Search:

Type: Posts; User: johnlaroux

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    613

    Datamate Base 3.0 to setup MEC

    Hi there

    Im wanting to setup an MEC in a remote building but I need Datamate base to set it up. I have datamate installed in an old desktop computer, but I need it on my laptop. I dont want to...
  2. Replies
    3
    Views
    420

    Ok problem solved. I was typing in the whole...

    Ok problem solved. I was typing in the whole word Hello when all I needed was the H.

    Its been at least 20 years since I last messed with hyperterminal hooked to a siemens panel.
  3. Replies
    3
    Views
    420

    Installing new MEC 549-616

    Im trying to install a new MEC to replace one thats bad. I try to connect to the new one with datamate to set the baud rate and node to what the bad one is so I can swap them out, but it doesnt...
  4. Replies
    3
    Views
    755

    Thanks for the reply. Is there a booster that...

    Thanks for the reply. Is there a booster that can be put inline to extend the distance as I need to go at least 600 feet. Thanks John
  5. Replies
    3
    Views
    755

    Siemens MEC expansion modules

    I am wondering how many expansion modules I can add to an MEC controller?

    Also how far away can an expansion module be from the MEC?

    I am wanting to mount the expansion modules (one by each...
  6. Replies
    2
    Views
    577

    Solved

    Thanks for the reply. I managed to find the old computer laying around that had the 3.7 Insight on it and found Datamate base on it so I used it to address the TEC on the desk top computer then...
  7. Replies
    2
    Views
    577

    Siemens TEC problem

    Ok I have a TEC controlling a VP's office and the CFM point is failed so the damper is no longer operating. Ive tried resetting the TEC, removed air sensing lines and made sure they arent plugged,...
  8. Replies
    6
    Views
    934

    Thanks Shiffer that works very well. When I...

    Thanks Shiffer that works very well.

    When I came to this building they just had all the TEC Room temp points on one page (about 60 TEC's) and you had to look up the room with the problem on a...
  9. Replies
    6
    Views
    934

    Thanks Willy: I guess I could put the room...

    Thanks Willy:

    I guess I could put the room temp points on the cad of the room layout where the temp sensors are located and just display the temp units on the info block to keep the size as small...
  10. Replies
    6
    Views
    934

    Thanks Willy: I guess I could put the room...

    Thanks Willy:

    I guess I could put the room temp points on the cad of the room layout where the temp sensors are located and just display the temp units on the info block to keep the size as small...
  11. Replies
    6
    Views
    934

    Siemens insight 3.2 Graphics question

    Im trying to create a link to a TEC graphic. I can make links to standard graphics all day long but it doesnt seem possible to make a link to a TEC graphic.

    I have a graphic of all the room...
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event