Search:

Type: Posts; User: weslud

Search: Search took 0.02 seconds.

  1. We finally got Hobart to return and try some...

    We finally got Hobart to return and try some more. The tech finally replaced the pump and impeller and that took care of the issue. It turns out that the pump on the new AM15 is a fraction of the HP...
  2. Detergent is "Respond solid". 208V/3 phase ...

    Detergent is "Respond solid".

    208V/3 phase

    Internal booster heater.
  3. Wash and rinse arms were checked, and switched...

    Wash and rinse arms were checked, and switched from top to bottom, hub O-rings were changed. We tried on cycle 2 but it still left some food residue and staff don't want to wait that long between...
  4. Yes, that was the first thing I checked.

    Yes, that was the first thing I checked.
  5. No softeners. We have good city water.

    No softeners. We have good city water.
  6. Temps are good. 167 wash and 185 rinse and we...

    Temps are good. 167 wash and 185 rinse
    and we don't have a hard water issue.
  7. Hobart AM15T not cleaning dish trays adequately.

    I have a new Hobart AM15T that doesn't clean the school trays very well. It leaves food residue on all some of the lunch trays. It is under warranty and Hobart came to check it out. We checked the...
  8. Replies
    7
    Views
    2,095

    I have had the same issue and called Blodgett to...

    I have had the same issue and called Blodgett to get the part number to replace the whole control assembly with solid state manual controls for around $1200.00. This seemed like the way to go so I...
  9. Thread: Hobart AM 15 T

    by weslud
    Replies
    5
    Views
    1,976

    Thanks everyone, it was the control board. I...

    Thanks everyone, it was the control board. I didn't see any signs of water leakage. I ordered the display module and the relay board as well just in case, but the main board took care of it.
    I did...
  10. Thread: Hobart AM 15 T

    by weslud
    Replies
    5
    Views
    1,976

    Hobart AM 15 T

    No display when turned on, just the cycle lights illuminated. No operation. Please help
  11. You could check www.publicsurplus.com. they sell...

    You could check www.publicsurplus.com. they sell used equipment from school districts, city govt., etc. buy a used machine for a few hundred and scavenge parts!
  12. I had a control board, so I just changed it out....

    I had a control board, so I just changed it out. It's running good now. Guess the old one was bad. Thanks
  13. Hobart AM-14T Dishwasher rinse only lasts 9 seconds

    I have an AM-14 T dishwasher and the rinse cycle stops after 9 seconds instead of the required 15 seconds. It is several years old so it has an older control board that only lets me adjust the wash...
Results 1 to 13 of 13

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365