Search:

Type: Posts; User: mldncx1

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Thread: Adapter

    by mldncx1
    Replies
    3
    Views
    241

    Thanks, guys!

    Thanks, guys!
  2. Thread: Adapter

    by mldncx1
    Replies
    3
    Views
    241

    Adapter

    I tried to charge a Napoleon mini-split yesterday and found that my hose would not fit the service valve. What size is it and is there an adapter I can use?
  3. Thread: Nameplate

    by mldncx1
    Replies
    2
    Views
    322

    Thanks!

    Thanks!
  4. Thread: Nameplate

    by mldncx1
    Replies
    2
    Views
    322

    Nameplate

    Where do I find the nameplate on a Waterfurnace Envision model number NSH060A111NEL? I need to know how much r410a to weigh in.
  5. Thread: Wiring diagram

    by mldncx1
    Replies
    2
    Views
    338

    Thanks, rundawg!

    Thanks, rundawg!
  6. Thread: Wiring diagram

    by mldncx1
    Replies
    2
    Views
    338

    Wiring diagram

    Can anyone hook me up with a wiring diagram for a Bryant heat pump, model 633ajx024-b?
  7. Replies
    2
    Views
    351

    Thanks, coolwhip!

    Thanks, coolwhip!
  8. Replies
    2
    Views
    351

    Furnace capacity

    Can anyone tell me the capacity of the furnace in a Carrier 48TFE008 roof top unit? The nameplate has been covered up with the disconnect box.
  9. Replies
    41
    Views
    3,780

    Thanks for all the helpful replies, Guys! I think...

    Thanks for all the helpful replies, Guys! I think I'll just let the board of trustees decide what to do about the cooler.
  10. Replies
    41
    Views
    3,780

    If I put in a new compressor, drier and cap tube,...

    If I put in a new compressor, drier and cap tube, can I put in r134a in place of the original r12 and get the same performance?
  11. Replies
    41
    Views
    3,780

    I had the amp clamp around the start cap wire...

    I had the amp clamp around the start cap wire when I it read 1.2 amps. I didn't think to clamp around the common wire. I'll do that. I checked the start cap MFD. It read out 207 MFD's which was...
  12. Replies
    41
    Views
    3,780

    I'm pulling 1.2 amps for a few seconds, then the...

    I'm pulling 1.2 amps for a few seconds, then the overload trips. The overload resets and the same process starts over. Funny thing, though, is that I'm not hearing a hum. I've ohmed out the...
  13. Replies
    41
    Views
    3,780

    I'll do that when I can remember. I keep...

    I'll do that when I can remember. I keep forgetting.
  14. Replies
    41
    Views
    3,780

    It does have a current relay.

    It does have a current relay.
  15. Replies
    41
    Views
    3,780

    I'm sure it's older than 5 years. Is the age of...

    I'm sure it's older than 5 years. Is the age of the unit printed on the nameplate?

    I did check the start relay by putting a voltmeter on the proper terminals and setting the meter on min/max. It...
  16. Replies
    41
    Views
    3,780

    No, I cleaned the condenser weeks before it quit.

    No, I cleaned the condenser weeks before it quit.
  17. Replies
    41
    Views
    3,780

    I'll make sure it only drops out after it starts.

    I'll make sure it only drops out after it starts.
  18. Replies
    41
    Views
    3,780

    Thanks! I'll give that a try.

    Thanks! I'll give that a try.
  19. Replies
    41
    Views
    3,780

    True GDM-12 soda cooler

    My church has a True GDM-12 soda cooler that has quit working. The compressor will click as if it's going to start, and then, almost immediately it will click again and fail to start. I checked the...
  20. Thread: Start relay

    by mldncx1
    Replies
    3
    Views
    566

    Start relay

    How do y'all select a start relay replacement. The ones I have looked at are rated by volts and pickup minimum and maximum. The one I took out is marked with the Carrier part number, nothing about...
  21. Thread: Puzzled

    by mldncx1
    Replies
    14
    Views
    1,213

    The noise I hear is like the rattling noise you...

    The noise I hear is like the rattling noise you get when you're adding refrigerant as a liquid.
  22. Thread: Puzzled

    by mldncx1
    Replies
    14
    Views
    1,213

    I'll check those measurements tomorrow and get...

    I'll check those measurements tomorrow and get back to you.
  23. Thread: Puzzled

    by mldncx1
    Replies
    14
    Views
    1,213

    Superheat was 2 degrees.

    Superheat was 2 degrees.
  24. Thread: Puzzled

    by mldncx1
    Replies
    14
    Views
    1,213

    I should have mentioned the superheat. It was 2...

    I should have mentioned the superheat. It was 2 degrees. That's why I hesitated to add any refrigerant.
  25. Thread: Puzzled

    by mldncx1
    Replies
    14
    Views
    1,213

    TXV

    Yes, TXV on indoor coil
  26. Thread: Puzzled

    by mldncx1
    Replies
    14
    Views
    1,213

    Puzzled

    I'm dealing with a Bryant heat pump, model 633ajx060-b. The problem is that I'm only getting a 10 degree temp drop across the indoor coil. It's a 410a system. My pressures were 245/160 at a 70 degree...
  27. Replies
    17
    Views
    2,225

    I should have been clearer. This tank would be...

