Search:

:ditto:

Crazy. We had the exact same thing happen this week at a McDonald's location.

solenoid?

the timer is really small, but there is also a low pressure initiate switch that makes in order to activate the timer sequence on some models. If that were bad, or the timer, you would get the...

if it's unable to reach a specific humidity level, it will cycle cooling well past it's cooling setpoint. Probably cutting out in the evening when trying to do this?

when you say energized, do you mean it trips? or is there just no power coming off the switch?

really? I haven't had any problem with that. I have a few meters, but this is my main go-to all day.

tell the plumber that your zones are gravity feeding.

if you shock that boiler and crack it, you are not going to be happy.

did you run a vac on this system before charging?

I have used Garmin for years, but wish I could get the Mr. T voice like the Tom Tom.

fluke 902.

I had the fieldpiece, but the thing was beeping the entire time it is put to power. it was annoying as heck. it also broke on the clamp part after a couple of months. the temp input...

pretty happy with my flukes. i use the 902 mainly.

what are the actual pressures?

hahaha that's funny. good thing they saved it. (so you could rebuild it for more than a new one)

how are the other circuits' defrost cycles coinciding? once the temp climbs, does it stay in that range indefinitely or swing around?

We service a church that has about 8 mini's controlled by one commercial stat. Once a call is initiated, each mini then energizes from individual relays in an electrical room. Then they react to...

walk-in freezer? what method of defrost? if it's hot gas, that may be your answer.

yea I recently dealt with this type of issue where I was focusing too much on the cooling setpoint, and the humidity setpoint was dragging the temp down too much and enabling heat. I would do...

$1.00 dawn dish soap bottle and pump sprayer as previously suggested. you will find it.

what is your incoming voltage?

sometimes, if both fans are running, and only one has power, it will pull the other and make it appear as though it is going backwards. other than that, your problem will be in the wiring. study the...

the fan may not have the right power at all, and may only be giving the illusion of running backwards. think about this, and see how you could prove that this statement does not apply.

every Mcdonald's location in the world is mandated to perform certifications on the clamshell grills each year. If you can get certified by Garland, the potential for work is huge. Of course, usually...

I usually gauge how good the coil cleaner is by how much the mist is stinging my face. I guess those days are fading. oh well.