Search:

Type: Posts; User: builder010974

Search: Search took 0.01 seconds.

  1. Replies
    24
    Views
    1,304

    agree with jpsmith , use an accurate set of...

    agree with jpsmith , use an accurate set of digital gauges, and excessive pressures and times aren't typically required. as a rule i test @ 150psi for 20mins or so and call it good.
    also one thing...
  2. referring to my previous post, i know i can swap...

    referring to my previous post, i know i can swap to a different control and make the system work properly, my concern is if anyone has had experience with a particular DF control that works well on...
  3. the codes on the DF board will only show 5 min...

    the codes on the DF board will only show 5 min lockout after the attempt to run on standby power. if i jump out test pins it will try again. and i get same results.
    any thoughts on just swapping...
  4. Thanks for all the replies guys. i will check...

    Thanks for all the replies guys.
    i will check for a load shed module. i did not look for it specifically. however i do not believe there is one installed. as i can use use low voltage signal from...
  5. Heat pump condenser will not function correctly on standby generator power.

    Hey guys i'm looking for some advice on a problem i have with a customers system.
    the system in question is a 2015 rheem 14 seer
    4 ton split heat pump.
    22kw honeywell generator
    condenser...
  6. Replies
    59
    Views
    6,690

    for full sized tools,i used the 18v dewalt ni-cad...

    for full sized tools,i used the 18v dewalt ni-cad set for years, then when makita lxt 18v lithium was introduced i switched to them. i dont know exact dates but i am shure its been 3+ years of...
Results 1 to 6 of 6

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365