Search:

Type: Posts; User: sporter7567

Search: Search took 0.01 seconds.

  1. Replies
    34
    Views
    9,515

    I have had two different inducer fan motors that...

    I have had two different inducer fan motors that were running apparently fine that when I hooked an amp clamp to them they were off the rating by more than 10%, I don't recall the exact amount; one...
  2. Replies
    1
    Views
    328

    Went into Best Buy last night. Was in there 45...

    Went into Best Buy last night. Was in there 45 minutes before a salesperson could help me the place was packed. People buying sh-t to so they can shop online.
  3. Replies
    4
    Views
    385

    I agree with Karst, zone systems work great if...

    I agree with Karst, zone systems work great if they are sized right. Have you verified the actuators are actually moving? Are there hidden dampers anywhere that might have worked closed after the...
  4. Replies
    41
    Views
    1,741

    give all the prisoners a knife and let them into...

    give all the prisoners a knife and let them into the common area's, post perimeter snipers, at the end of the week take the last guy standing, dis-arm him and lock him back up. Over crowding solved....
  5. Replies
    34
    Views
    9,515

    Just curious, did you find the problem??

    Just curious, did you find the problem??
  6. Replies
    6
    Views
    817

    Done!

    Done!
  7. Replies
    34
    Views
    9,515

    check your draft inducer motor it may be crapping...

    check your draft inducer motor it may be crapping out. If the amps are off the rating replace it. If your tech is a stand up guy he won't charge you for fixing the problem that wasn't a problem. ...
  8. Replies
    6
    Views
    817

    I'll check that out, I'm not sure if our license...

    I'll check that out, I'm not sure if our license included a hard copy of insight. I'll have to ask our Siemens rep. Thanks for the suggestion!
    Stacey
  9. try swapping the rollouts around if the same...

    try swapping the rollouts around if the same rollout trips in the new location replace it. Check the flue, have there been high winds? Does it run out horizontally? Is it sloped properly? Sized...
  10. Replies
    6
    Views
    817

    Siemens TEC setup

    Does anyone know where I can get my hands on a copy of cis powers (I believe its Novell, not sure?) Our laptop crashed and nobody can find a back-up copy. They can't pull it from the hard drive...
  11. Replies
    4
    Views
    608

    Yeah, I agree change it. The black buildup I...

    Yeah, I agree change it. The black buildup I discovered is from an old humidifier that was running on city water discharging in front of the coil. I sprayed a light mist of 50/50 Muriatic acid/H2o...
  12. Replies
    4
    Views
    608

    copper fin chilled water coil

    I have a copper fin coil that has a black build-up (very hard) over quite a big area of the surface its about 30 years old. There doesn't seem to be any corrosion of the surfaces. It's installed in...
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event