    I should have been clearer. This tank would be used only for scrap refrigerant.
  28. Replies
    17
    Views
    2,225

    Homemade refrigerant recovery cylinder

    Could a used propane grill cylinder be modified to use as a refrigerant recovery cylinder?
  29. Replies
    11
    Views
    908

    The leak is in the coil. I always heard that the...

    The leak is in the coil. I always heard that the copper was too thin to braze.
  30. Replies
    11
    Views
    908

    It's R410A.

    It's R410A.
  31. Replies
    11
    Views
    908

    Year of the outdoor unit is 2002. It's a 12 SEER.

    Year of the outdoor unit is 2002. It's a 12 SEER.
  32. Replies
    11
    Views
    908

    Heat pump outdoor unit compatability

    My church has a heat pump system with a leaking outdoor unit. I'm a former HVAC service tech who has been retired for several years. I would like to replace the unit for the church but I don't know...
  33. Replies
    107
    Views
    10,399

    I'm just posting in order to find this thread...

    I'm just posting in order to find this thread again.
  34. Replies
    31
    Views
    14,326

    Thanks, Sky! I agree with you. I see nothing...

    Thanks, Sky! I agree with you. I see nothing wrong with that practice. I believe the bulk of the responsibility should be on the contractor.
  35. Replies
    31
    Views
    14,326

    Can anyone explain to me the term "bought down...

    Can anyone explain to me the term "bought down the warranty"?
  36. Replies
    31
    Views
    14,326

    What does that mean? The installer "buys down"...

    What does that mean? The installer "buys down" the manufacturers warranty? How does that work?
  37. Thread: Defrost mode

    by mldncx1
    Replies
    3
    Views
    771

    Defrost mode

    I own a Kenmore model 2539668421 refrigerator. It seems to go into defrost mode much more often than it would need to. What determines when it goes into defrost? Time, temp or both? Does anyone have...
  38. Replies
    56
    Views
    4,753

    Please let me in!

    I just realized that I have 14 posts here. So I'm going to take RoBoTeq's advice and let him know how much I admire him and that he's my idol and that is the biggest reason I would like to be...
  39. Replies
    113
    Views
    13,830

    I agree with Mark. When I was in trade school...

    I agree with Mark.

    When I was in trade school I heard a lot of bad things about Goodman. It was referred to as Junktrol.

    But when I got out in the field I found that Goodman equipment had...
  40. Replies
    28
    Views
    2,603

    Great tip!

    Thanks, udarrell, for a helpful tip.
  41. Replies
    28
    Views
    2,603

    I run into the same problem around here. I'm...

    I run into the same problem around here.

    I'm retired but work during the busy season for my old boss doing PM's. When I come up against this I'm stuck between a rock and a hard place.

    On the...
  42. Thread: Compatible?

    by mldncx1
    Replies
    2
    Views
    1,162

    Compatible?

    My brother's church is considering replacing the 25 year old air handler, Ruud model uhqa 1220 t. The heat pump is an Arcoaire, model yj036gb1 only 9 years old. It's a mismatched system that requires...
  43. Replies
    50
    Views
    5,443

    That's an EZ Trap. It has a float switch...

    That's an EZ Trap. It has a float switch installed and wired to shut the system down in case the drain backs up. The red dial looking thing is a cap that can be removed to use the brush that comes...
  44. Replies
    3
    Views
    858

    Thanks!

    That's it. I just hope I can find it again next time on my own.

    Thanks, guys!
  45. Replies
    3
    Views
    858

    Tips and tricks?

    I feel like an idiot. I just looked at "tips and tricks" yesterday and found it quite informative and very entertaining. Today I can't find it. Can someone direct me to it?
  46. Replies
    51
    Views
    4,669

    filter grill

    Return air filter grill seems like the best idea to me. Being sure to remove the filter from the existing filter box.
  47. Replies
    16
    Views
    2,171

    can't see 'um

    I'd love to look at that system, but I can't get the photos to come up. Anyone else having that problem?
  48. Replies
    16
    Views
    2,221

    Yesterday I pumped down the system, blew...

    Yesterday I pumped down the system, blew backwards thru the lineset and ecoil, and inspected the metering pin. I didn't find anything so I pulled a vacuum down to 300 microns and made sure it held...
  49. Replies
    21
    Views
    6,192

    aircooled53, I love the quote at the bottom of...

    aircooled53,

    I love the quote at the bottom of your post! How very true.
  50. Thread: My helper

    by mldncx1
    Replies
    20
    Views
    5,209

    The little gal really looks like she knows what...

    The little gal really looks like she knows what she's doing!

    She belongs in the "Wall of Pride"
Results 1 to 50 of 116
Page 1 of 3 1 2 3

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365