Search:

Type: Posts; User: gban

Search: Search took 0.01 seconds.

  1. Replies
    86
    Views
    7,204

    Interesting thread, Job well Done chrisk! Kinda...

    Interesting thread, Job well Done chrisk! Kinda late but just out of curiousity,,,,you mentioned you installed a couple of Sporlan Y1236C oil regulating valves, Did it have one on the low temp when...
  2. Replies
    18
    Views
    2,835

    maybe the oil separator isnt doing its job We...

    maybe the oil separator isnt doing its job
    We had a very similar issue with a hill rack also about 10 years old. same senario low and med temp setup. off time for med temp and hot gas for low....
  3. Replies
    5
    Views
    950

    there is a dial in the back where you can adjust...

    there is a dial in the back where you can adjust the contrast maybe it will help some. is there a 5k(modem for Comtrols) in the store you can connect to using ezcom and you can see what your...
  4. Thread: SORIT VALVE

    by gban
    Replies
    15
    Views
    2,661

    Bunny any idea why one of those new valves would...

    Bunny any idea why one of those new valves would start closing up after a hot gas defrost or when they leave the door open fir a while? The box goes to about 1 deg F and then pres and temp rises. I...
  5. Thread: SORIT VALVE

    by gban
    Replies
    15
    Views
    2,661

    Bunny any idea why one of those new valves would...

    Bunny any idea why one of those new valves would start closing up after a hot gas defrost or when they leave the door open fir a while? The box goes to about 1 deg F and then pres and temp rises. I...
  6. Thread: SORIT VALVE

    by gban
    Replies
    15
    Views
    2,661

    NANOTECH what is the issue you are having with...

    NANOTECH
    what is the issue you are having with that valve? is it not opening at all or does it close up after being on for a while after the hot gas defrost cycle? what type of cases Hill Hussmann?
  7. Replies
    17
    Views
    1,755

    A while back had a brand new compressor on a...

    A while back had a brand new compressor on a freezer kept tripping on oil failure. net pressure good, oil level good. took of the sentronic sensor and there was no o-ring on the sensor. maybe the...
  8. Replies
    8
    Views
    967

    Liquid Line Solenoids being damaged

    have a big meat packaging processing plant with a parallel system r404a. used to be one on one systems. (-25 & +15 R22, R404a, R408a and oviiouslly diffrent oil. ). the liquid line solenoids after a...
  9. Thread: Hill Phoenix

    by gban
    Replies
    17
    Views
    2,186

    Poll: It almost reminds me when I used to work for...

    It almost reminds me when I used to work for Hussmann Chino Systems and IR bought them and came in strong, we all felt good. "1-2-3 by 2004" they said, little we knew that they were shutting us down...
  10. Replies
    11
    Views
    908

    Have any of you guys ever had an experience were...

    Have any of you guys ever had an experience were the oil reservoir and the line going from the oil reservoir to the compressors is almost as hot as the separator and the sight glass on the oil return...
  11. Thread: Hussmann Kool Gas

    by gban
    Replies
    7
    Views
    745

    The first picture is an Alco (Flow Control)...

    The first picture is an Alco (Flow Control) liquid differential valve, the second is a "hot gas boost" for the kool gas defrost. I think this was to give the kool gas a "boost" if there wasn't enough...
  12. Replies
    26
    Views
    5,660

    Poll: Now that I remember, when I was at Hussmann...

    Now that I remember, when I was at Hussmann Chino, we built some units for Dippin Dots. It was a blast freezer, and a small staging area. We started out with 3 Copeland compressors on the first units...
  13. Replies
    26
    Views
    5,660

    Poll: Nice quiet compressors, available with unloaders...

    Nice quiet compressors, available with unloaders on most models, less vibration.
  14. Replies
    8
    Views
    728

    I've used it on some units that had digital...

    I've used it on some units that had digital scrolls, not a bad set up.
  15. Replies
    7
    Views
    1,350

    From the main menu, after you have logged in with...

    From the main menu, after you have logged in with level 4 password, I believe it's #7-Configuration, #3 System Information, "Unit No." should be displayed at the very top left hand corner, No?
  16. Replies
    10
    Views
    1,129

    Have any of you guys come across where the oil...

    Have any of you guys come across where the oil reservoir on a rack is hotter than heck (about the same temp as the separator a little less) and where you could see the oil bubbling in the sight glass...
  17. Replies
    14
    Views
    3,789

    Sorry Icemeister, just realized i mispelled...

    Sorry Icemeister,
    just realized i mispelled your name on my previous post and thanks again for info.
  18. Replies
    14
    Views
    3,789

    thanks icemaster

    thanks icemaster
  19. Replies
    14
    Views
    3,789

    hey freonguy, you mentioned that oil doesnt move...

    hey freonguy,
    you mentioned that oil doesnt move with "refrigerant" as well as with conventional refrigerants so im assuming that you refer to amonia as refrigerant in your post. would you be able...
  20. Replies
    3
    Views
    491

    Looks and sounds nice. what do you think all...

    Looks and sounds nice. what do you think all those lines on the floor covered with sheet metal are and where do you think they are going or coming from? to me it looks like an oil supply system for...
  21. Thread: Digital Scroll

    by gban
    Replies
    6
    Views
    1,104

    Hey Dow do you remember what controller was used...

