Search:

Type: Posts; User: sshanky

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    2,021

    I found out I know someone who can clean it in...

    I found out I know someone who can clean it in place. I always figured it would be possible. The top of the Goodman unit was easy for him to open without cutting it -- it must've been done before...
  2. Replies
    10
    Views
    2,021

    The tech shot a photo through a small hole to...

    The tech shot a photo through a small hole to show me the coil. Isn't there any way to get to it without having to do what I described above? What would the experts do?
  3. Replies
    10
    Views
    2,021

    Cleaning the coils in a Goodman air handler

    Hi everyone,

    I have a Goodman air handler in my attic that is easily accessible. I've posted about a situation I had recently where condensation was dripping out of the tray. First tech said water...
  4. Thanks for all the replies. He told me that it...

    Thanks for all the replies. He told me that it would cost $$$ to $$$ to pull the coil due to the need to cut it out. He thought it might be possible to trap the freon. But he thought it wasn't worth...
  5. OK. I just finished talking to the tech. He...

    OK. I just finished talking to the tech. He showed me a photo of the AC coil, which was apparently very dirty. After the 4th visit they finally took a look at that. I asked him why no one checked it...
  6. Fan reduced over summer by contractor; Now heating fan is so low, heat barely works

    Hi all,

    I live in Phoenix. Over the summer, I had some water dripping from the air handler in the attic, causing a wet spot on the drywall below it. Short story is contractor (sent by warranty...
  7. can you give general guidelines on what the...

    can you give general guidelines on what the proper solution is? If it's simple, shouldn't the tech have figured out what to do? I still am not sure if I should leave the fan at 1/2 speed or if I...
  8. Also, he told us that we could remove the cover,...

    Also, he told us that we could remove the cover, unplug the air handler, and reverse the black and blue wires to up the speed back to full. I opened the cover and reversed the two wires, but one was...
  9. More info, in case it helps. I have a Goodman...

    More info, in case it helps. I have a Goodman chpf60d2c, as shown on work order. I saw a label inside the unit that says 1993, so it's not new, even though he thought the coil was newer than that.
    ...
  10. Oops...didn't realize prices were not ok. just...

    Oops...didn't realize prices were not ok. just wanted to explain the decision process.

    So, do you guys think I am putting my system at risk by leaving the fan at this lower speed (seems like 1/2...
  11. We just moved into the house. The outside unit is...

    We just moved into the house. The outside unit is probably 10 years old, maybe 15. Soon after we moved in (and after we thankfully got the warranty, called OneGuard), the control board went out (we...
  12. Trying to figure out if the repair guy is right in his assessment

    Hi all,

    First post in the forums...

    I live in Phoenix, where it has been a bit humid and very hot recently. I have a 5-ton outside ground mounted compressor and the air handler and furnace are...
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event