Search:

I would have to add a receiver :munching:

Looks like I might have to go with a sporlin rapid pressure bleed TVX. Any suggestions?

487871

Much better results with this setup. I kept the large reservoir to hold water.

Now all I need is some help with the pressure when the unit cycles off. My compressor is low torque; so...

Using distilled water helps if you have leak. Just remember to change it every couple of months.



It was fresh tubing that I bent around a piece of PVC. Yes you are correct on the sizes.

I...

Source
Second paragraph. Really just don't know enough about them to start with.

Not very efficient.

I think the flow is so fast the water never slows down to get a good heat exchange. Gonna put some dividers in tomorrow and see what happens.

If I set the temperature to 90 degrees it will cycle on and off. If I crank the temp down to 75 degrees or ambient it will never satisfy under-load. But the temps will not rise, stays steady just...

That 94 degrees is with the radiator setup that the chiller replaced. The new setup can hold the full load but it will not cycle during load. Stays on continuously

Was thinking one of these might work. Not sure if there is contact there on the Refrigeration Research BH33 and BH50.
486431

Condensation not a issue, I am not running below the dew point. This was the water temp when I drained the system to remove the radiators. My whole reasoning behind this was no matter how many...

Hey Guys, this is something I built to cool my pc. My goal was to get rid of the radiators in the case. Well, for that it worked. But I want something that will give me more of a direct contact...

Thanks for responses; gave me some fresh ideas ;-)

Ok guys and girls this is my last week of school(HVAC/R trade SCHOOL). I have been looking for a jobs in the hvac/r field and everything that i have seen requires experience. So how do I get around...

Thanks for the upgrade to PRO Membership Committee :-)

OK so i debated with myself to post about this but here it goes. I applied to be a PRO member on September third 2011. First I should give some background info...I am a NOOB!!! I am attending...

Welcome Back

Welcome!!!

Welcome

Welcome

Welcome

Welcome

Welcome!

Welcome! According to WIKIpedia 90% of forum members are lurkers :-)

Welcome!

Welcome!

From a fellow new guy Welcome

Is Fieldpiece a good company to purchase stuff from? How do they stand behind thier products like warranty wise? The Fieldpiece does have nice specs!

Best scales for the money and longevity? Don't want to break the bank for some good ones.

Triad area

Found this great site after deciding to get into the HVAC field. After spending over half a decade in the IT field i have decided to go to trade school for some HVAC training. Office work isn't for...