    Hey Dow do you remember what controller was used on that rack? CPC, Danfoss, Com-trol? How did you program it? anything fancy like a sensor control or something like that?
  22. Thread: hill phoenix rack

    by gban
    Replies
    5
    Views
    1,025

    jaybee you can find a lot of info on the...

    jaybee you can find a lot of info on the manufacturers websites. just depends what application you are going to use the inverter on or what inverter brand you want to work with. Once you've figured...
  23. Thread: hill phoenix rack

    by gban
    Replies
    5
    Views
    1,025

    When you say variable capacity, do you mean...

    When you say variable capacity, do you mean unloaders or an inverter. The rack usually comes with a service manual a lot of info there. If not you can contact Hill Phoenix and i am sure they can send...
  24. Thread: r.m.c.c. problem

    by gban
    Replies
    29
    Views
    1,369

    You said you even bought a new USB adapter so i'm...

    You said you even bought a new USB adapter so i'm thinking this is a newer laptop with out a DB9 connection. Not all USB to DB9 converters work especially on older units. I personally have a Radio...
  25. Replies
    40
    Views
    4,788

    terminal #4 should be your N.C. (solenoid or...

    terminal #4 should be your N.C. (solenoid or compressor) and #3 N.O. defrost heater contactor. if the wire on the #4 (N.C.) terminal on the timer is going to a liquid line solenoid then more than...
  26. Thread: Hussman Puzzler ?

    by gban
    Replies
    17
    Views
    1,778

    hmmm, i thought it was only ambient + 15

    hmmm, i thought it was only ambient + 15
  27. Thread: Hussman Puzzler ?

    by gban
    Replies
    17
    Views
    1,778

    maybe liquid drier or txv is plugged? does the...

    maybe liquid drier or txv is plugged? does the txv have the right charge or big enough? the high side seems a kind of high though, 275# = 111 degrees r404a on a self contained (indoors probobaly...
  28. Replies
    31
    Views
    1,462

    no connection, and yes i read the story. the...

    no connection, and yes i read the story. the reason why he's probobaly not getting offers is because of his indictement or teams probobaly figure no one wants to pitch to him because they don't want...
  29. Replies
    31
    Views
    1,462

    so mark mcguire from a slim oakland a to a mamoth...

    so mark mcguire from a slim oakland a to a mamoth st luis cardinal naturally? yeah......
  30. Replies
    31
    Views
    1,462

    it just seems that only bonds the arrogant ah...

    it just seems that only bonds the arrogant ah cheater. i dont believe that cheating is ok either. but dont put the spotlight on anyone or point the finger at only one person when many other athletes...
  31. Replies
    21
    Views
    5,137

    i asked cpc and they told me that the screen had...

    i asked cpc and they told me that the screen had to be the same as they have different manufacturers. unfortunately i had a newer controller. and I like the newer RMCCs a lot better than the older...
  32. Replies
    31
    Views
    1,462

    so mark mcwire, jason giambi, roger clemens are...

    so mark mcwire, jason giambi, roger clemens are ok though. they haven't used any illegal drugs or enhancing steroids, right?......... come on
  33. Replies
    31
    Views
    1,462

    I'm getting the impression that people have...

    I'm getting the impression that people have something against him. It's not like he can't play or anything like that. he is the home run king for a reason
  34. Replies
    21
    Views
    5,137

    I agree with Ned,not to long ago i was trying to...

    I agree with Ned,not to long ago i was trying to replace an RMCC because the screen was bad. I got a hold of another RMCC but the sofware version on that controller was different and when I restored...
  35. Replies
    31
    Views
    1,462

    barry bonds, mark mcguire, roger clemens, jason...

    barry bonds, mark mcguire, roger clemens, jason giambi you name the player all "tainted goods" but all of them very talented. I wouldn't mind having barry bonds on the astros roster or any other...
  36. Replies
    12
    Views
    960

    thanks really aprecciate it. have somewhere to...

    thanks really aprecciate it. have somewhere to start now

    gban
  37. Replies
    12
    Views
    960

    Hey guys I am from the southern california area...

    Hey guys I am from the southern california area and I'm trying to find out a way to call up stores that have analog modems from where ever i may be. I looked into the verizon broadband access plan...
  38. Thread: oil seprator

    by gban
    Replies
    6
    Views
    814

    I beleive some rack manufacturers installed that...

    I beleive some rack manufacturers installed that solenoid on the oil line to prevent oil and liquid from migrating back to the compressors crank if all of the compressors turned off, controlled by a...
  39. Thread: CPC E2 password

    by gban
    Replies
    22
    Views
    5,343

    yeah, but according to hem057 in post #10 of this...

    yeah, but according to hem057 in post #10 of this thread it looks like he even bought new boards and wired in the fan contactors to the boards. And it doesn't matter how many times you read the e2...
  40. Thread: CPC E2 password

    by gban
    Replies
    22
    Views
    5,343

    After reading this thread I couldn't help finding...

    After reading this thread I couldn't help finding out myself. In the older manuals it does say that you CAN choose to turn the fans on or off during pump down, defrost, & drip but you actually CAN'T....
Results 1 to 40 of 40
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event