Type: Posts; User: jaceski
Under the point, Did you actually select Hex and put in 10 for address or 0A?
How do you write to it?
Thanks for the feedback...I built out the temp points as Numeric bits and beginning bit 0 and number of bits 8 for Low Bytes
and Numeric bits and beginning bit 8 and number of bits 8 for High Bytes...
Here is the manual if it helps...modbus towards the back.
Anyone get these resolved?
I have the same issues with those points.
I mapped the supply temp as Numeric Bit point as Hex 0 with
Beginning Bit 0 and number of bits 8 then I did the conversion...
Where do I get the latest MP580s firmware upgrade?
I think it is 4.08, the latest?
rgcowie4D: We are a contractor in Chicagoland area and we have the JCI tools along with some ex-JCI techs.
We have ex-JCI customers that have ADS, NAEs, and just picked up a JCI customer that has...
I have old Lieberts(1996) that are wired back to a sitelink panel that failed. This panel goes to a JCI N2 Integrator.
The communication wires are on terminals 77 and 78 and go to this sitelink...
There are no numbers except the assembly number.
There are around 12 Liebert units connected to this panel then the JCI Integrator is connected to it.
The Integrator is bad but there is a Jace...
Does anyone know what this Liebert panel is?
The N2 Integrator is connected to it but the Integrator
is bad and I want to connect to a Jace.
Sounds like the firewall is blocking port 80
The Bacnet /IP 47808 should only need to be open if your network
is talking to another external network. (Other side of firewall)
Here is one company....
They get paid through the Utility companies, not the customer.
Whatever anyone has is appreciated...
try pinging the ip locally.
i had a couple of pneumatic tube connections on the box cracked, causing airflow to be intermittent.
check object category then uninstall JAVA and re-install the "old"
version of JAVA that is needed.
what is in hand?
There are companies that will perform the audits free of charge..
You can use lonmaker to setup the network and install .xif files in nae
Can you send me the link also?
Thanks, I will try it and let you know.
I have a site that has FX60 with NXP-FSC-01 lon controllers.
One of the controllers died and we replaced it.
I tried to discover the new device but the FX would not discover it.
I connected to the...