Search:

Type: Posts; User: Gunslinger

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    3
    Views
    75

    this what he posted in his document 1) Temp...

    this what he posted in his document


    1) Temp set is at 71.
    2) Manual increase (override set temp to 74. At that time, manual set temp will be in override for 2 hours.
    3) If then hit the...
  2. Replies
    6
    Views
    292

    I recover from both Hi and Lo sides.

    I recover from both Hi and Lo sides.
  3. Just remember this "You'll only be concerned with...

    Just remember this "You'll only be concerned with the price one time but the results will last a long long time"
  4. Replies
    53
    Views
    2,051

    This would not pass inspection in my area. The...

    This would not pass inspection in my area. The liquid tite needs to be clamped, condensing unit needs to be fastened to the mountimng pad, penetrations thru the wall needs to be foamed or sealed.
  5. Replies
    38
    Views
    1,036

    The sheriff's office here will post a pic of the...

    The sheriff's office here will post a pic of the bad guys on their facebook page. Someone will ID them and then it's silver braclet time.
  6. Replies
    11
    Views
    422

    I take strander copper wire and wind it over the...

    I take strander copper wire and wind it over the hole and adjacent area. Then when you braze it, the braze filler does not block the tubing. I also try to cut the tubing and swedge the connection.
  7. Replies
    38
    Views
    1,036

    A large mean dog in your secure fenced yard will...

    A large mean dog in your secure fenced yard will also help.
  8. Replies
    13
    Views
    913

    Yes that is the place.

    Yes that is the place.
  9. http://www.grainger.com/product/WESCO-Hydr-Pltfrm-...

    http://www.grainger.com/product/WESCO-Hydr-Pltfrm-Lift-9GNA0?cm_sp=EN-_-L3-_-MostPopular&cm_vc=CFMP&pbi=

    I have this one. The hydraulic jack failed;I did not want to invest in repairing it so I...
  10. Replies
    51
    Views
    5,879

    If you get a schrader core stuck, try to put a...

    If you get a schrader core stuck, try to put a core remover on it ( core remover is open ) and then close the core remover or just let it blow.
  11. Replies
    13
    Views
    913

    you probably want a minute to 2 minutes of the...

    you probably want a minute to 2 minutes of the blower to run after a call so the coil can be dried.
  12. Replies
    13
    Views
    913

    To eliminate DSS, the microbes growing on the...

    To eliminate DSS, the microbes growing on the coil need to be removed. Pulling the coil, cleaning and disinfecting is thee only way I know. Then the coil can be coated. UV lights help but they must...
  13. Replies
    41
    Views
    3,341

    TREE

    This is my emergency tree. I bought 10 packless valves off ebay so they were used. I only had to purchase some fittings. The flare that connects to the pump also has an o-ring in it.
  14. Replies
    2
    Views
    239

    You will need a service tech for this repair....

    You will need a service tech for this repair. Sorry but I do not think I am permitted to advise you anything further due to the rules. You will most likely need a replacement part.
  15. My opinion is that when the AC is off due to a...

    My opinion is that when the AC is off due to a low heat load, the air flow gets stagnant. If you have a separate dehumidifier, it will lower the humidity when you do not need cooling. I do not like...
  16. I have a 9 ft little giant step ladder that I use...

    I have a 9 ft little giant step ladder that I use with a Harbor freight winch. I don't have room on the van for the complift that is shown. My set up has worked for me. I also have a lift for holding...
  17. Replies
    103
    Views
    7,123

    That is great news.

    That is great news.
  18. Replies
    32
    Views
    1,094

    I am having a colonoscopy tomorrow morning and I...

    I am having a colonoscopy tomorrow morning and I can tell you that the medicine tastes like what comes out.
  19. Replies
    13
    Views
    2,762

    I had this one 2 weeks ago

    I had this one 2 weeks ago
  20. Replies
    32
    Views
    940

    It is very possible that the refrigerant charge...

    It is very possible that the refrigerant charge was wrong from the get-go. also, if the installer used the same refrigerant lines, the flares may be leaking. have someone do a thorough leak test and...
  21. Replies
    48
    Views
    3,503

    I ask how old are you? The reason is that...

    I ask how old are you? The reason is that residental clients seem to have more faith in older techs. I do not have any problems with residental clients but I am older than dirt. When I was 26, I...
  22. Replies
    2
    Views
    335

    YJ says not to allow pressure on their sensors....

    YJ says not to allow pressure on their sensors. That is the reason I use a core remover in the micron line.You may have contaminated the sensor. Flush it out with rubbing alcohol.
  23. Replies
    17
    Views
    645

    Johnstone B12-401

    Johnstone B12-401
  24. Replies
    25
    Views
    1,325

    The Fieldpiece SRLK8 is my choice for R410. I do...

    The Fieldpiece SRLK8 is my choice for R410. I do not use the auto zero feature; I use manual zero. I use the Tekmate for R22, 134, 404. I have replaced the sensor with the updated blue packaged...
  25. Replies
    6
    Views
    519

    You might try to leave the motor in the circuit...

