Type: Posts; User: condenseddave
Call Danfoss and ask to speak to Fred Feldman. His knowledge is anything but limited.
Did they eliminate the "start new thread" button???
Happy Memorial Day.
The co I work for installs for Costco, glycol & MicrothermoŽ nowadays, from what I hear. Can't be a good thing, lol.
I think I use the same words you do for them.
I like it. It's not really all that different from the others, aside from the long nose.
I am here: http://tapatalk.com/map.php?soj13s
I have them on my Nissan NV, and they're pretty secure. The bolts that hold mine on are factory installed, and, after working with them awhile, I've come to the conclusion that a thief could get...
Lol. Good question. New & improved!
It's been out for a couple years, I never heard of anyone using it, though.
I am here: http://tapatalk.com/map.php?0neasc
Thanks, Phase Loss.
I am here: http://tapatalk.com/map.php?4waent
Is the BBS still online? I tried my bookmarked URL, and it comes up dead.
I use a wet/dry vac. You can get one of those bucket head vacs at HD for 20 bucks, that is plenty strong for drains.
I've done a few.
It's no big deal. I was in on around 120 502-404a conversions a few years ago, and they were a bigger pain.
Haven't had any significant leaks to know if fractionation is a...
I don't know much about the R22a, but I will say that I have dealt with this guy on and off for about 8 years, and I have never had a problem with him.
He's got a LOT of hard to find gaskets, etc....
The Loctite 5 minute epoxy gets ya online quickerer.:LOL:
Good thing it was on the suction line.
We had that store for over a year, with no valve failures, running the old controller, in fact, it was a super-quiet store. The moment they put those used Reflecs in, the games began.
I work for...
If it is the P-mark on Stelton, then yes, I have been intimate with it. There used to be a Lon controller in there to run those KVQs, and, to the best of my knowledge, there were almost no failures...
You're not in a store in South Plainfield with this, are you? CPC Reflecs, KVQ's and relays all over the place? Hussmann Screw racks... Just curious.
Whatever floats your boat, skippy.
Here is the actual Browning manual.
5 years later...
Well, here are the instructions. I use it all the time on compressor drive belts. Just when you think they're too tight, you find out that they are too loose...
KVQ is an old Danfoss stepper type EPR. Should be controlled by a Danfoss case controller...
Full beard? Scott?
You'll regret it. Then THEY will know where you are!:couchhide:
I don't. Got lost. Or bored. Or am a glutton.
Or, I like to :deadhorse:.
Or maybe they have a better emoticon selection and that's the only reason I stopped in...