Type: Posts; User: SteveBelcher
Has anyone ever thought about going intoindustrial air compressor service?
Check with Ga Trane or local 72 when you graduate
I used JB weld on a leaking rupture disc flange on a 19dk chiller it worked fine
Check with Emcor or Jake Marshall
I think I would stay as DDC Technician. Control work is not as hard on your body physically
Install an accurate micron guage it is possible that your low side guage is not reading properly
Carrier does not support Pic 1 controls, if you have another module it may be able to down load the software if you know anybody that has it or the service engineer from carrier that covers your area...
Do not feel bad, I remember I totalled a service van only after 2 weeks on the job.
What is the best gas grill?
Idid it 3 years ago and I do not regret it. I am thinking about going on and getting my BS degree in Business or HVAC from Ferris State. As far as your question about fitting it in the classes are...
I have a Proto Torque Wrench 150 to 600ft lbs for sell 400$ or best offer
get a good one with the ball bearing slides on the drawers it is worth the extra money
You might try applying at Lockheed or Batchelor and Kimball they take care of some data centers
American Hermetics in atlanta ga did sell T frames that is where I got mine