Search:

Thanks again!

Thanks for the ideas guys. The mesh looks like a good idea, only I need to cut it to size, to wrap around.

Hey guys I just cleaned out my condenser and found a ton of these little palm tree nuts that managed to slide into the hood of my XL14i. Is there a screen I can use to cover top part of condenser?...

Yup, found some piping rubbing against panels, and flooring. So I insulated them and unit runs quieter.

Ok, been working this issue for a while, obviously. I tried putting a little insulation rubber tape under cover connections going to fan motor, this didn't stop vibration. When I hold or even press...

We installed my Trane 2 ton system about 6 years ago. To level and try and eliminate vibration, I placed 4 or five rubber feet under condensing unit. A few months ago, Brighthouse (tv) people showed...

I've got an old Ruud and the condenser fan motor is failing. It's an Emerson, 1/6 hp, .9 amp, 208-230 volt 1075 rpm, 3 uf cap. I've got an AO Smith, 1/4 hp, 1.8 amp, 208-230 volt 1075 rpm, 5 uf cap,...

Check your pitch. Is your drain working right?

Go Sox, Go Pat's!

Try not to use any soap if the coils are not too dirty. And use as less soap as you can to remove the dirt because when you wash a coil, your removing a certain amount of millage with it...

Timberland Pros. Steel toe. They sell them at Sears for about 80 bucks. And there light too!

Thanks for your help guys. I was just getting a good idea about increasing by a half ton based on my heat load during the summer afternoons. I've done an effiency test by calculating my amps,...

Hi, my name is Bob, and I have been perusing these boards rarely for the past couple of years. I was wondering about replacing my Heil air handler which is a 2 ton, and 17 years old, as well as my...