed in a rack? What does the ceiling space above look like?

Here...

every manufacture has their fair share of issues. One thing APC is doing is investing more time and energy to the inrow product line. We have some new stuff that blows the doors of the old school way...

What BTU are you planning for this little room?

Check out APC / Products.. we can match equipment to just about anything.

One option is the SC below. Depending on what the space above the...

APC purchased Airflow back in 2001. The tech support numbers are still the same,

888-695-6500

Let me know what you are looking for and I'll help out. Started out with Airflow a long time ago

at the display hold down alarm history / blank screen / help. That will take you past the password into the config screen.. you can see and then change the pasword on page 2.

And the tech support...

Zerocool, I did find out some new information on this site and the duct work design. Now I am not saying I am an expert in dust design but from what I was told. It sounds like the units 67x29 filter...

Zero-cool,

Where is this unit and whats the serial number?

serverroom,
I have 2 companies that you can call..... email me and I will give you their contact information. Mike.clemence@apcc.com
And I'm sure you know my opinion on Datair

serverroom,
I must of read into "the dinner bell is ringing" too much. I thought that you were ready to go with one of our units. (that is what puts the food on my table) let me see if we have any...

serverroom,
sorry I haven't been here in a while. I've been flying all over the country.. I hear the dinner bell and I see that liebert word alot on these past pages. Now I will admit that I have...