Search:

Advanced Response,

Only a HO but sounds like pulling a pin and running on first stage is way to go. Will give it further thought and do some research. Thanks so much.

Kind of dark in here right now but perhaps the light will come on. Thanks for all responses and willing assistance.

According to printout from manual, I am only able to get to 915cfm with single stage. Oh....perhaps D for cool tap and D for adjust tap?

With pins set on cool tap on D and adjust tap on C provides 915cfm on high and 495 on low. Since it is single stage, I assume the low setting of 495cfm is not available.

Single stage AC. If I had a two stage, I could get CFM down to around 400 very easily. When this unit goes, I will replace with two stage. Must I replace with a York unit or do I have options?

PIXUC16V07501

York Diamond 95 Ultra with VS 2 stage gas heater circa 2002.

It is VS blower but again 915 is lowest setting using pins inside unit. This is a single stage AC unit although the heat is two stage.

Do not have the expertise to check pressures, load, etc. so will likely be safe setting it the 900 cfm. Or at least, I hope so. Also just double checked and lowest setting is 900 cfm so will have...

Right. But not sure if the CFM was set to coil or condenser. At an rate, now set to 900 CFM so will keep an eye on humidity control.

I appreciate the response. Just a few minutes ago decided to set the VS blower to 900 CFM and watch RH movement.

Outside unit is 2 Ton but coil is 2 5 Ton. What would the recommended CFM be for maximum humidity control? Presently set at 1000 cfm.

The Bryant uses a hogs hair filter in a size that is not compatible with any commercially available 1" filter. Other than having a custom frame made and then periodically purchasing the inserts, is...

Well Gunny, that about sums it up.

Thought so. Thanks.

Does anyone have any info on this item. It sits on top of heat pump and "blows" upward when fan is running and then lays down on top of unit supposedly to protect motor from getting constantly...

My experience that there are many good professional HVAC guys and techs out there but there are also some lazy ones. The young man that they sent out to correct some problems with my new install had...

It is likely in the manual. Have to enter program mode and follow directions.

I ordered some pleated material from air sponge. Will have to cut and fit to frame.

Isn't hammock spun fiberglass same as inexpensive bue $1 filters? Is present hogshair filter better than cheap disposable filters?

So what would the recommended material to be used in this frame? Pleated media?

Recently purchased a custom made aluminum frame filter with screen and hinged sides. Am I correct in assuming that the direction of air flow should be first through the filter material and then...

Consider the 265ANA and FV4 variable speed handler with preferred humidistat with outdoor sensor.

Interesting that the washable filters are standard on Bryant VS air handlers.

That info is availavble on their web site. Just go to menu on left side of page where it says controls. Then select the Preferred stat. That page will have option for documentation and those...