Search:

Type: Posts; User: nikolce

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    15
    Views
    1,057

    amana is piss of sh.t!!!="GOODMAN" GET TRANE! OR...

    amana is piss of sh.t!!!="GOODMAN"
    GET TRANE! OR CARRIER
  2. Only By Subcooling If Is Txv Sys At Least 60 F...

    Only By Subcooling If Is Txv Sys At Least 60 F Ambiant!!!!!
  3. Replies
    12
    Views
    696

    whats you liquid line temp and hih side presure?...

    whats you liquid line temp and hih side presure? ask the guy to change only the back part of the motor the electronics!
  4. you will have lots of problem with static...

    you will have lots of problem with static pressure if you are using infinity zone contols by looking those zones.....you had to oversize all zones each zone to be capable 75% by it self read zonning...
  5. Replies
    46
    Views
    2,870

    carrier only makes 2,3,4 and 5 ton cond units in...

    carrier only makes 2,3,4 and 5 ton cond units in infinity as you contractor to check sys pressures and make sure he checks it by subcooling ask him to tell you what subcooling is running i think 5...
  6. Replies
    3
    Views
    748

    infinity looks at out door unit and determs the...

    infinity looks at out door unit and determs the cfm by it u can not adj CFM on infinity to reset it you have to go to addvance
  7. 1.Your sys should be service every year by pro...

    1.Your sys should be service every year by pro
    2.Not blowing cold enough could be low on freon
    2.Not blowing as use to could be dirty filter or freezing coil do to low on freon
    3.Use white...
  8. Replies
    32
    Views
    5,157

    may be you should start to charge 410A by gas...

    may be you should start to charge 410A by gas since is so close.....wasnt supply house was in puron class by carrier.....
  9. Replies
    26
    Views
    1,978

    did you check if is windings are gorunded??? also...

    did you check if is windings are gorunded??? also owm out winding.....and try to add hard star kit..........my ex boss (plumber) told one time to hit the compresor with 2x4 and hamer on top of of...
  10. Replies
    32
    Views
    5,157

    BECOMES HIGHLY FLAMEBLE!!!!not a good idea :)...

    BECOMES HIGHLY FLAMEBLE!!!!not a good idea :) PUT new 410a if you have leak!!!!!!!!!!!
  11. Replies
    19
    Views
    1,061

    you miss understood the point i was thiking since...

    you miss understood the point i was thiking since the txv froze been coolder than the bulb which is on suction bulb charge magrate to powerhead....not the freon!!!!!
  12. Replies
    19
    Views
    1,061

    but the fact sys worked last summer.......and i...

    but the fact sys worked last summer.......and i checked the vents and return i the house ok....
  13. Replies
    19
    Views
    1,061

    it was freezing up still right after...

    it was freezing up still right after txv......when i was trying to add more 410a (after 4F subcooling ) freezing moved down where dist tubes wore anterying the coil......and then when i was done...
  14. Replies
    19
    Views
    1,061

    custumer said that has been freezing up for the...

    custumer said that has been freezing up for the past month and he was shuting off to unmelt and then he was putting back on also the previose service tech when he did start and test on the new sys...
  15. Replies
    19
    Views
    1,061

    low

    low
  16. Replies
    19
    Views
    1,061

    after 3lbs of 410a sys ran with 4F of subcooling...

    after 3lbs of 410a sys ran with 4F of subcooling and low side was around 70 psi and high side around 250 psi but sence txv was not oppening not acts like fixed orfice so i didnt want to leave the...
  17. Replies
    19
    Views
    1,061

    was joking....

    was joking....
  18. Replies
    19
    Views
    1,061

    ......remove sencing bulb warm up by hand low...

    ......remove sencing bulb warm up by hand low said still the same
  19. Replies
    19
    Views
    1,061

    Is it the TXV???

    about 1 year old sys worked 1 summer this is the 2 summer....found sys low 0F subcooling (side glass bubles):D added 3 lbs of 410 A (service tech left caps off service valve) sys runs now with 4F of...
  20. Replies
    27
    Views
    2,836

    Just Better digital gauge problem!!!! HELP

    :confused:I bought my digital gauges about 1 year and 4 mon....(http://www.jbind.com/catalog_multi-page/Page_10-11_JB_Industries_2007_catalog.pdf) JB i had them change twice first year under warranty...
  21. http://www.geocities.com/nikola36/000_0076.jpg ...

    http://www.geocities.com/nikola36/000_0076.jpg


    http://www.geocities.com/nikola36/000_0078.jpg


    http://www.geocities.com/nikola36/000_0077.jpg
  22. Replies
    49
    Views
    3,274

    You duct is small or u dont have enough run ON...

    You duct is small or u dont have enough run ON THAT ZONE, that zone only will open if other zone calls for heat/cool
  23. Infinity Zoning System!!!!!!!!

    Infinity Zoning System!!!!!!!!
  24. Thread: Carrier 48GS

    by nikolce
    Replies
    6
    Views
    739

    clean ur flame sensor with sandpaper or check the...

    clean ur flame sensor with sandpaper or check the hose of the presure switches
  25. YES u can add hydro coil and u can wireto the A/H...

    YES u can add hydro coil and u can wireto the A/H u need to cut 2 wires and use DC relay and u need to set up 5,8,9,10,20 KW (AIRFLOW) ON THE infinity control the only problem is when control calls...
Results 1 to 25 of 28
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event