Search:

Type: Posts; User: skw83

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    634

    Amana 80% problems

    I went on this furnace 2 times today. Arrived both times to lockout and no diagnostic lights on the board. I reset power and the furnace fires up and runs ok. Homeowner tells me ignitor comes on and...
  2. Replies
    2
    Views
    515

    Sanyo heat pump problems

    I am working on a sanyo mini split heat pump system. Indoor unit is a KHS1271 and the outdoor is a CH1271. I keep getting a SO1 code which is a sensor failure. I have replaced the temp sensor, the...
  3. Replies
    5
    Views
    491

    York Stellar problems

    The burners ignite and stay lit from 10 to 40 seconds at a time. I have cleaned the flame sensor and replace the ignition module but am still having problems. Also have jumped the pressure switch...
  4. Replies
    3
    Views
    409

    I have been installing servicing HVAC equipment...

    I have been installing servicing HVAC equipment for 15 years. This is my second sanyo split install. I just posted on here because of my frustration of getting any help out of sanyo.
  5. Replies
    3
    Views
    409

    Sanyo Unit Headaches

    I installed a sanyo split unit last summer. It has two indoor units and one cond unit. The downstairs unit is fine but the upstairs unit keeps giving me a fault code. I have been on the phone with...
Results 1 to 5 of 5
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event