Type: Posts; User: reed
Checkout Jackson systems .com. They have a simple device mm100.
I was involved in the installation of the tac controls there. ( East Indianola ). That building has some thick walls. As I remember you have a boiler and chiller barrel in basement. Two tac panels...
Looking for a manufacturers that makes a through the wall mounted condensing unit. I have seen them where the units are flush with outside wall and all access is inside. Another unit i seen was a...
Are the outside air dampers closed at airhandler. Sounds like it could be open and bringing in hot air with the discharge temp. being 73.
the company called comstar 1-800-328-0142 makes a spray just for dirty sock coils. It has fix some of our problems in the past.
I'm looking at a 4x4x8 walk in cooler. was a r12 now mp39. this unit has been thrown together nothing fancy. what type of pressures, sh, sc and td should this unit be running. one thing i did noticed...
looks good!!!! Only thing I don't see is a barometric draft regulator, a draft inducer and a cleanout tee.
I'm looking for a wiring diagram for landing wires at base. honeywell stat #t7300f2150 or american standard #asystat705a. I got the installer's guide, no were in there about terminal landing.
Trublshter what I was getting out. If being a novar service provider has it got your foot in the door on commercial stores that have novar to do more than repairing controls?
is anybody out there a novar technology center provider? and if so what are the pro's and con's of being n.t.c provider.
what is the differance between a ubhb-25j21 mfea and ubhb-25j18 mfea. what size coil is in it and is a piston or txv inside.
they have them at graingers
I found on two furnaces of rheem or ruud that the fan would not come on ( stat was in fan on ) because they didn't land a motor speed on fan terminal on circuit board.
if the waterheater ties into the same chimney i would turn the waterheater on and checked for drafting of flue. To see if chimney could be plugged. Is your chimney lined.
thanks for the advice so far. I went to there web site and went threw check list. the one thing that caught my attention was.. water runs over evaporator during harvest cycle and it did when i was...
m# gy0204a s# 930860075 The problem is that the ice does not stay hard during the harvest cycle. By the end of cycle there is no cubes of ice left. what should the timer be set at for pump after...