    You might try to leave the motor in the circuit and disconnect the mechanical linkage to the louvers.
  26. Replies
    21
    Views
    1,091

    You must be careful removing them. Pressure can...

    You must be careful removing them. Pressure can build up in them and come off like a guided missile.
  27. Replies
    7
    Views
    504

    Pls allow me to state that R438 and R22 are not...

    Pls allow me to state that R438 and R22 are not to be mixed. The R438 is a replacement for R22 meaning it uses the same metering device.
  28. Replies
    26
    Views
    1,682

    Actually, I removed my schrader on the side...

    Actually, I removed my schrader on the side point. I use this one on the high side of the system with the Bluevac and adaptor. I have not seen this problem. After the adaptor, I use another core...
  29. Replies
    7
    Views
    504

    R438 is MO99. It is a replacement for R22 so it...

    R438 is MO99. It is a replacement for R22 so it is the same as R22.
  30. Fieldpiece has a charging blanket you may want to...

    Fieldpiece has a charging blanket you may want to look at.
  31. Replies
    5
    Views
    313

    Did the tech note on the invoice superheat, sub...

    Did the tech note on the invoice superheat, sub cooling vaves,high and low side pressures? Make and model number? If so post them so we have an idea. You need to call him back.
  32. Replies
    19
    Views
    1,378

    when choosing an Ipad, what is the best viewing...

    when choosing an Ipad, what is the best viewing color? Is it the grey model?
  33. Replies
    28
    Views
    1,526

    I use the SLR8 on R410. Have not had a problem...

    I use the SLR8 on R410. Have not had a problem finding a leak. It is terrible on R22 and R134. I use a Tek-mate on R22, R134, R404 with great results. My H10 comes out to verify. The SLR2 is also...
  34. Replies
    30
    Views
    2,112

    I would feel embarassed if I had to ask a client...

    I would feel embarassed if I had to ask a client to borrow a tool.
  35. Replies
    8
    Views
    621

    no but it has a cable for remote viewing.

    no but it has a cable for remote viewing.
  36. Replies
    8
    Views
    621

    Inspectyion Camera

    I just purchased an inspection camera from harbor freight for $60.00. It uses 4 AAA batteries. I bought it for checking to see if coils are in the need of cleaning. I tired it on my own coil and...
  37. At this point, the onloy thing that can be done...

    At this point, the onloy thing that can be done is to extensively pruge the lines with N2. Hopefullt, the splice can be reached thru the attic in case of a future problem. Make sure the rubber...
  38. I swage them and braze them often but I do sweep...

    I swage them and braze them often but I do sweep N2 thru them. Never had a problem. I am not thrilled with your shed...makes for difficult servicing unless it will come apart easilt.
  39. Replies
    21
    Views
    1,625

    That would be kind of tough. Different parts of...

    That would be kind of tough. Different parts of the country require different inventory. You will need driers,motors, fuses,capacitors, fittings, access valves, a complete assortment of hose repair...
  40. here is more ...

    here is more

    https://www.energystar.gov/ia/partners/bldrs_lenders_raters/downloads/SizingGuidelines.pdf


    http://www.huduser.org/portal/publications/manufhsg/uvalue.html
  41. read this ...

    read this

    http://portal.hud.gov/hudportal/documents/huddoc?id=doc_10603.pdf
  42. Replies
    19
    Views
    1,378

    I'm on the fence with a purchase of an Ipad Air...

    I'm on the fence with a purchase of an Ipad Air 2. The Verizon salesman said there are Apps that allow you to read PDF's. I will still investigate this.

    Thanks for the heads up.
  43. Replies
    18
    Views
    1,035

    You can't flare it when it won't fit in the flare...

    You can't flare it when it won't fit in the flare vise. They use a metric sized tubing.
  44. Replies
    18
    Views
    1,035

    email is in my profile. click on my name and...

    email is in my profile. click on my name and follow the choices. Also, give model numbers
  45. Replies
    18
    Views
    1,035

    Where else? China

    Where else? China
  46. Replies
    18
    Views
    1,035

    Those Air-con mini's usually have a cap tube for...

    Those Air-con mini's usually have a cap tube for metering. Also, the reason why you may see a coil of copper coiled up is because someone bought or they gave away at no extra charge a lineset. The...
  47. Replies
    56
    Views
    3,309

    Just a reminder that when using a clamp on meter,...

    Just a reminder that when using a clamp on meter, the conductor should be in the center of the clamp.
  48. Replies
    2
    Views
    1,606

    My ice production is low

    Wenton this today. manitowic QY214A. The filter is MIA. This is after I brushed condenser,
  49. Replies
    13
    Views
    590

    A dehumidifier is a good option. There will be...

    A dehumidifier is a good option. There will be days that the AC won't kick on due to load conditions but the air may feel "sticky" because the humidity will be high. An AC system while running will...
  50. Replies
    12
    Views
    925

    I have progressive lenses with the transition...

    I have progressive lenses with the transition option. I have no problem with them.
Results 1 to 50 of 1000
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event