Search:

Thank You So Much Have A Great Day

Have not worked on many 410a systems,Need to know if you can use a swival tee or is this a no no?And can you use flare fittingsin the high /low lines.have to install a water regulator,Johnson V246,No...

Does anyone out there have the compressor Torque specs and clearances on a york ZB4K1 compressor? Thanks

Have a 2850 sf 3 year old house,Installed a 9 gal per day true steam Humidifier,started up ,Running now for 3 weeks .Humidistat set at 40% can only get house to 32% out side temp between 10 and...

Hi
had a situation ,pulled vac on centrifugal [no R11 in system]pulled down to 26 in ".Used 3 vac pumps.felt presure comming out of pumps,isolated pumps turned off pumps ,let sit ,had thermal...

Has Anyone come acoss a bad suction accumulator? Not sure what can go wrong,Have a small chiller ,Floading back,low low load ,has accumulator,R22,suction 20lb,low temp compresor discus.Want to know...

Time to buy a Halide

I think I may have a leaking tube in a small chiller ,The water has glycal mix,I was told electronic detectors pick up glycal,is this true? If so what would you use to sniff for R22?



...

What it definition of term - 100*seconds
If entering water temp drops 2* below leaving water temp for more than 100* seconds - indicates loss of water through chiller evap.Thanks

Have a older sanyo split M#ch182 The temp is over shooting set set point [will not shut off]-you can shut unit off and on through remote.but remote will not auto turn off unit at setpoint. you must...

Hay guys I got the manual on machine from york, Cooler -Horizontal,flooded,shell and tube type,distrabution system consisting of -distribution trugh to give uniform distrabution throughout the shell...

Thanks Klove

Does anyone know what the tube supports in the cooler and the condenser are made of are M#YSDCDBS3-CMCS?Thanks

HI GRAHAM
Thank you very much ,That was a wonderfull Explanation.Sounds like that would be the best way to make shure its right.Thanks again

Thanks for the input chillr dude.That helps

Hi graham
Thanks for your inpute!
With out writing a book,I do know about moisture in the system and megging,Im not asking about any clean up issues.Ive cleaned up many systems ! I try to do things...

The oil tested low acidic,and it looks dirty,sight glass is still green.I am megging motors This is a prosses chiller Cant Leave off long,trying to buy time.

Does anyone have steps on changing oil on RTAA 370 air cooled screws-The book does not have info.
Anyone done it out there?Thanks

new member having trouble postin question can you help harley91