Search:

It will not let me add by left clicking. I am waiting for permission to cycle power because this unit is controlling a clean room. I hope it takes the configuration and up-dates the changes after the...

Does anyone know if I need to Re-Start the station after you make the station a BBMD to be able to modify the BDT?

How do you add a BBMD to a Niagara panel. Do you add this under the Link tab?

Does anyone out there know if Cypress Environsystems Green Box has a BBMD? The documentation say's its BBMD enabled but I do not know where to go to get this... Anyone out there deal with this...

I wanted to know if this was a BaCnet device that I would be able to integrate into a siemens system via BaCnet?

Thanks Bill. Is there a default log on that JCI uses to get into these controllers?

What Baud Rate do you use for Hyperterminal.

ÄB.CTWR1.SS#2 Must have the same virtual address as the DI virtual address within the L2SL.

I have a site that we have taken over that has a JCI N31. I have Project Builder abd Site Book.... How do I get into the N31 and upload into the project builder? What type of cables do I need?

I have a Trane voyger unit, 25-50 ton unit that i'm trying to install a supply air reset from a siemens system. I was told all I need a reset board that has a 0-10 VDC input and a 0-1000 ohm output....

it has an extermal Reset board that connects to terminals 12 and 15...

it has an extermal Reset board that connects to terminals 12 and 15...

I have a Box car Air Handler thats a Carrier Model # 48DK044 that has a Supply Air Reset board in it and im trying to find out if it can take a 0-10 VDC signal to it. Anyone??????

you will have to get your hands on wincis. that will take care of your problem

Whats a good way to calculate BTU'S on a chilled water system.

I would run any kind of reports you could on your DDC Panels through your work station to find any failed points and and Programming that could help save energy.

Try uploading the panel

what exactly does DMS stand for im pretty new to the controls industries and only know siemens software